FIND-R-SCOPE UV-SCOPE OPTICAL RELAY User`s Manual
Contents
1. Other FIND R SCOPE Product Lines FIND R SCOPE FIND R SCOPE FIND R SCOPE FIND R SCOPE FIND R SCOPE FIND R SCOPE FIND R SCOPE FIND R SCOPE FIND R SCOPE Infrared viewer with IR light source 1800 amp 2200 nm camera viewers Infrared video system amp monitor Helmet mounted infrared viewer Microscope mounted infrared viewer UV viewers Electronic infrared viewer Speckle Buster Radiometric Infrared Imager FJW Optical Systems Inc 322 N Woodwork Lane Palatine IL 60067 4933 Tel 847 358 2500 Fax 847 358 2533 E mail irsales findrscope com www findrscope com 85643M Rev 1 09 2007 FIND R SCOPE and SCOPE OPTICAL RELAY User s Manual For Part 85643 FJW plical Systems Inc 85643M Rev 1 09 2007 Several things to consider before coupling the CCD camera to your FIND R SCOPE IR viewer 1 Itis best if the viewer is supported i e mounted on a rigid object like a sturdy tripod or mounted on an optical table 2 The viewer should be focused on a target pro ducing a clear image on the screen 3 Care should be taken that the focus is not dis turbed during the mounting of the relay and camera 4 The Relay may be used to couple any video camera equipped with a C or a CS lens mounts If the camera has a CS mount then a 5 mm extension ring must be inserted into the CS mount The relay interfaces with the Find R Scope Relay CCD cam2. era assembly viewer at the eyepiece mounting threads and with the camera at the lens C mount 5 The Relay may be used with the following FIND R SCOPE viewers 84499A 84499 se ries 85100 85300 the UV Scope 85100A amp 84530A 6 The heavier of the two viewer or camera should be supported or mounted on a rigid body The lighter of the two is then supported via the Relay Assembly The Relay Assembly will support the weight of the viewer 7 The following procedure describes mounting a camera which is lighter than the viewer 1 6 It is best to do this part with the viewer mounted on a tripod and to have the viewer objective pre focused at a target Take the Camera Relay Lens Housing Assembly and insert it into the Relay Housing Tighten the thumb screw to hold the sys tem together Connect the camera to power and to your monitor Switch the viewer on Release the thumb screw enough to enable you to move the camera Move the camera in and out to find the best focus At the best focus rotate the camera to achieve the needed image orientation and tighten the thumb screw 85643M Rev 1 09 2007 FHD n acnpg Unscrew the Eyepiece Assembly as shown above oplit the relay assembly by releasing the thumb screw and pulling the two assemblies apart as shown above The smaller diameter component on the left is the relay Lens Housing Assembly The larger one on the right is the Relay Housing As
3. sembly 2 85643M Rev 1 09 2007 Take your CCD camera and remove the lens If your camera has the CS mount and the C mount adapter ring comes off with the lens unscrew the ring from the lens and screw it back into the cam era lens mount Take the relay lens housing and screw it into the camera lens mount Take the relay housing insert it into the eyepiece opening col lapsing the spring and screw it in in place of the eyepiece FHD A ncapg Camera and Relay Lens Housing assembly Assembly of the viewer and relay housing 3
Download Pdf Manuals
Related Search