Manual - Power Inspired Ltd
Contents
1. Important Safety Warning SAVE THESE INSTRUCTIONS CAUTION To prevent the risk of fire or electric shock install in a temperature and humidity controlled indoor area free of conductive contaminants See the specifications for the acceptable temperature and humidity range CAUTION To reduce the risk of overheating the UPS do not cover the UPS cooling vents and avoid exposing the unit to direct sunlight or installing the unit near heat emitting appliances such as space heaters or furnaces CAUTION Do not attach non computer related items such as medical equipment life support equipment microwave ovens or vacuum cleaners to UPS CAUTION Do not plug the UPS input into its own output CAUTION Do not allow liquids or any foreign object to enter the UPS Do not place beverages or any other liquid containing vessels on or near the unit CAUTION In the event of an emergency press the OFF button and disconnect the power cord from the AC power supply to properly disable the UPS CAUTION Do not attach a power strip or surge suppressor to the UPS CAUTION If the UPS is with metal chassis for safety purpose grounding is a must during UPS installation in order to reduce leakage current below 3 5mA Attention hazardous through electric shock Also with disconnection of this unit from the mains hazardous voltage still may be accessible through supply from battery The battery supply should be therefore disconnected in the plus and minus pol2. Fault indicator _ _ i 5 Load level indicator Power switch Power switch AC mode green lighting Battery mode green flashing Fault Red lighting Output receptacles AC input Circuit breaker Fuse Modem Phone Network surge protection USB com port e Mre 3 650V 850VA 1KVA 1 5KVA 2KVA Installation amp Operation NOTE Before installation please inspect the unit Be sure that nothing inside l the package is damaged Placement amp Storage Conditions Install the UPS in a protected area that is free of excessive dust and has adequate air flow Please place the UPS away from other units at least 20 cm to avoid interference Do NOT operate the UPS where the temperature and humidity is outside the specific limits
3. Please check the specs for the limitations tem ttem 4 a Connect to Utility and Charging Plug in the AC input cord to the wall outlet For the best results suggest to charge the battery at least 6 hours before initial use The unit charges its battery while connecting to the utility Connect the Loads 6 hours Plug in the loads to output receptacles on the rear panel of the UPS Simply turn on the power switch of UPS unit then devices connected to the UPS will be protected by UPS unit Connect Modem Phone Network for Surge Protection Connect a single modem phone line into surge protected IN outlet on the back panel of the UPS unit Connect from OUT outlet to the computer with another phone line cable Connect Communication Cable To allow for unattended UPS shutdown start up and status monitoring connect the communication cable one end to the USB RS 232 port and the other to the communication port of your PC With the monitoring software installed you can schedule UPS shutdown start up and monitor UPS status through PC Turn On Off the Unit Turn on the UPS unit by pressing the power switch Turn off the UPS by pressing the power switch again CAUTION NEVER connect a laser printer or scanner to the UPS unit This may cause the damage of the unit Troubleshooting Possible Cause Solutions LCD blank No LEDs AC input is not connected Check if the input powercord is firmly illuminated when Mell connected to
4. the mains mains is normal AC input is connected to the Plug AC input power cord to AC input UPS output correctly Battery backup time is Batteries are not fully shorter than nominal charged value Charge the batteries at least 6 hours and then check the capacity again If the problem still persists please consult your dealer Batteries defect Contact your dealer to replace the batteries Warning or fault icon Fan is locked or not working Check fans and notify your dealer is shown and alarm is The UPS is overload Remove some loads first Before reconnecting devices please verify the total loads match the UPS capability specified in the spec Charge the UPS at least 6 hours Low battery icon is __ Low battery shown on the LCD screen
5. 12V 7AHx1 12V 9AHx1 12V 7AHx2 12V 9AHx2 12V 9AHx2 5 Disconnect charging source prior to connecting or disconnecting batteries terminal Charging Time 4 6 hours recover to 90 capacity PHYSICAL Software Download amp Installation Dimension DxWxH mm 287 x 100 x 142 350x146x160 307 x 146 x 205 If your UPS came with a software CD follow the instructions on the CD otherwise Net Weight kgs 4 25 49 8 0 aba 115 1 Go to the website http www power software download com T SaL 0 90 RH 0 40 C non condensing 2 Click ViewPower software icon and then choose your required OS to downloadthe software Nosie Level Eoen 40d 3 Follow the on screen instructions to install the software MANAGEMENT USB Supports Windows 2000 2003 XP Vista 2008 Windows 7 8 L Linux Unix and MAC Power Inspired Ltd Units 5 7 High Point Riding Road Brackley UK Tel 01280 811180 www powerinspired com VIX3000 REV1 Introduction Thank you for purchasing a Power Inspired Uninterruptible Power Supply For further information on this product or for support please visit www powerinspired com vix3000 Product Overview LED Models LCD Models UPS status LED LCD panel s f el a i i Seen AHE Ay O i oe a fal js AS O PERT e e n T P L T 1 Input information 6 Battery capacity indicator 2 Output information 7 Overload indicator proper Arownr 3 AC mode indicator 8 Low battery indicator Li ilia m 4 Battery mode indicator 9
6. e at the quick connectors of the battery when maintenance or service work inside the UPS is necessary CAUTION Servicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the required precautions Keep unauthorized personnel away from batteries CAUTION When replacing the batteries use the same number and type of batteries CAUTION Internal battery voltage is 12VDC Sealed lead acid 6 cell battery VIX3000 Series Line Interactive UPS System CAUTION Do not dispose of batteries in a fire The battery may explode Do not open or f Model VIX3065 VIX3085 VIX3100 VIX3150 VIX3200 mutilate the battery or batteries Released electrolyte is harmful to the skin and eyes CAPACITY 650VA 360W 850VA 480W 1000VA 600W 1500VA 900W 2000VA 1200W CAUTION Unplug the UPS prior to cleaning and do not use liquid or spray detergent INPUT CAUTION A battery can present a risk of electric shock and high short circuit current The a Range 220 530 Rak MAC following precaution should be observed before replacing batteries OUTPUT 1 Remove watches rings or other metal objects Voltage Regulation 10 2 Use tools with insulated handles Transfer Time Typical 2 6 ms 10 ms max 3 Wear rubber gloves and boots waveform Simulated Sine Wave 4 Do not lay tools or metal parts on top of batteries Type amp Number
Download Pdf Manuals
Related Search