User`s Manual PBC1 (Item 93924) Single Channel Simultaneous
Contents
1. PBC 1 is a smart battery charger designed for 14 8V Li ion polymer battery This device uses operate amplifier to control charge and maintenance Li ion polymer battery automatically Red color of LED indicates main charging stage Green color means end of charging and enter maintenance mode stage Trickle charging The charger will enter trickle mode when the charging current is less than 1 10 of the charging current or on the Hi level voltage stage Specification Rating AC Input 100 240VAC Rating current 0 4A Max input power 48W Rating frequency 50 60Hz Rating output Vout 16 8V 1 8A Suit Battery 14 8V 2 8 Ah Li ion polymer Battery Protection Output shorted protection or overload will be safe LED Indicator Red Charging Green Finished Maintenance Efficiency gt 80 Operate Temperature 10 degrees C 40 degrees C Humidity lt 90 Caution and Guarantee 1 Please maker sure the battery to be charged is connected property 2 Make sure to charge ONLY Frezzi PB 65 Battery 3 Indoor use only do not use in rain or expose to water 4 High voltage danger Don t open the cover 5 One year use guarantee from date of purchase Frezzi Energy Systems 7 Valley Street Hawthorne NJ 07506 973 427 1160 http www frezzi com PCB1_MANUAL_REV_A2. User s Manual PBC1 Item 93924 Single Channel Simultaneous Charger for PB65 Battery WARNING Read this instruction sheet prior to use 1 Use only with Frezzi PB65 14 8V LI ION POLYMER BATTERY battery pack DO NOT ATTEMPT TO CHARGE ANY OTHER BATTERY DO NOT PLUG CONNECTOR IN TO ANYTHING OTHER THAN PB65 BATTERY OR DAMAGE WILL OCCUR TO EQUIPMENT AND CHARGER 2 Never charge other type of batteries such as NiMH NiCd battery or Lead acid battery pack as this may cause property damage and or personal injury 3 This battery charger is for indoor use only NEVER EXPOSE the charger to rain or snow 4 High voltage dangerous inside DON T OPEN THE COVER 5 Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions a When the power cord or plug is damaged or frayed b If liquid has been spilled into the charger c If the charger casing has been dropped and damaged d If the charger does not operate normally when the operating instructions are followed 6 Make sure good ventilation is provided when charger is operating Don t place the charger near radiator heat register or similar heat source when charging Operate setup 1 Connect AC power plug LED will be green 2 Connect DC battery charge plug to PB65 LED will turn to Red Charge time is approximately 2 5 Hours 3 LED will change to Green when fully charged Remove AC plug and DC plug and use Brief Introduction
Download Pdf Manuals
Related Search