User`s Manual
Contents
1. l Wroann Air i Hot Air LEDIndcators Power Timer Sunulated Flames Heat Control l l Simulated lames Timer Duration Bright H 0 5 7 Alir Dim i Remote Control amp Switch Panel Power switch Plug in power cord the fireplace is now on standby mode Press the power button once the indicator lights up Enjoy the view of the simulated charcoal lighting up and small flames in dancing tempo Press the same power button again and the flames go off The Fireplace is on standby mode again Do not switch on fireplace when air outlets are blocked Heat Control Press this button once and indicator lights up Ten seconds after the mechanism is activated warm air of 750W will be produced through the air outlets at the bottom Press the same button again and the indicator lights up The air outlets will produce hot air of 1500W Press the same button a third time and the mechanism stops functioning after blowing out the remaining air in and shuts off 10 seconds INSTRUCTION FOR REMOTE CONTROL AND SWITCH PANEL cont KA Simulated flames Press either the or the button the indicator light will brighten up or dim the flames Timer This sets the timing for switching the fireplace off automatically The timer s duration ranges from 0 5 to7 5 hours The lighting up shown on the LED indicator indicates the setting of the timer Remote Control Device Itis operated by AAA 7 batteries not included Point2. must not be supplied through an external switching device such as a timer or connected to a circuit that is regularly switched on and off by the utility UNPACKING AND TESTING APPLIANCE Carefully remove the appliance from the box Prior to installing the appliance test to make sure the appliance operates properly by plugging the power supply cord into a conveniently located 110 120 Volt grounded outlet GROUNDING THE APPLIANCE This appliance is for use on 120 Volts The cord has a plug as shown in A An adapter as shown in C is available for connecting three blade grounding type plugs to two slot receptacles The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box The adapter should not be used if a three slot grounded receptacle is available To disconnect appliance turn controls to off then remove plug from outlet WARNING Keep the front of the appliance through which the heat is radiated at least 3 feet away from furniture curtains and other flammable objects at all time Never use an extension lead The mains cable must remain at the back of the appliance and must not be in contact with any hot elements GROUNDING METHODS i METAL SCREW COVER OF A GROUNDED OUTLET BOX GROUNDING PIN ADAPTER C GROUNDING MEANS NOT ALLOWED IN CANADA INSTALLATION ALWAYS unplug this fireplace heater before assembly or cleani
3. User s Manual 80004 Sideline Electric Fireplace MODEL 80004 Read this owner s manual very carefully before using fireplace Please retain for future reference touchstone QP Smart Furniture Beautiful Solution IMPORTANT It is important to read these instructions carefully before using the appliance for the first time Keep the instructions so that you can refer to them later if necessary IMPORTANT INSTRUCTIONS When using electrical appliances basic precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following 1 Read all instructions before using this heater 2 This heater is hot when in use To avoid burning do not touch hot surface If provided use handles when moving this heater Keep combustible materials such as furniture pillows bedding papers clothes and curtains at least 3 ft from the front of the heater and keep them away from the sides and rear In order to avoid overheating do not cover the heater 3 Extreme caution is necessary when any heater is used near children and whenever the heater is left operating and unattended 4 Unplug heather when not in use for extended period of time 5 Do not operate any heater with a damaged cord or plug or after the heater malfunctions has been dropped or damaged in any manner return heater to authorized service facility for examination electrical or mechanical adjustment or repair 6 Do
4. djust from Dimmer to Lighter SAFETY INSTRUCITONS e Only use the appliance in accordance with the instructions in this manual It cannot be used for any other purpose e Never operate when the fireplace or the main cable show any signs of damage e In order to avoid overheating do not cover the heater e Be responsible when handling the packing material Warning plastic wrapping may be lethal to children e Never operate the heater on a program switch timer switch or any other appliance for automatic operation e The heater is only suitable for indoor use e Never use the heater in the bathroom shower or near a swimming pool e The heater must not be located immediately below a socket outlet e If the supply cord is damaged it must be replaced by the manufacturer its service agent a similarly qualified person in order to avoid a hazard e Never leave small children unattended near the appliance e In case of malfunction disconnect the plug immediately e When not in use for a considerable amount of time unplug the appliance e Components should only be serviced by an approved electrician OPERATING THE FIREPLACE TO SWITCH UNIT ON 1 Plug in the appliance into the socket Turn on the Power Switch 2 The control Switch Panel is under the Vent in front of the fireplace See pic ON Power Switch INSTRUCTION FOR REMOTE CONTROL AND SWITCH PANEL Heat Control C E E Control Switch Panel Power I ON gt C OOF F
5. it directly towards the fireplace and it functions within a distance of approx 10 ft The functions are similar to that of the Control Panel CLEANING THE EXTERIOR OF THE APPLIANCE 1 Before cleaning the appliance disconnect it from the socket and allow the fireplace to cool 2 You can clean the exterior of the heater with a soft damp cloth 3 Do not use cleaning or polishing products MANUFACTURERS WARRANTY There is guarantee of one year During this period faulty components will be repaired or replaced free of charge if the fault is due to a manufacturing defect In this case please contact Touchstone Home Products at 800 215 1990 TECHINCAL DATA 80004 Rated Voltage 120V Rated Frequency 60Hz Rated Power 1500W LED Lights 12 1W led light bulbs max 12W WEEE aes Do not dispose of electrical appliances as unsorted municipal waste use separate collection facilities Contact you local government for information regarding the collection systems available If electrical appliances are disposed of in landfills or dumps hazardous substances can leak into the groundwater and get into the food chain damaging your health and well being
6. ng or before relocating Failure to do so could result in electric shock fire or personal injury 1 Using the Philips Screw Driver to take off the two screws in the front two sides Figure A then have two people to take off the Glass Panel Figure B Screw Driver Figure A Figure B 2 Put the Fireplace box into the wall Align the two hanger brackets in both sides of the fireplace box with the studded frame of the wall cut out and using 6 pcs of ST4X 16 screws each side with 3 screws to lock the fireplace in the wooden wall Figure C Note If mounting fireplace below a TV please leave at least 12 between top of fireplace and bottom of TV BS SS SS SSS SS ESE pees R Ss E BS BS SS SS SS Eee iLL __ itl It It J I 1 3 After firmly installing the fireplace box move the glass panel back to the fireplace box and secure the glass panel using the two screws to lock in both sides Figure A p 3 4 The fireplace will look like this after the installation Firgure D SPECIAL FEATURES OF THIS FIREPLACE e The smoldering glow of the flames can hardly be distinguished from that of a real fireplace e Produces heat on a separate setting e Automatic and constant temperature control e Fireplace can be both used as Wall Hanging and Build in the wall e Perfect for rooms of any size e Timer 0 5hrs to 7 5hrs e Operated with remote control and Manual Panel Switch Dimmer Five steps Flame a
7. not use outdoors 7 This heater is not intended for use in bathrooms laundry areas and similar indoor locations Never locate heater where it may fall into a bathtub or other water container 8 Do not run cord under carpeting Do not cover cord with throw rugs runners or similar coverings Arrange cord away from traffic area and where it will not be tipped over 9 To disconnect heater turn controls to off then remove plug from outlet 10 Do not inset or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 11 To prevent a possible fire do not block air intakes or exhaust in any manner Do not use on soft surfaces like a bed where openings many become blocked 12 Do not use it in areas where gasoline or flammable liquids are used or stored 13 Use this heater only as describes in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons 14 DANGER High temperatures may be generated under certain abnormal conditions Do not partially or fully cover or obstruct the front of this heater 15 Replacement of the lamps should be done only while the heater is powered off and unplugged from the electrical outlet 16 Children should be supervised to ensure that they do not play with the appliance 17 CAUTION In order to avoid a hazard due to inadvertent resetting of the thermal cut out this appliance
Download Pdf Manuals
Related Search