User Manual - Audio Authority
Contents
1. e Test using known good HDMI cables or try shorter cables e Make certain the 1322 is connected to a live AC outlet and check the indicator lights to verify the unit is powered on If the indicators are off press the Power button Verify that the 1322 is set to a resolution supported by the display Contact Audio Authority Technical Service at support audioauthority com or call 800 322 8346 or 859 233 4599 6 0 SPECIFICATIONS Storage Humidity 10 to 90 non condensing Dimensions H W D inches mm 7 0 LIMITED WARRANTY If any consumer product from Audio Authority fails due to defects in materials or workmanship within one year from the date of the original sale to the end user Audio Authority guarantees that we will replace the defective product at no cost Freight charges for the replacement unit will be paid by Audio Authority ground service only A copy of the invoice showing the item number and date of purchase proof of purchase must be submitted with the defective unit to constitute a valid in warranty claim Units that fail after the warranty period has expired may be returned to the factory for repair at a nominal charge if not damaged beyond the point of repair All freight charges for out of warranty returns for repair are the responsibility of the customer Units returned for repair must have a Return Authorization Number assigned by the factory This is a limited warranty and is not applicable for products2. REGULATORY COMPLIANCE The 1322 complies with HDMI and HDCP rules and regulations The power supply included has been tested for compliance with UL CUL CE PSE and GS rules and guidelines This product and its power supply are RoHS compliant 9 0 CONTACT INFORMATION If you have questions or require assistance with this product in areas not covered by this manual please contact Audio Authority using the information below Audio Authority Technical Service 800 322 8346 M F 8 30 AM to 5 00 PM EST International 859 233 4599 Fax 859 233 4510 Send email to support audioauthority com Audio Authority Corporation 2048 Mercer Road Lexington Kentucky 40511 1071 USA 11 Audio CBAuthority 2048 Mercer Road Lexington Kentucky 40511 1071 Phone 859 233 4599 Fax 859 233 4510 Customer Toll Free USA amp Canada 800 322 8346 www audioauthority com E 0967 7 10
3. is installed correctly All rights are reserved No parts of this manual may be reproduced or transmitted by any form or means electronic or mechanical including photocopying recording or by any information storage or retrieval system without the written consent of the publisher Audio Authority reserves the right to revise any of its hardware and software following its policy to modify and or improve its products where necessary or desirable Audio Authority and the Double A Symbol are registered trademarks of Audio Authority Corp Copyright July 2010 HDMI the HDMI Logo and High Definition Multimedia Interface are registered trademarks of HDMI Licensing LLC in the United States and other countries All other third party trademarks and copyrights are recognized 1 0 INTRODUCTION Thank you for purchasing this HDMI EDID Controller from Audio Authority This device is designed to ensure reliable responsive EDID and CEC operation between a source and display Without the 1322 the source and display s must synchronize before any video image appears often resulting in inconvenient delays and unpredictable settings The 1322 ensures that the desired video and audio settings are preserved and in complex systems it can significantly reduce synchronization time Audio Authority audio video switchers converters and distribution amps can be purchased at www audioauthority com or through authorized dealers 1 1 SYSTEM FEATURES Pe
4. O COLOR RESOLUTION POWER OQOOOO CEC EDID O 66066 900 m AO BITSTREAM 12BIT UXGA 1080p SYSTEM RESET I I LPCM7 1 10BIT SXGA 1080i CEC OFF SYSTEM RESET ON SET TV LPCM2 0 8BIT XGA 720p CECON OFF 000 4 Resolution Select a resolution UXGA SXGA XGA 1080p 1080i or 720p Use a PC monitor or a monitor that supports PC mode when selecting PC resolution UXGA SXGA or XGA 5 Deep Color Choose 12 10 or 8 bit deep color 6 Audio Selectable audio Bitstream from Dolby TrueHD or DTS HD to LPCM 7 10r 2 0 Note The above key selections only function when EDID is switched to SET 7 Indicator lights Visual feedback for setup confirmation BITSTREAM 12BIT UXGA 1080p SYSTEM RESET LPCM7 1 10BIT SXGA 1080i CEC OFF LPCM2 0 8BIT XGA 720p CEC ON 8 Enter key Press to activate and save new settings 4 0 INSTALLATION e HDMI INPUT Connect the source device directly to the 1322 with a short HDMI cable Do not install the 1322 after any other device in the signal path e HDMI OUTPUT Connect the 1322 to HDMI display s or other in line device with an HDMI cable or via an extender Use good strain relief methods on HDMI cables to prevent loose connections e Power Connect the DC power adapter cord and plug into an AC power outlet Power the system for setup and final testing POWER 5V DC 2A HDMI INPUT HDMI OUTPUT
5. OSO K 4 1 SETUP In many applications the 1322 is particularly useful to insure that the correct resolution and audio settings are maintained when switching between video displays or in multiple display video distribution systems Operate the controls moving from the right to the left When setting Resolution Color and Audio press the button once or several times until the light indicates the desired setting Press Enter to apply and save all settings The following steps illustrate the setup procedure Connect and power up the 1322 as directed above Switch settings EDID SET and CEC OFF Resolution 1080p Deep Color 8 BIT Audio BITSTREAM Press Enter and observe desired results oar Go h 5 0 TROUBLESHOOTING e Poor image quality Some sources such as cable and satellite receivers compress output resulting in poor image quality Connect the source directly to a display via a short HDMI cable to compare e Intermittent signal dropout Cable is longer than rated distance for the bandwidth of the source signal Reduce bandwidth or cable length e No surround sound multi channel audio adjust the source to output the desired digital audio format and make certain the destination device is capable of receiving it e No picture perform the verifications below e Check the HDMI cables at input and output connections to see if any of the connectors have become loose Use good strain relief methods
6. User Manual Hum EDID Controller AudioPauthority 800 322 8346 859 233 4599 www audioauthority com EDID CONTROLLER Model 1322 HIMI Model 1322 AudioPauthority User Manual Model 1322 EDID Controller TABLE OF CONTENTS 1 0 INTRODUCTION 2 0 CHECKING PACKAGE CONTENTS 3 0 CONTROLS AND FUNCTIONS 4 0 INSTALLATION 5 0 TROUBLESHOOTING 6 0 SPECIFICATIONS 7 0 LIMITED WARRANTY 8 0 REGULATORY COMPLIANCE 9 0 CONTACT INFORMATION Audio authority 2048 Mercer Road Lexington Kentucky 40511 1071 Phone 859 233 4599 Fax 859 233 4510 Customer Toll Free USA amp Canada 800 322 8346 www audioauthority com WARNINGS e Read these instructions before installing or using this product To reduce the risk of fire or electric shock do not expose this unit to rain or mois ture This product must be installed by qualified personnel Do not open the cover there are no user serviceable parts inside Do not expose this unit to excessive heat Install only in dry indoor locations Clean the unit only with a dry or slightly dampened soft cloth LIABILITY STATEMENT Every effort has been made to ensure that this product is free of defects Audio Authority cannot be held liable for the use of this product or any direct or indirect consequential damages arising from its use It is the responsibility of the user of the product to check that it is suitable for his her requirements and that it
7. rmanent EDID settings streamline the HDMI switching process Insures desired settings remain intact when switching sources and displays Prevents drop outs due to EDID conflicts e Built in CEC support with compliant CEC PHY e Supports 480i p 576i p 720p 1080i p HDTV resolutions e Supports VGA SVGA XGA SXGA to UXGA PC resolutions e Supports Deep Color e Supports Dolby Digital TrueHD and DTS HD Master Audio e Supports up to 36 bit digital audio e HDMI input and output cable length may be up to 32 feet 10m e HDMI version 1 3 DVI version 1 0 and HDCP compliant 2 0 CHECKING PACKAGE CONTENTS Before connecting the system please make certain the following items are in the shipping carton e 1322 EDID Controller Note Please retain the original packing material and invoice in case you need to return the unit If you find any items are missing contact Audio Authority User manual immediately Have the model number and invoice available for reference when you call DV DC power adapter 3 0 CONTROLS AND FUNCTIONS 1 Power Turns the 1322 on or off off standby mode 2 EDID To use 1322 settings select SET 3 CEC Select on off or system reset mode with the CEC switch On allows the source access to the display s CEC Off disables CEC functions in the system If CEC is switched to SYS RST this means the system will reset every 8 10 minutes 0 o 9 ENTER O 000 O AUDI
8. which in our opinion have been damaged altered abused misused or improperly installed Audio Authority makes no other warranties either expressed or implied including limitation warranties as to merchantability or fitness for a particular purpose Additionally there are no allowances or credits available for service work or installation performed in the field by the end user 7 1 WARRANTY SERVICE PROCEDURES If you suspect a product defect contact Audio Authority s Technical Service Department at 800 322 8346 or 859 233 4599 for assistance in verifying the problem If a defect or potential defect is suspected a replacement unit will be shipped immediately on a defect exchange basis and a Return Authorization Number will be issued for the return of the defective product Replacement units are sent out at the Manufacturer s Suggested Retail Price which is debited to the Customer s Credit Card at the time of shipment Once we receive the defective unit back at the factory it will be evaluated under the conditions of this warranty and if found to be in warranty a full credit will be issued to the Customer s Credit Card Return freight charges for the defective unit are the customer s responsibility Please contact our Technical Service Department for complete details concerning all in and out of warranty service matters We appreciate your confidence in our products and services and will always strive to meet or exceed your needs 10 8 0
Download Pdf Manuals
Related Search