Home

RAP17 Series (Real Action Paintball Pistol) Operation

image

Contents

1. Cleaning Cloth on the other end of the Cleaning Wire Pull the Cleaning Wire from the barrel slowly Repeat this procedure with a cleaned Cleaning Cloth if necessary DISASSEMBLING UPPER BODY PROCEDURES EMPTY THE CYLINDER BEFORE ANY FURTHER ACTION TO BE TAKEN TO AVOID ANY UNNECESSARY INJURY Remove the Rear Sight 3403 either to left or right Unscrew the Slide Locking Screw 3404 Pull back the Slide 3402 and lift up the rear part of the Slide 3402 and forward the slide with under control and remove the slide out from the marker Remove the Slide Locking Screw 3407 MARKER CORE DISASSEMBLING Remove the upper body the Slide Refer to DISASSEMBLING UPPER BODY PROCEDURES NOTE EMPTY THE CYLINDER BEFORE ANY FURTHER ACTION TO BE TAKEN TO AVOID ANY UNNECESSARY INJURY Remove the Trigger Stand Locking Pin 3510 Launching Compartment Locking Pin 3511 and Hammer Stand Locking Pin 3512 Pull out the core inner part from the RAP17 pistol ADJUSTING PRESSURE 1 Remove Pressure Adjust cover 3519 2 Use a provided L Key to adjust the Pressure Adjust Screw 3712 through the hole in back of the pistol grip 3 Turn clockwise to increase the pressure and turn anti clockwise to decrease the pressure Note Too much pressure will result in paintball breakage RAP17 Series Trouble Shooting and Maintenance Gas Leak
2. dry up the barrel and apply lubricant oil for protection e DO NOT store the RA P17 or accessories in a place over 45 C
3. RAP17 Series Real Action Paintball Pistol Operation amp Maintenance Manual Before Starting Check the RAP17 Accessories attached Spare Parts 1 x RAP17 marker 2 x L Keys I x Magazine I x Adjusting Tool I x Refill Adaptor 1 x Valve 3108 I x Holster Sling Extension I x O ring 3110 I x Cleaning set Warning his paintball marker is not a toy nor is it intend K g Li linen ML used by any persons under the E age of 18 years Always keep in mind that the sport of Paintball will be viewed and judged upon your safe and Adult Only sportsmanlike conduct This paintball marker takes Co as energy source takes paintball as projectile This paintball marker must be used in the Real Action Exercise or Paintball Sport sport Only Do always wear eye protection in the form of approved goggles or full face mask and never shoot at a person who is not similarly protected Read the warning notice and user manual before you operate this paintball marker to prevent any unnecessary property damage or personal injury Dear User Please read the following note and instructions before you operate the RAP17 Warning This Paintball Marker IS NOT a toy and DO NOT let unsupervised used by person under the age of 18 years old Always keep in mind that the sport of paintball will be viewed and judged upon your safe and sportsmanlike conduct User must relieve the marker s stored internal air pressure eac
4. er to avoid paints and or cartridge cases injury to the eyes DO NOT point or shoot with the Marker to any persons and yourself it may cause blindness or other serious injury Keep the Gas Cylinder and the Marker away from fire or high temperature area in excess of 113F or 45 C Only use Co2 to fill in the Gas Cylinder to operate the Marker DO NOT attempt to strip the Marker and gas cylinder when the gas cylinder is attached DO NOT load any pellets other than paintballs in the Marker Only suggested paintballs are used for the Marker DO NOT carry the Marker without case in the public area DO NOT ship the Marker or accessories except in the original package case DO NOT attempt to rebuild or modify the structure of the Marker It may result in serious injury and damage to the Marker during use Remove the Gas Cylinder form the Marker after use keep the Marker and the Gas Cylinder out of reach of the children at all time Ensure the adjustment of the muzzle energy joule of the Marker is within the limit of local laws Any injury during usage the Marker or any accessories should go to see Doctor immediately DO NOT ATTEMPT to repair the Marker or any accessories of this Marker by yourself should refer to nearest Authorized Service Center e DO NOT ATTEMPT to strip and assemble the Gas Cylinder or the main core DO WEAR appropriate protective dress and mask when using the Marker Suggest that after each use clean
5. h time the air tank is removed or turned off Action Make certain there is no paintball inside the receiver point the marker in a safe direction and depress the trigger until all the air pressure has been relieved Failure to do so may cause accidental firing internal damage and may void your warranty Please wipe lubricant oil to the Launching Compartment 3102 before putting back into storage for protection Thank you for using our products Please contact us for any inquiry regarding maintenance or service Enjoy your Real Action Paintball Marker and play safely Real Action Paintball LLC www rap4 com RAP17 Diagram 10 11 ii ia O D p i GAS FILLING PROCEDURES Push the Cylinder Valve Pin 3719 against table to empty the CO2 cylinder 3715 Check the refilling cylinder if it is filled with CO2 Turn off clockwise the Refill Adapter Switch 3804 Connect the refilling cylinder with Refill Adapter 3802 and apply 2 drops of lubricate oil inside the Refill Adapter 3802 Connect the Refill Adapter 3802 with Cylinder Valve 3716 Turn on the cylinder switch and pull the Trigger 3310 five to seven times Refilling takes about 20 seconds Turn off clockwise the cylinder switch Turn on anti clockwise the Refill Adapter Switch 3804 and let the excess CO2 out Disconnect the Refill Adapter 3802 Put on the Cylinder C
6. ing from the Slide 1 3109 is not tight Tight up 3109 enough Re cock function is not 1 Shoot too many blank a After disconnect the refill working after refill shot while refilling cylinder and shoot few normally 4 5 times blank shot with re cock manually Procedure for Optimum Storage of RAP17 Projectiles Keep the projectiles in a re sealable bag Storage temperature should be 15 30 degree Celsius 60 85 degree Fahrenheit Storage humidity should be 65 80 percent Do not allow the projectiles to freeze They will lose their outer strength integrity Remember the projectiles are sensitive to pressure temperature and humidity If you follow these few short procedures the shelf life of the projectiles is approximately one 1 year Suggest that after each use clean dry up the barrel and put on some lubricant oil for protection DONOT store the RAP17 or accessories in a place over 45 degree Celsius For enquiry please contact your dealer or contact us Si Se ee Important Notices Read the User Manual carefully before using the Marker to avoid any unnecessary accidents or injuries Empty the CO2 cylinder before any maintenance to avoid unnecessary injury Only 18 years old or above to use the Marker Failure to follow the instructions may result in serious injury such as blindness and damage to the property Wear a protective mask or goggle at all time while using this mark
7. over 3518 immediately to prevent damage to the Cylinder Valve 3716 The RAP17 takes about 10g of CO2 and can shot about 30 rounds for each refill Notice Temperature of refilling cylinder must lower than the pistol cylinder PAINTBALL AND MAGAZINE LOADING PROCEDURES Pull down the Paintball Holding Nuts on the magazine until it stays in the bottom and locked Insert paintball into the Magazine 3601 Cock back the Slide 3402 and halt the Slide with applying the Slide Release Catch 3315 Insert the Magazine 3601 into the magazine housing Press the Slide Release Catch 3315 down to let the Slide forward and load the paintball into the chamber MAGAZINE UNLOADING PROCEDURES 1 Ensure the Slide is cocked back or halt at backward 2 Press the Magazine Release Catch 3514 to release the magazine 3 Press down the Slide Release Catch 3315 to let Slide forward and point to the safe direction and pull the trigger once to ensure no paintball inside the chamber ANNAN rN T Ty Th 2 x KS SLL ch Fr A Oo m f nr a A ir 5 E pal i my ARR SGP a H d LI CLEANING BARREL PROCEDURES Pull back the Slide 3402 and halt with apply Slide Release Catch 3315 and ensure no magazine in the magazine housing Pass one end of the Cleaning Wire through the barrel from the Ejection Opening and attach the

Download Pdf Manuals

image

Related Search

Related Contents

  DSO NANO V2 マニュアル V0.9B  User Manual - Biolase Romania  AVR-USB-STK User Manual  Machine à laver Mode d`emploi  陸 上 自 衛 隊 仕 様 書  Mellerware ADRIA 1400 User's Manual  Mode d`emploi EXPERTIS-CALC Version 3.2 - E  

Copyright © All rights reserved.
Failed to retrieve file