ADE-24 Analog/Digital Enhancer Some listeners feel
Contents
1. ADE 24 Analog Digital Enhancer Some listeners feel digital recording is flat and sterile sounding lacking the warmth and presence of analog reproduction For those listeners Margules Audio has designed the Magenta ADE 24 Analog Digital Enhancer Until now the problems involved in reconstructing the original analog signal from digital samples have been dealt with in the digital domain This requires complex and expensive DSP digital signal processing circuitry In our research we found that the basic problems can be solved in the analog domain The design of the ADE 24 is based on the idea that high order odd harmonics are generated during the reconstruction of the analog signal These harmonics falsify instrumental timbre and create a bright hard or harsh sound We designed a circuit that removes these unwanted harmonics and more closely approximate the original signal Implementing this design would normally require integrated circuits with less than perfect sound quality or costly discrete circuits Our original circuit topology patent pending gives outstanding performance at a reasonable price History of Value and Innovation Margules Audio been part of the audio industry for more than 40 years Its entry level products have been marketed under the Magenta brand for 13 years Magenta products are designed to offer the best cost performance ratio possible The ADE 24 was engineered to provide most of the sonic benefits2. ail info margules com mx Visit our home page in internet http www margules com mx ADE 24 User Manual Digital Analog Enhancer
3. ms power consumption 10W Trouble Shouting It doesn t sound The led to turn on The device plugged to the wall outlet And to have the correct voltage supply If it still doesn t turn on there is an internal fuse of 5 A to protect the device if you fill capable off changing it disconnect the ADE 24 from the wall outlet and open it from the screws in the bottom It is very important to replace it with the same value to avoid fire hazards We recommend in this very rare occasions to take it to you dealer If the led does turn on The inputs and outputs correctly connected The input should be connected to the output of the source and output to the input of the preamplifier or the integrated amplifier If the above conditions are correct The selector position in your preamplifier or integrated amplifier to be properly set If it sounds but not properly Very noisy Correct power voltage input for the device Tight ground connections in the inputs and outputs of the signal Note It is recommendable to have as far away as possible the signal cables from the power cord Doesn t sound clear The maximum signal voltage before saturating the ADE 24 is 4 7 v be sure not to overcome this level do not connect directly an amplified device into it For more information please contact us at MARGULES AUDIO Uruapan 17 4 Col Roma Mexico D F 06700 Mexico Tel 525 514 7448 Toll free 1 888 538 8605 FAX 525 533 4654 Em
4. of expensive DSP at a fraction of the cost The ADE 24 substantially improves the sound quality of any digital source with sample rating of 44 1Khz or less This isn t magic it s the product of research in electronics and psychoacoustics You can expect the following improvements enhanced detail greater air and acoustic space between instruments reduced edginess and harshness improved imaging increased dynamic range The ADE 24 is connected to the output of any digital audio source CD DAT D A converter Laserdisc AC 3 Dolby Digital and DTS DSS Computer multimedia Precaution and care of your new ade 24 This product is intended to be plugged directly to the power supply line of your house although we have taken all the precaution to make your equipment completely safe and complies with the safety standards we recommend that if your are not going to use your system for an extended period of time to unplug it from the wall outlet Keep the equipment in a well ventilated area and far away from materials that can be ignited Do not expose to rain or direct sun light Do nat open high voltage no serviceable parts inside The voltage supply should be 15 of the specified in the product To clean it use a soft lightly hummed felp Specifications Frequency response 15 20 000 HZ THD lt 0 06 noise 0 15 mV maximum input voltage 4 7 V rms maximum output voltage 4 8 V r
Download Pdf Manuals
Related Search