T-300 Instructions
Contents
1. C dn is shown as in Figure 9 2 Press lt SET POSSESSION gt to enter The previous countdown time digits will blink 3 Press lt TEAM 1 gt to adjust the minutes and hours Press lt TEAM 2 gt to adjust the seconds 4 Press lt SET POSSESSION gt to confirm the timer setting the count down time will be stored in the memory The period and possession arrow will start blinking 5 Press lt TEAM2 gt to adjust the period number as before 6 Press lt TEAM I gt to enable or disable the possession arrow alternately 7 Press lt SET POSSESSION gt after setting the period and possession arrow 8 Press lt START STOP gt to start and stop the count down timer 9 Press lt SET POSSESSION gt to alter the arrow direction during the count down process 10 The scoreboard will give a long beep when the time is up 11 When the count down timer stops press and hold lt SET POSSESSIONS gt for 3 seconds to reset the timer to the original memorized record P 2 12 When the count down timer stops press lt MODE gt to adjust the timer that will blink momentarily Press lt TEAM 1 gt and lt TEAM 2 gt to adjust the count down timer as before 13 When the time is up press and hold lt SET POSSESSIONS gt for 3 seconds to reset the timer back to the memorized time 14 Under any static state press and hold lt MODE gt for 3 seconds to enter the INTERVAL COUNT DOWN MODE INTERVAL COUNT DOWN MODE 1 In the T2. IME DISPLAY MODE press and hold lt MODE gt 3 seconds 4 times to enter the INTERVAL COUNT DOWN MODE Int Cd is shown as in Figure 10 2 Press lt SET POSSESSIONS gt to enter The Interval Count Down timer A will blink as in Figure 11 The first digit on the top row shows the timer indicator 3 Press lt TEAM 1 gt and lt TEAM 2 gt to adjust the timer A 4 Press lt SET POSSESSIONS gt after setting timer A the display will turn to timer B automatically The timer indicator will become b as in Figure 12 5 Press lt TEAM 1 gt and lt TEAM 2 gt to adjust the timer B 6 Press lt SET POSSESSIONS gt to confirm setting 7 Press lt START STOP gt to start and stop timer A When timer A is up 4 seconds long beep can be heard And the timer A will directly turn to timer B When Timer B ends 4 seconds long beep can also be heard and the timer will switch to timer A again Timer A Timer B refer to one complete cycle This process runs continuously until stop is pressed The cycle of the Interval Count Down timer repeats to operate with no cycle limit While the timer is running the first digit indicates the cycle number which goes from 1 gt 2 gt 3 gt 0 gt 1 gt 2 gt 3 as in Figure 13 To distinguish between timer A and B timer B will always keep on blinking 8 When the Interval Count Down Timer stops pr
3. ONS gt to enter the mode and the time digits will blink 3 Adjust hour by pressing lt TEAM1 gt and adjust minute by pressing lt TEAM2 gt 4 Press lt SET POSSESSION gt when setting finishes Me 2 00 L Ho ii ij 0 D 10 O CHOME GUEST SHOME UEST Figure 6 Figure 7 COUNT UP MODE 1 In the TIME DISPLAY MODE press and hold lt MODE gt for 3 seconds 2 times to enter the COUNT UP MODE C UP is shown as in Figure 8 2 Press lt SET POSSESSION gt to enter The timer will switch to 0 00 00 while the period and possession arrow will blink 3 Press lt TEAM2 gt to adjust the period number which goes from 1 gt 2 gt 3 gt 4 gt n gt I1 gt where n implies that the period will keep blank 4 Press lt TEAMI gt to enable or disable the possession arrow alternately 5 Press lt SET POSSESSIONS gt after setting the period and possession arrow 6 Press lt START STOP gt to start and stop the count up timer 7 Press lt SET POSSESSION gt to alter the arrow direction during the count up process 8 When timer stops press and hold lt SET POSSESSIONS gt for 3 seconds to reset the timer to zero 9 Under any static state press and hold lt MODE gt for 3 seconds to enter the COUNT DOWN MODE 1 IE UP JIE l dn J a D L EE G a HONE GUEST a HOME GUEST 7 Figure 8 Figure 9 COUNT DOWN MODE 1 In the TIME DISPLAY MODE press and hold lt MODE gt 3 seconds 3 times to enter the COUNT DOWN MODE
4. T 300 SCOREBOARD WITH PERIOD AND POSSESSION ARROW FEATURES INSTRUCTION MANUAL C Es S 24 hour clock display Count up timer with range to 9 hr 59min 59sec Countdown timer with loud beep Interval Countdown Timer Able to show the Set Points of two teams Display period number together with possession arrow jam i B B 3 B8B a Display scores of two teams up to maximum score of 199 lak RF remote control no cords required Large 4 inches LCD digits for viewing from as far away as 50M 150feet HOME GUEST Powered by AC adapter included or batteries four D size not included pn Wall mounted or free standing 16 different RF channels user adjustable to another channel to avoid interference with nearby units Figure 1 LIST OF ACCESSORIES _ Scoreboard g Bru a S Remote control with four AAA batteries X i S es aa i fo i Stands J065 HY gt 4 Y A p KL AAE E AC adapter For indoor use only Z yj l Y Instruction manual V Figure 2 HOW TO OPEN NAME PLATE DOORS Use a suitable screwdriver to open the side doors as shown in Figure 2 Do this carefully so as not to damage the plastic side doors This allows the removal or insertion of the nameplates and advertisements MOUNTING THE SCOREBOARD The Scoreboard can be mounted on the wall by the means of two screws hooked into the eyelets on the back of the top housing Make sure the screws are securely fixed on the
5. compartments of the Scoreboard and change the 4 position mini toggles to different positions Make sure the 4 position mini toggles are set to identical ON OFF positions else the unit will not work A maximum of 16 different settings can be achieved WATER RESISTANCE The Scoreboard is not water resistant so it should be kept and used in a dry location For outdoor use avoid contact with water or rain TEMPERATURE Do not leave the Scoreboard in direct sunlight or under very high temperatures for an extended time as the display may become black Do not leave the Scoreboard under very low temperatures as this may result in slow moving digits The above conditions will be corrected when the Scoreboard returns to normal temperatures SHOCKS Be careful not to drop the Scoreboard or hit against hard surfaces as it may cause mechanical damages MAGNETISM Not affected CHEMICALS Do not expose the Scoreboard to solvents such as gasoline alcohol cosmetic sprays cleaners paints etc as they may cause damage to the Scoreboard BATTERY REPLACEMENT when powered by DC When the display becomes dim or blank or the remote control does not function battery replacement is necessary Replace with alkaline battery size D 1 5V for the scoreboard and alkaline size AAA 1 5V for the remote control Remove the batteries from the scoreboard and remote control when not being used for an extended time over 3 months TROUBLESHOOTING If the Scoreboard doe
6. ess lt MODE gt to adjust the timer that will blink momentarily Press lt TEAM 1 gt and lt TEAM 2 gt to adjust the interval count down timer as before 9 Under any static state press and hold lt SET POSSESSIONS gt for 3 seconds to reset the time to the original starting time of Timer A 10 If setting of new interval countdown period value Press and hold lt SET gt for 3 seconds twice times to enter the interval count down timer A and timer B as shown in Figure 11 and Figure 12 11 Under any static state press and hold lt MODE gt for 3 seconds to enter the SET POINT MODE Se be si ph ee A 00 00 60 PL PL HE D s e A a Timer indicator A 4 5 i E7 ee we Av Figure 10 Figure 11 Figure 12 Cycle number 2 00 115 _ 0 Gi J p iT GUEST HOE Figure 13 i eee T O FTE ji Figure 14 SET POINT MODE 1 In the TIME DISPLAY MODE press and hold lt MODE gt 3 seconds 5 times to enter the SET POINT MODE S Pt is shown as in Figure 14 P 3 2 Press lt SET POSSESSION gt to enter The period and the possession arrow will blink 3 Press lt TEAM2 gt to enable or disable the period number 4 Press lt TEAMI gt to enable or disable the possession arrow alternately 5 Press lt SET POSSESSIONS gt to confirm the setting 6 After the above setting press lt SET POSSESSION gt to change the possession arrow direc
7. s not function for any reason contact you dealer for an authorized service center Do not try to report it yourself www CEI ULTRAK com BK206 Printed in China P 4
8. tion 7 Press lt MODE gt to adjust the SET POINT The 2 teams set points will blink 8 Press lt TEAM 1 gt to change the set point of TEAM 1 press lt TEAM 2 gt to adjust the set point of TEAM 2 The period will always equal to the sum of two teams set points plus one The maximum period can be up to 9 9 Press lt SET POSSESSION gt after setting the SET POINT 10 Under any static state press and hold lt SET POSSESSION gt for 3 seconds to reset the set points of the two teams 11 Under any static state press and hold lt MODE gt for 3 seconds to return to the original TIME DISPLAY MODE Remarks If the period is chosen to be blank the maximum set points of the two teams can be 9 9 SCORE For resetting the score to zero press the center of both lt TEAM1 gt and lt TEAM2 gt together for 5 seconds Scores cannot be adjusted when the screen displays Hour C UP C dn Int Cd or S Pt CARE OF SCOREBOARD CHANNEL DESIGNATION Each packing box main Scoreboard and remote control box are labeled with the color codes of one of the four present RF channels yellow green blue and orange Each set should have the same color code It is suggested to choose different label set for purchasing 2 to 4 set in order to avoid interference If more than 4 sets of Scoreboard are used you can adjust the Scoreboards to different channels by opening the backs of the remote control and the top
9. wall The Scoreboard can also stand alone on the floor or on a table using the stands of the Scoreboard as shown in Figure 3 POWER UP For AC connection use only the AC adapter 9V supplied with the unit Verify the power rating indicated on the adapters is the same as the AC power supplied in your location Plug the adapter into the socket on the right side of the Scoreboard as shown in Figure 3 The digits will light up automatically and be ready for setting When AC power is not available insert four D size batteries into the battery compartment on the back of the Scoreboard as shown in Figure 4 When using battery power the ON OFF SWITCH can be used to turn the Scoreboard on and off If the batteries are left in the Scoreboard during AC operation they serve as a back up in the event of AC power interruption The volume switch is used for tuning the volume to HIGH LOW or OFF The scoreboard remote control needs four 1 5V AAA size batteries to operate as shown in Figure 5 4 X 1 5V SIZE AAA BATTERIES a x A 4 X 1 5V SIZE D ONOFF SWITCH BATTERY i VOLUME SWITCH W AC ADAPTER SOCKET a ms STAND A SCREW FOR FIXING THE STAND BATTERIES ala hor Figure 3 Figure 4 Figure 5 P 1 TIME SETTING 1 Inthe TIME DISPLAY MODE shown in Figure 6 press and hold lt MODE gt for 3 seconds to enter the TIME SETTING MODE Hour will be shown as in Figure 7 2 Press lt SET POSSESSI
Download Pdf Manuals
Related Search