“QS SERIES” USER MANUAL Models QS-1 and QS-4
Contents
1. accessories will remain on for the duration of the programmed runtime Remove key exit vehicle and lock doors All safety devices will remain active If you return to your vehicle before runtime has elapsed just turn the key to the ON position and depress brake pedal WHAT STOPS THE ENGINE For your safety engine will not start or will stop if Ignition switch is in the ON position prevents starting Remote control sends a stop message Hood is open Brakes are applied Engine is over revving programmable 7 Main switch is OFF MAIN SWITCH The main switch is usually mounted under the dashboard It is a toggle ON OFF switch that is used to cancel start functions It does not disable other commands that remain active STOP Qrrrr wee QS 4 When engine is kept running by Remote Starter you can stop it by pressing the rrr and rs fe buttons simultaneously lights 1 Engine and parking lights will shut down LOW TEMPERATURE MODE QS 4 ONLY In Low Temperature Sentinel mode system starts your engine automatically when temperature falls below Threshold temperature is set for v a preset level programmable during installation see 5 C 23 F hd 20 C 7 F Lo table Factory default shaded Team 30 C 22 F Engine will run for programmed runtime after which system will wait 2 2 hours and then start engine again if temperature is still below preset level Factory default Eng2. carefully read the following safety precautions Immediately report any malfunction to the dealer that performed installation Under no circumstance can this product or its use be modified Always turn off main switch when vehicle is parked in an enclosed unventilated area or is in for servicing Always turn off main switch when not using your Remote Starter for extended periods of time Keep remote controls away from children Have your engine tuned regularly to ensure optimum performance of your Remote Starter Make sure your windshield wipers are turned off before leaving vehicle Regularly check safety features that stop engine see SAFETY CHECKS on page 8 Make sure you comply with all local regulations that may prohibit leaving your engine running when vehicle is unattended in a public place Always advise service personnel that your vehicle is equipped with a Remote Starter We strongly recommend that you have your Remote Starter checked annually Contact the dealer in your area BEFORE USING YOUR REMOTE STARTER Before leaving your vehicle set the various controls in order to use your Remote Starter Set heating air conditioning controls to desired position When the remote starter starts your engine it will also turn on your climate control system Turn your windshield wipers to the OFF position Make sure gearshift is in P THE REMOTE CONTROL Your remote control works off a small long life 12 v
3. ENTERING YOUR VEHICLE Do not apply brakes this will stop engine immediately Insert ignition key and turn it to ON position AN DO NOT TURN THE IGNITION KEY TO THE START POSITION 7 Drive as usual ENGINE RUNTIME Your engine will stop automatically after a preset time of 2 min Bi 4 min Bi 8 min or 18 min depending on settings during installation Runtime doubles for diesel engine vehicles Parking lights will remain on for the whole running time period TRIGGER INPUT Your remote starter is equipped with a negative trigger pulse input This input can be connected to another remote control device or to a timer control output optional P n 310 903 502 If this input is connected consult this device s manual or ask your technician which command controls the start stop function The Start Stop commands received on this input are ignored while the engine is running on a remote start All Start Stop functions controlled by this input behave in the same way as functions controlled by remote CONTINUOUS MODE Ovre The Continuous Mode function allows to remove the key from the ignition while leaving the engine running This convenient feature allows you to leave the vehicle for short periods of time while the climate controls remain on To access the Continuous Mode carry out the Start command while the engine is idling See START command on page 4 Parking lights engine and preset
4. HEN BOOSTING YOUR BATTERY COULD PERMANENTLY DAMAGE YOUR REMOTE STARTER
5. REMOTE CONTROL ENGINE STARTER QS SERIES USER MANUAL Models QS 1 and QS 4 For all automatic transmission gas and diesel powered a ai vehicles ah QS 1 QS 4 FRAN AIS AU VERSO CONSULT THE SAFETY PRECAUTION SECTION BEFORE USING THIS PRODUCT NEVER INSTALL THIS PRODUCT ON A MANUAL TRANSMISSION VEHICLE SOME FEATURES MAY REQUIRE ADDITIONAL MATERIAL NOT INCLUDED NOS DE BREVETS CAN 1 130 426 U 4 345 554 5 614 883 5 617 819 5 673 017 ET AUTRES BREVETS EN INSTANCE PRINTED IN CANADA 08 03 193 127 311 00 GOVERNMENT REGULATIONS This device complies with the requirements of Industry Canada IC Management of Radio frequencies as specified in document CNR 210 Its use is authorized only on a no interference no protection basis in other words this device must not be used if it is determined that it causes harmful interference to services authorized by IC In addition the user of this device must accept any radio interference that may be received even if this interference could affect the operation of the device This device complies with Part 15 of the FCC rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC Rules These limits a
6. en received The Unlock function can be programmed and connected in such a way that the first Unlock command only unlocks the driver s door while a following Unlock command unlocks the other door s DOME LIGHT SUPERVISION Dome light will turn on for 30 seconds every time Unlock command is sent This 30 second period is cancelled when Lock or Trunk release command is sent brakes are applied or key is inserted in ignition and turned to ON position TRUNK RELEASE gt Press the coe button lights 3 Trunk is released and parking lights flash three times to confirm command has been received The trunk cannot be released if ignition key is in ON position In this case parking lights flash once to confirm that command has been received but trunk could not be released If you are not sure you have received confirmation repeat command System will repeat confirmation as often as you wish If your vehicle is equipped with an OEM security system the command will neutralize it So remember to rearm it after trunk is closed Lock command AUTOMATIC LOCK UNLOCK Programmable as Active or Inactive _ during installation This function locks the doors when ignition key is in ON position engine is running and brakes are applied Doors are unlocked when key is turned from ON to OFF or when Continuous Mode is activated If Unlock function is set to unlock only driver s door on the fir
7. gine should stop as soon as hood is opened If engine does not stop immediately turn main switch to OFF position and leave it off until situation is rectified Contact your service center GEARSHIFT CHECK lf key must be in ignition for gearshift to be moved out of P your vehicle is safe as long as keys are kept away from children lf on the other hand gearshift can be put in gear without key being in ignition proceed with this simple check Put gearshift in gear D e Remain in the vehicle and be ready to apply brakes Start vehicle with remote starter e Repeat these steps with gearshift in every position other than P and N If starter reacts within 90 seconds which would not be secure turn main switch to OFF position and leave it off until situation is rectified Contact your service center With gearshift in P start vehicle with remote starter e Remain in vehicle and be ready to apply brakes Without applying brakes move gearshift out of P If without applying brakes engine does not stop immediately which would not be secure turn main switch to OFF position and leave it off until situation is rectified Contact your service center REPLACING OR BOOSTING VEHICLE BATTERY If you have to replace or boost your battery for any reason turn main switch to OFF position and leave it OFF until battery is replaced or fully charged REVERSING POLARITY W
8. ine runtime Low temp mode is set to v C 2mins emnes shaded C amines 18 minutes To activate deactivate Low Temperature mode press and A buttons simultaneously WHEN MODE IS ACTIVATED Parking lights will flash 4 times then if temperature is below preset level engine will start If temperature is above preset level system waits until it goes below preset level before starting If system cannot execute command for example hood is open confirmation will be different lights 3 WHEN MODE IS DEACTIVATED Parking lights will flash twice to confirm that mode is deactivated Applying brakes also deactivates Low Temperature mode LOCK UNLOCK COMMANDS as 4 ONLY If your vehicle is equipped with electric door locks several functions can be operated by remote control These features are optional and may require purchasing additional equipment Consult your dealer for advice Following systems can be controlled Door locks e Trunk or hatchback release Interior lights LOCK amp Press the A button doors are locked and parking light flashes once to confirm command has been received Parking light confirmation is sent as many times as command is repeated so you are sure that system has received the command Horn sounds once if option Confirmation on 2nd lock was set during installation UNLOCK Ef Press the rs fe button doors are unlocked and parking light flashes twice to confirm command has be
9. me for you We take this opportunity to remind you to properly defrost your windows and remove all the snow on your vehicle before driving on public roads Rolling igloos are extremely dangerous We wish you an excellent journey with your remote engine starter Table of contents SAFETY PRECAUTIONS 2 BEFORE USING YOUR REMOTE STARTER 2 THE REMOTE CONTROL 2 USING YOUR REMOTE CONTROL 2 20 2 22 nenennnnnennnnnnnnnennnnnnnnnnnnnnnennnanennnnnnnnanennnanennnnnnnnanennnanenns 3 TABLE OF COMMANDS 3 CONFIRMATION 22 20000 nscnnneneennnnanneneennnnanneneeenennnennennesnnenneennenneneeennennenneennasmennennnnsamemneennnanmmmmmnnn 3 START COMMANDS 20 200 0000eencsnneneeencaneennennenanneneenneannenneennansenneennnannenneennnanmenneeneaameaneennnasnammmnnn 4 LOCK UNLOCK COMMANDS QS 4 ONLY 22 200 esseessecnennnncseannsnnnsennannssneennansenesannnnnesnnaenennaaeaeeennnens 6 ANTITHEFT CIRCUIT DISABLER QS 4 ONLY 02 0 00sesencsensnnsenenesnnncenesnnnneseeenannenesannaeneennnennneneenees 7 SAFETY CHECKS 8 HOOD SWITCH 2 2020 neannnnnennnnannnnnnnnnnnnnnnneennnannennenneannennnnnnanmeneennnanmennennnnnmenennneanmenenenasnmemenmmmnn 8 GEARSHIFT CHECK 2 2 22 n nennnnennnnnnnnnnnnnnnnennnnnnnnnnnnnnnnennnnnennnnnnennnnnnnanennnnnnnnanennnanennnnnnnnnnenenannnns 8 REPLACING OR BOOSTING VEHICLE BATTERY 8 SAFETY PRECAUTIONS Before using this product
10. n signals are written in an abbreviated form for example Lights 2 means that the parking lights will flash twice Confirmations are explained in more detail under each command QS 1 QS 4 START COMMANDS START STOP TOGGLE QS 1 The Start Stop command is in fact the reason for being of your remote starter It allows you to start or stop your vehicle without stepping outdoors Press and hold the button down for at least two seconds UPON STARTING Parking lights will flash once to confirm the reception of the command then will stay ON for as long as the engine is running under remote control UPON STOPPING The engine and parking lights will turn off The command is only applicable when engine is running under remote control START Ove QS 4 To start the engine press button lights 1 The system automatically adjusts ignition duration for your type of vehicle parking lights flash once then stay on all the time engine is running If more than one command is emitted each successive start command resets runtime to the beginning parking lights flash once to confirm command has been received and horn sounds once if wired to system IF ENGINE FAILS TO START If your system cannot start the engine at first attempt it will wait for a few seconds and then try again it could try again twice depending on reason for failure to start After three attempts it will shut down automatically and wait for a new command WHEN
11. olt alkaline battery f GP 23A Ji The range of your remote control can be affected by a weak battery interference from nearby metal structures hydro poles or crowded al Lab parking lots With its electronic CODE LEARNING feature a maximum of four remote controls can be programmed for your vehicle We strongly recommend that you keep a replacement battery in your I glove compartment See your dealer for replacement batteries or for additional remote controls USING YOUR REMOTE CONTROL To ensure that commands are transmitted properly press desired button for 2 seconds The indicator light will flash while transmitting the command 4 blinks The QS 4 remote shows pictograms to help you remember the commands Remote included in kit may differ from the ones illustrated TABLE OF COMMANDS COMMANDS REMOTES CONFIRMATION 1 BUTTONS 4BUTTONS LIGHTS HORN STAR STOP TOGGLE N a se ee E ro a EE 0 THIS CONFIRMATION IS SENT ONLY WHEN ENGINE IS ALREADY RUNNING UNDER REMOTE CONTROL 4 ACTIVATION 2 DEACTIVATION 3 SYSTEM NOT READY PROGRAMMABLE DURING INSTALLATION 2ND LOCK CONFIRMATION In all cases your Remote Starter will confirm that a command has been received properly by flashing parking lights See TABLE OF COMMANDS on page 3 With a QS 4 the horn provides certain confirmations when connected to system requires optional wiring and material In this manual confirmatio
12. re designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television which can be determined by turning the equipment OFF and ON the user is encouraged to try to correct the interference by one or more of the following measures 7 Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver 7 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Warning Changes or modifications not expressly approved by lt manufacturer gt could void the user s authority to operate the equipment 1164 Route 220 516A Elm Street St Elie d Orford Qu bec Manchester NH 03101 Canada JOB 2S0 USA THANK YOU FOR CHOOSING A PRIVATE LABEL QS SERIES REMOTE CAR STARTER Like you we are concerned with the environment This is why we are suggesting you to use the two minute runtime when you remote start your vehicle to warm up engine fluids You can ask your authorized dealer to set the runti
13. st command the Automatic Unlock function will unlock driver s door only If dome light is connected to system it is activated when an automatic unlock Occurs ANTITHEFT CIRCUIT DISABLER as 4 ony Programmable as Active _ or Inactive __ during installation Your Remote Starter is equipped with an Antitheft system This system consists of an output that controls a relay that cuts all circuits required to operate your vehicle optional connection Two types of Antitheft can be program and wire up PASSIF ARMING TYPE ANTITHEFT This type of antitheft system arms automatically when ignition key is turned from ON to OFF and remains OFF for one minute It can also be armed manually by sending a Lock command unless ignition key is in ON position Disarming Antitheft system is disarmed for one minute when you send Unlock command If the ignition key is not turned to ON position within one minute system automatically rearms thus preventing any intruder from starting your vehicle even with the key in the ignition switch ACTIVE TYPE ANTITHEFT amp This type of antitheft system arms by sending the Lock command unless ignition key is in ON position and disarms by sending the Unlock command SAFETY CHECKS In order to maintain a high safety standard proceed with the following checks every month HOOD SWITCH Remote start your vehicle e Open hood En
Download Pdf Manuals
Related Search