Posiflex MR-2000U magnetic card reader
Contents
1. IV CABLE CONNECTION GUIDE Cable connection for KB WEDGE models MR2000 2 3 JIS MR2000 2 2 3 3 JIS PC PC Keyboard KB I P Mini DIN 6 P Male4 Mini DIN 6 P Female Cable connection for RS232 interface models MR2000R 2 3 MR2000R 2 2 3 3 2 5 5 5 DC plug from power adaptor g D sub 9 P Female to COM port Cable connection for USB interface models MR2000U 2 3 JIS PC USB port or USB hub MR2000U 2 2 3 3 JIS V ADJUSTABLE PARAMETERS Some parameters in readout format of the MR 2000 series in PS 2 KB interface and USB interface can be controlled by software downloaded from our web site http www posiflex com However saved parameters must be retrieved after power off and on under proper arrangement for the PS 2 KB interface model while for USB models parameters are automatically saved even after power off and on It is also possible to adjust some parameters with modification in hardware described below if not by software Please note that the individual track enable mentioned applies only when the track is supported in physical reader head For MR2000 2 2 3 3 and MR2000R 2 2 3 3 Changing the status of each jumper in the lower dotted area at right that is the enlarged image of the shaded area on the eee pee control PCB determines 2 g c U3 D ee parameters illustrated in pena U2 ul the table2. POSIFLEX MR 2000 Series MAGNETIC STRIPE READER USER S MANUAL Rev C l FEATURES Double or triple tracks as indicated in MODEL IDENTIFICATION Built in keyboard wedge interface or RS 232 interface or USB interface as indicated in MODEL IDENTIFICATION Built in decoder Dual directional operation Interface cable included Heavy duty die cast case 3 tracks type MSR can read also AAMVA and CA DMV card FCC NOTICE This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions manual may cause interference to radio communications It has been tested and found to comply with limits for a Class A digital device pursuant to subpart J of Part 15 of FCC Rules which are designed to provide reasonable protection against interference when operated in a commercial environment Operation of this equipment in a residential area is likely to cause interference in which case the user at his own expense will be required to take whatever measures to correct the interference WARRANTY LIMITS Warranty will terminate automatically when the equipment is opened by any person other than the authorized technicians The user should consult his her dealer for the problem happened Warranty voids if the user does not follow the instructions in application of this merchandise The manufacturer is by no means responsible for any damage or hazard caused by improper application T
3. below For JPI Ce ES AN ASISE 85284 MR2000R 2 2 3 3 the Vee oh communication protocol LOCATIONS OF SELECTORS REEERE l is default at 9600 bps on PCB inside case T T2 T3 J1 3233 none parity 8 data bit 10 EEE stop bit Table 1 FUNCTION amp LEADING STOP ALT NUM TRACK 1 TRACK 2 TRACK 3 J2 T1 T2 T3 DEFAULT For MR2000U 2 2 3 3 Changing the jumper status on the control PCB inside die cast case determines parameters illustrated in the table below Table 2 FUNCTION JUMPER SHORT DEFAULT LEADING STOP CODE Jl DISABLED ENABLED OPEN ALT NUM JP2 PIN 1 2 DISABLED ENABLED SHORT INIT NUM LOCK JP2 PIN 3 4 DISABLED ENABLED SHORT CLASS JP2 PIN 7 8 HID VENDOR SHORT os JP2 PIN 9 10 WINDOWS LINUX DOS SHORT TRACK 1 Tl ENABLED DISABLED SHORT TRACK 2 T2 ENABLED DISABLED SHORT TRACK 3 T3 ENABLED DISABLED SHORT Note 1 To use the USB interface MSR in operating system without USB support please set USB keyboard enabled in BIOS CMOS setup Note 2 Since this USB interface MSR works as a USB keyboard which is a normal HID Human Interface Devices in USB classification no special driver shall be required However it should be set as vendor class for Linux system and special driver is required Page 2 2
4. f this documentation TRADE MARKS AND SERVICE MARKS P N 19030900030 POSIFLEX GQ C POSIFLEX is a registered trademark of Posiflex Technologies Inc an ISO 9001 and ISO 14001 certified manufacturer Other brand and product names are trademarks and registered trademarks and service marks of their respective owners ll MODEL IDENTIFICATIONS Interface Applicable tracks ISO track 1 amp 2 MR2000 2 MR2000R 2 MR2000U 2 ISO track 2 amp 3 MR2000 2 3 MR2000R 2 3 MR2000U 2 3 ISO track 1 amp 2 MR2000 3 MR2000R 3 MR2000U 3 JIS track I amp II MR2000 JIS N A N A lil SPECIFICATIONS Reader specification Card feed method Manal SC Read write function Errorrate Lessthan 0 5 Lessthan0 1 o Card data format Rear side Applicable to MRA000 2921353 MR2000 JIS MR2000R 2 2 3 3 models MR2000U 2 2 3 3 MR2000U JIS PS 2 KB wedge RS232 Recording method Recording density 210 BPI 75 BPI 210 BPI 75 BPI 210 BPI Recording capacity characters bits 79 7 40 5 107 5 40 5 Note 1 AAMVA and CA DMV standards are supported in 3 track ISO models Note 2 For 2 track ISO readers like MR2000 2 or MR2000U 2 3 info about the missing track in above table is not applicable Page 1 2 Dimensions 14 5 cm L X 4 6 cm W X 3 4 cm H Weight 490 gm LED dual color green for good read or ready to read red for invalid read Rated voltage 5 VDC Rated current 100 mA max
5. he hardware utility program including instructions for its use is provided AS IS without warranty of any kind Posiflex Technologies Inc further disclaims all implied warranties including without limitation any implied warranties of merchantability or of fitness for a particular purpose The entire risk arising out of the use or performance of the software and documentation remains with you ABOUT THIS MANUAL This manual is written in an attempt with full strength to assist the user to utilize the stand alone magnetic stripe reader MR2000 series of Posiflex POS products This series of products provide excellent flexibility and reliability in application This manual covers both operational and technical aspects of these units The manufacturer of the MR2000 series heartily apologizes to the user for reserving the right to change or to modify this manual without notice due to the rapid and constant progress and improvement on science and technology The user may always obtain the most up to date information through any of our web sites http www posiflex com or http www posiflex com tw or http www posiflexusa com Copyright Posiflex Technologies Inc 2009 All rights are strictly reserved No part of this documentation may be reproduced stored in a retrieval system or transmitted in any form or by any means electronic mechanical photocopying or otherwise without the prior written consent of Posiflex Technologies Inc the publisher o
Download Pdf Manuals
Related Search
Posiflex MR 2000U magnetic card reader usb magnetic card reader portable magnetic card reader credit card magnetic reader