User`s Manual
Contents
1. 10 CAUTION SAVE THS INSTRUCTIONS This manual contains important safety and operating instructions for the G10 XXN battery charger Please read the caution of batteries or devices you want to charge firstly When charging batteries can emit explosive gases therefore itis essential to prevent flames and sparks The charger is designed for charging specified NIMH NICD batteries Do not use for any other purpose Always provide good ventilation when charging Use of an attachment not recommended or sold by Green Digital Power tech may result in a risk of fire electric shock or Serious Injury to persons To reduce risk of damage to electric plug and cord pull by the plug rather than by the cord when disconnecting charger An extension cord should not be used unless absolutely necessary Use of an improper extension cord could result in a risk of fire and electric shock If extension cord must be used make sure that a Pins on plug of extension cord are the same number size and shape as those of plug on charger b Extension cord is properly wired and in good electrical condition and c Wire size is large enough for ac ampere rating as specified in technical data Do not operate charger with a damaged cord or plug return the charger to the place where purchased Never operate the charger if it has received a sharp blow been dropped or otherwise damaged in any way take is to a qualified serviceman Do not disassemble th2. e charger take it to a qualified serviceman when service or repair is required Incorrect reassembly may result in a risk of electrical shock or fire To reduce risk of electric shock unplug charger from AC outlet before attempting any maintenance or cleaning Turning off controls will not reduce the risk m tal reen Green Digital Power G10 XXN 4 8V 12V NIMH NICD Battery Charger User s Manual May 2011 1rd Version Green Digital Power tech Co Ltd Brief Introduction G10 XXN is a main member of digital chargers from Green Digital Power tech Co Ltd It represents today s new technology for 4 8V 4s 12V 10s NIMH NICD battery pack charging G10 XXN programmed 2 auto stages Im It charging process It is designed for 4s 4 8V 10s 12V 2 8Ah NIMH NICD battery pack When the battery was connected properly stage Im will give bulk constant current charging This is the main charge stage when the battery nearly charged full dV phenomenon will be detected by the MCU in charger dV value is 3 6mV per cell about Then the battery will leave bulk stage and cut off output or enter a defined trickle pulse charge stage It to maintain battery Further G10 can display the charging process indicate the battery capacity from 50 to 100 timely This is helpful for user For more safety G10 will inter protection mode when the battery polarity reversed our the output connectors shorted Specification
3. for G10 XXN Input Voltage 100 240VAC 50 60Hz Charge voltage limit G10 08N G10 12N G10 20N suit for 3s 4s suit for 5s 6s suit for 7s 10s Mog 100g Display Panel Charging process indicator Indicate battery capacity from 50 to 75 then to 100 when charging input OK All 3 lamps flashing means battery polarity reversed or output shorted All lamps are off means no battery How to use 1 Connect the AC cord to the socket The power lamp will light on RED 2 Connect positive charger clip red to positive battery terminal the black clip to negative You can use other dc plugs to connect battery the 50 100 lamps will light on flowing If the battery polarity reversed or output shorted 3 lamps will flashing please check the setup 3 Depend on the charged capacity 50 100 lamps will lights up solid sequence until the battery is fully charged Then you can power off the charger and disconnect the battery or you can charge a new battery if you need The table shows the duration of 100 state charged for an empty battery Battery Cap Ah G10 08N hours G10 12N hours G10 20N hours C fd
Download Pdf Manuals
Related Search