DICE Auxiliary interface for iPod
Contents
1. auxiliary audio power cable Gain adjustment The potentiometers located on the interface unit are used to adjust the gain settings for the iPod and AUX jack to properly match the radio s input level We recommend setting the AUX module s output level to match the factory CD or AM FM station s sound level NOTE Use a small phillips head screw driver ora plastic pot adjuster tool to adjust the Interface unit re a B potentiometers TR Increase decrease LISE E iPod gain mini jack gain setting setting 10 Installation instructions Installation should only be performed by a qualified professional Beware of sharp edges to avoid injury and exercise caution when removing trims as they may break The interface unit should be placed at an accessible location such as in the glove box the center console or underthe front seat 1 Pull vehicle into service bay 2 Make sure that the radio code is available before disconnecting battery Disconnect both battery terminals These cables must be disconnected during installation to ensure proper initialization of the module when it is connected 3 Pull out the radio by removing surrounding trims and screws to access the radio s auxiliary input connectors Most trims can be removed by carefully pulling on the piece or using trim removal tools Trim is usually held in place by snap in clips Consult your dealership if additional in2. Keep away from children Interface components may contain small parts can be broken or disassembled and components may become loose from vibration and heat Small components and packaging materials may be a chocking hazard when handled by children Do not open disassemble or alter the interface in any way SE Congratulations on your purchase Thank you for purchasing the DICE integration kit for iPod Please review our user manual and installation guide before operating the unit This interface was designed and manufactured to seamlessly integrate with your vehicle s factory entertainment system Product registration In order to validate your warranty period and to receive telephone or online support you MUST register your DICE product To register your DICE product please complete the following steps 1 Visit http www diceelectronics com register 2 Complete the product registration form 3 Submit the form 4 Save the registration support warranty sheet in a safe place for future reference If you are unable to complete the registration via internet please call DICE Electronics at 1 888 342 3999 6 Supported iPod models and firmware version requirements FW 3 1 1 iPod 4th generation 20GB 40GB FW 1 2 1 iPod 5th generation video 30GB 60GB 80GB FW 1 3 1 Y O iPod nano 1st generation 1GB 2GB 4GB For the latest firmware versions and models not listed please contact your authorized dealer
3. PDICE o 00 ELECTRONICS DICE Auxiliary interface for iPod Installation Guide User Manual iPod SIN CRUINNE ran DD ELECTRONICS Copyrights and Trademarks Copyright 2008 DICE Electronics LLC The DICE Electronics logo is a trademark of DICE Electronics LLC iPod is a trademark of Apple Inc All rights reserved Printed in the U S A Table of contents Copyrights and trademarks Table of contents Warning and safety Product registration Supported iPod models Charging Integration kit contents Gain adjustment Installation Using the AUX integration Troubleshooting Installation notes Disclaimer and Warranty 0 YOU 11 14 16 18 Warning and safety Please read these instructions carefully before proceeding Failure to follow instructions may result in improper operation or injury Neither DICE Electronics LLC nor Apple Inc its regional offices distributors or resellers take any responsibility for any damage or injury as a result of using the integration kit Do notinsert anything into the casing Do notcutortryto alter cables in any way and always use the correct connections Only operate unit when stationary or ask passengers to operate it for you Donotallowthe Apple iPod to distract you from driving Exercise good judgement and keep your eyes on the road at all times Donotexpose unit to extreme temperatures humidity or shock Keep the unit and iPod away from fluids
4. d using the potentiometers See pg 10 No audio from auxiliary device 1 8 mini jack Refer to the documentation of the device for the correct audio ouput settings Verify proper connection to device interface 15 Installation notes Installed by Illustration Othernotes AN Install date ii 16 PDICE ce ELECTRONICS Notes Disclaimer and warranty Important disclaimer please read Unauthorized reproduction or reverse engineering is strictly prohibited Intellectual property included is distributed under specific license agreement with respective owners and is licensed only not sold No warranty explicit or implied is stated Neither DICE Electronics LLC nor any of its agents distributors dealers or vendors shall be liable for damages IN NO EVENT SHALL DICE ELECTRONICS LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT FROM DIRECT INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT ITS ACCOMPANYING SOFTWARE OR ITS DOCUMENTATION Warranty and Support Products carry a 90 day limited warranty that protects you from defects in material and workmanship of products sold by DICE Electronics or its authorized agents distributors and dealers The warranty period begins the day a product is purchased by the end user Products found to be defective during the warranty period will either be repaired or replac
5. ed by DICE Electronics at no charge unless warranty is void Unauthorized attempt of repair or alteration of the product in any way immediately voids this warranty Warranty does not extend to cosmetics or finish A DICE product specialist must determine that defect is present in the product and issue an RMA Be sure that all wiring is connected as described in the user manual and all related equipment is functioning properly DICE Electronics disclaims any liability for other incurred damages resulting from product defects Any expenses in the removal and reinstallation of products are not covered by this warranty If experience any problems or need help please contact your local dealer or call 888 342 3999 or visit our support site at http www diceelectronics com support 18 DICE ELECTRONICS AUX iPod www diceelectronics com AUX iPod 2008 03 SIN CRUINNE ma
6. formation is needed on removing the radio 11 4 You can access the factory AUX port located on the back of the radio Connect the red and white colored AUX audio connectors into the red and white colored receptacle on the radio If the factory AUX port already has something connected it must be disconnected Connect the 12 volt ground and remote wire leads to their proper sources y U O UU U l H UUUU g U l Red wire REM connect to switched power CD AL TIQITOTTT El aid Abel pi ground O Maen ellow wire 12V connect to 12V 0 99 na E AUX audio RCA connectors Red Right channel White Left channel Note some radios will not have RCA inputs and will require custom installation connect to interface unit 12 5 Connect the AUX audio cable and the iPod docking cable to the interface unit If an additional audio device will also be used mp3 DVD player etc connect its audio cable to the 1 8 mini jack Apply cable ties to secure the cables mi receptacle receptacle a pages 1 8 iPod power mini jack dock input adapter i t MPG iPod docking cable power antenna cable 6 Verify that all connections have been properly made 7 Reconnec
7. or DICE Electronics LLC FW 1 2 1 iPod 4th generation color display 20GB 30GB 40GB 60GB FW 1 4 1 O iPod mini 4GB 6GB FW 1 1 3 A O iPod nano 2nd generation aluminum 2GB 4GB 8GB pr o O 3 iPod classic 80GB 160GB AR o 3 iPod nano 3th generation video AGB 8GB ole FW 1 1 1 iPod touch 8GB 16GB 32GB Charging The interface automatically charges the battery of the iPod when connected and the key is in the ACC ON position Most vehicles turn off ACC power when the key is in the OFF position and the iPod will stop playing and charging However in some vehicles the ACC power is always on and the iPod should be disconnected to prevent draining the vehicles battery Charging icon will appear on the upper right corner of the iPod screen to indicate charging Battery icon will appear on the upper right corner of the iPod screen to indicate charging has stopped Some vehicles will constantly supply ACC power even when ignition is OFF The iPod will continue to charge until disconnected To prevent battery from draining or possibly being damaged iPod MUST be disconnected in these vehicles BDICE Integration kit contents 1 interface unit 1 auxiliary audio power cable 1 iPod dockcable 1 User manual Paice El user manual iPod dock cable
8. tthe car s battery Test the unit before seating the cables and reinstalling the panels trim 13 Using the AUX integration Connect the iPod to the dock cable and select the auxiliary source on the radio The charging indicator should appear on the iPod and a selected song will start to play If an additional audio device is connected through the 1 8 mini jack it will become active when the iPod is disconnected AUX source selector AM cD 2 E a VOL foe ser pm E cn Ser sore sai AUX O SKIP ROM ida CNET 3 7 oF FI NY NOTE Some vehicles require the ignition to be in the on position to provide ACC power i In this case the interface unit will not function until ignition is turned on Troubleshooting Problem Solution Cannot select the interface using the radio Check all connections With the ignition OFF disconnect vehicle harness from module for a few seconds and reconnect Turn ignition to ACC ON Verify that the correct button is used to access the AUX input No audio from iPod source Reset the iPod Verify proper connection to iPod interface iPod does not charge Check all connections Reset iPod and make sure iPod charges while connected to computer or wall charger Music is distorted or sound level is too low The output gain for iPod and AUX should be adjuste
Download Pdf Manuals
Related Search