ACH-CAT / ACH-MC
Contents
1. to each other 4 Slide an empty cardboard core only partway about 50mm 2 over the Fingers 5 Now rotate the Flange plates in opposite directions to expand the Fingers against the inside of the cardboard core While you hold the Flanges so the Fingers are against the inside of the core rotate one of the Locking Levers clockwise until it is snug DO NOT OVER TIGHTEN 6 Move the other two 2 Locking Levers to the LOCK position DO NOT OVER TIGHTEN 7 Now slide the core all the way on up against the inside Flange If the core is too tight loosen the Lock Levers and try again Sliding the core a little further over the Fingers to yield less tightness 8 Refer to your Rewinder Unwinder User Manual if needed for operation of the unit itself 9 When rewinding is finished place the Rewinder or Unwinder DIRECTION switch in the centre OFF position 10 Slide the cardboard core and the label roll off the ACH LABELMATE LLC 69 AVENUE ALPHONSE XIII 1180 BRUSSELS BELGIUM TEL 322 375 69 60 FAX 322 375 38 96 brussels labelmate com www labelmate com LABELMATE User_ACH 02 072. ACrI CAT ACrI MC Adjustable Core Holder for CAT UCAT amp MC Label Rewinder amp Unwinder e Three convenient Lock Levers e Use any Core Size 25mm to 101mm 1 to 4 e Core Widths up to 155mm 6 for CAT UCAT and 115mm 4 5 for MC CAT 2 ACH MC 11 Remove all parts from the shipping container and verify contents Package Contents e User Manual this document e ACH Adjustable Core Holder e Allen Wrench e KEEP MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE e SET UP The ACH Adjustable Core Holder is supplied fully assembled ready to use An Allen Wrench is also included e lf yourLABELMATE Label Rewinder or Label Unwinder as a standard Vanes style Core Holder on it or a Quick Chuck Core Holder loosen the Allen screw remove the Core Holder and set it aside e Slide the Hub for the ACH over the motor Shaft of the Label Rewinder or Unwinder Position the Hub so there is a gap between the ACH Hub and the Rewinder or Unwinder Drive Unit Case e Using the supplied Allen Wrench tighten the Allen screw in the Hub onto the flat side of the motor Shaft until it is snug Your ACH is now ready for use USE 1 Loosen the three 3 Lock Levers on the back of the ACH Flange Plate 2 Grasp the front Flange Plate with one hand and the rear Flange Plate with one hand and the rear Flange Plate with the other 3 Rotate the Plates in opposite directions until the three 3 Core Fingers move to the centre of the ACH next
Download Pdf Manuals
Related Search