THE PROJECTOR SHUTTER. DMX controlled.
Contents
1. DK TELEPHONE 45 86 18 14 20 CELL PHONE 45 40 52 20 88 EMAIL Mads Wahlberg dk SE VATT no 18827638 BANK BG Bank Storetorv 3 Aarhus C Denmark Account No 1199 041 5928 SWIFT BIC DABADKKK IBAN DK8630000000415928 wahlberg LIGHT amp MOTION DESIGN J gerg rdsgade 152 05A DK 8000 Aarhus C DENMARK Optional ON OFF function WWW WAHLBERG DK The shutter with DMX interface has an optional ON OFF function This option makes it possible to use the shutter without DMX signal To do this you need to make a special cable with the required connections to a button ore a relay You can also buy a separate ON OFF switchbox at the web shop 1 Setting of ON OFF address When the address is set to 700 you can use the ON OFF function Note the 10 digit should bee set to 0 if set tol you can test the ON OFF function 2 Setting the operation angle The operation angle is set on the 1 digits on the address When set to 700 you have a small operation angle when set to 709 you have the maximum operation angle 3 Pin Connection on the 5 pole XLR plug Pin GND Pin2 DMX Pin3 DMX Pin 4 5 volt for the switch light sources only 0 05 amp Pin 2 Sense signal for the switch shutter is active when connected to GND WWW WAHLBERG DK TELEPHONE 45 86 18 14 20 CELL PHONE 45 40 52 20 88 EMAIL Mads Wahlberg dk SE VATT no 18827638 BANK BG Bank Storetorv 3 Aarhus C Denmark Account No 1199 02. 41 5928 SWIFT BIC DABADKKK IBAN DK8630000000415928
3. wahlberg LIGHT amp MOTION DESIGN J gerg rdsgade 152 05A THE PROJECTOR SHUTTER DK 8000 Aarhus C DENMARK DMX controlled WWW WAHLBERG DK Contents of the projector shutter 1 motor box with transformer 1 small disc with motor clamp 1 big disc without motor clamp 1 small screwdriver Aluminum cabinet DMX output Motor axe with screw __ for mounting the disc Use the small screwdriver here DMX Input DMX ok lamp DMX address setting User manual DMX 1 Setting of DMX address The DMX address is set on the 3 DMX wheels mounted inside the motor box The red lamp flashes when addresses outside 1 to 512 are chosen 2 Connecting of DMX The DMX signal is applied with a standard 5 pole XLR plug The red lamp shows a constant light when a good signal is found and flashes if the DMX signal is bad or missing 3 Mounting of the disk The disk is mounted on the motor axle When the desired angle has been found the disc can be tightened with the small black screw For this you may use the small screwdriver included with the projector shutter 4 Use of the projector shutter When 220 volts and the DMX have been connected the projector shutter is ready for use By changing the percentage of the chosen DMX address the motor axle can be made to turn forward and backward following the DMX percentage The motor axle can turn from 0 to 180 degrees 0 equalling 0 degrees and 100 being 180 degrees WWW WAHLBERG
Download Pdf Manuals
Related Search