MNBCM Datasheet
Contents
1. MidNite Solar Battery Monitor MNBCM Rev D 1 Installation Remove Cover of Battery Monitor using the slots in side of plastic case Attach Battery Monitor base using 4 screw holes Reattach Cover to base Battery Cable Hookup Attach RED wire to battery bank plus terminal Attach BLACK wire to battery bank minus terminal Battery Battery Battery Battery Full Rate Gel Note The Battery Monitor enters the self test mode when power if first applied All LEDs are tested one by one Eattery Eank Battery chemistry jumper ON GEL 13 65V to turn on green light OFF AGM amp FLOODED 14 25V to turn on green light voltage must be attained for 2 hours to turn green light on MidNite Solar Battery Monitor MNBCM Rev D Status Display One of 10 LEDs light to show present battery capacity Capacity is based on battery voltage Extended status is displayed using one of the three LEDs located under the tinted window Use the decal on the cover as a key to explain their meaning Mio ire Di FULL CHARGE RECENTI Gs URRY Hi OTRECEIVED ai ta GE FO YA i wank ao po HAS NOT kipra VED ts AFULL CHARGE FOR 2 WEEKS 7 es On the above display the green LED indicates the battery has 90 of full charge The red LED behind the tinted cover indicates the battery has not been fully charged for at least 2 weeks Nominal Input Voltage Range 12V 24V 36V 48V Absolute Maximum Input 70V Reverse P2. olarity Protection max 100V Average Current 15 mA at 12V Charge Status LEDs 10 Extended Charge Status LEDs 3 Physical Size 4 75 x 3 76 x 0 85 Humidity 5 95 Non Condensing Indoor Installation Only in Dry Area Protected from direct sun Battery Monitor must be installed within 30 ft of battery bank MidNite Solar Inc midnitesolar com 17722 67 Ave NE Ph 425 374 9060 Arlington WA 98223 Fax 360 691 6882
Download Pdf Manuals
Related Search