User`s Manual - UsedPhoneBuyer.com
Contents
1. limitation of implied warranties therefore the aforesaid limitation s may not apply to the purchaser EXCEPT AS PROVIDED ABOVE IN NO EVENT WILL PARA SYSTEMS BE LIABLE FOR DIRECT INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE Specifically Para Systems is not liable for any costs such as lost profits or revenue loss of equipment loss of use of equipment loss of software loss of data cost of substitutes claims by third parties or otherwise The sole and exclusive remedy for breach of any warranty expressed or implied concerning Para Systems s products and the only obligation of Para Systems hereunder shall be the repair or replacement of defective equipment components or parts or at Para Systems s option refund of the purchase price or substitution with an equivalent replacement product This warranty gives you specific legal rights and you may also have other rights which vary from state to state Longer term and F O B job site warranties are available at extra cost Contact Para Systems 1 972 446 7363 for details Page 2 of 2 34000218 Rev02. User s Manua The SNMP C04 and the SNMP C05 can be setup to be used as an Environmental Monitoring Device by attaching the Temperature Humidity Probe This is the installation procedure of the Temperature Humidity Probe NOTE The user must configure the EMD see the EMD User s Manual Temperature Humidity Probe Contents of the Temp Hum Probe Package 1 Temperature Humidity Probe 2 3 5 Floppy Disk with the Temp Hum Probe User s Manual and the EMD User s Manual Installation Procedure of the Temp Hum Probe Turn off all the equipment that is plugged into the UPS Turn off the UPS and unplug the UPS s power cord from the AC wall outlet Plug the RS232 connector on the Temp Hum Probe into the RS232 connector on the front of the SNMP C04 or the SNMP CO05 Tighten the screws on the RS232 connector for the Temp Hum Probe Plug the UPS s power cord into the wall outlet Turn the UPS and your equipment ON The Temp Hum Probe is operational oOn gt NDNA NOTE The user must configure the EMD see the EMD User s Manual Page 1 of 2 34000218 Rev0 LIMITED PRODUCT WARRANTY Para Systems Inc Para Systems warrants this equipment when properly applied and operated within specified conditions against faulty materials or workmanship for a period of three years from the date of original purchase by the end user For equipment sites within the United States and Canada this warranty covers repair or replacement of d
3. efective equipment at the discretion of Para Systems Repair will be from the nearest authorized service center Replacement parts and warranty labor will be borne by Para Systems For equipment located outside of the United States and Canada Para Systems only covers faulty parts Para Systems products repaired or replaced pursuant to this warranty shall be warranted for the remaining portion of the warranty that applies to the original product This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase The warranty shall be void if a the equipment is damaged by the customer is improperly used is subjected to an adverse operating environment or is operated outside the limits of its electrical specifications b the equipment is repaired or modified by anyone other than Para Systems or Para Systems approved personnel or c has been used in a manner contrary to the product s operating manual or other written instructions Any technical advice furnished before or after delivery in regard to use or application of Para Systems s equipment is furnished without charge and on the basis that it represents Para Systems s best judgment under the circumstances but it is used at the recipient s sole risk EXCEPT AS PROVIDED HEREIN PARA SYSTEMS MAKES NO WARRANTIES EXPRESSED OR IMPLIED INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE Some states do not permit
Download Pdf Manuals
Related Search