Deep Trekker - Quickstart guide
Contents
1. you swim up or down In this case the camera stays horizontal If you want the camera to automatically look up when you are driving up etc Set it to stay in aligment with your thrusters Toggle between the two options by holding the fault reset and the camera back to center buttons together for 4 seconds TIP FIVE Auto Heading and Auto Depth ONLY APPLICABLE FOR SMART AND WORKER DTG2 PA Auto heading and depth makes driving a little bit easier for you You will know it is enabled when there are parenthesis around the on screen units TIP SIX Removing the grabber ONLY APPLICABLE FOR THE WORKER DTG2 PACKAGE 1 Make sure your ROV is off and dry 2 Remove the electrical connector and plug the port with the plug provided 3 Remove the 4 pins that hold the grabber arm onto the ROV 4 Install the skis on each side of the ROV using the same 4 pins before you set out on a dive To reattach the grabber arm take off the skis and reattach the grabber with the pins Then remove the plug note the orientation of the pins on the connector and reconnect the electrical connector Tighten only by hand only2. TIP ONE Remove the shipping screws IF YOU ONLY READ ONE PART OF THE GUIDE THIS SHOULD BE IT Turn your ROV upside down so the handles are facing downward Use a flathead screwdriver to turn both shipping screws counter clockwise until the heads are against the cover plate Gently rotate your ROV back to the level position De Hoogjens 22 4254 XW Sleeuwijk The Netherlands T 31 183 307900 F 31 183 307910 E info seascape nl www seascape nl Remove the charge port plug and in sert the charger the LED will be red as the ROV charges and turn green when it is fully charged Re insert the charge port plug to the ROV before you head out on a dive The controller has its own charging cable again plug it in to the charging port and the LED light will illuminate green when the controller is fully charged CHARGING COMPLETELY USUALLY TAKES ABOUT 3 HOURS DEEP REKKER Araua EXPLORING NEW WORLDS Thank you for purchasing the DEEP TREKKER DTG2 ROV We ve put together some quick tips for you to learn the basics of discovering the underwater world with the DTG2 ROV Once you have mastered this quickstart guide you will be well on your way to becoming an expert operator of the only fully portable remotely operated vehicle on the market always read the user manual TIP THREE Adjusting the bouyancy of Before a dive it is imporant to check the bouyancy of your ROV It is easiest to drive when it is co
3. mpletely neutral Although some like it to be a little heavy or light Using a Phillips screwdriver remove the screws holding on to the handles Add or remove the ballast plate provided to adjust the bouyancy Put back the handles and screws More ballast plates can be added or removed from the bottom feet of the ROV as well TIP THREE Learning how to drive your R Take a moment to get familar with the controls to drive the ROV Don t forget you can rotate the camera independently of the ROV body this will be important as you become an expert The thrusters joystick will swim your ROV in any direction on a horizontal plane while the pitching joystick rotates your whole ROV body and controls the grabber arm optional De Hoogjens 22 4254 XW Sleeuwijk SEES eM aINCECIS E info seascape nl www seascape nl The Netherlands T 31 183 307900 F 31 183 307910 TIP THREE CONTINUED How to swim up ar YES WITH ONLY TWO THRUSTERS You must hold both joysticks at the same time to swim up and down If you push the pitching joystick only half way the ROV will move at a 45 degree angle This will be helpful when you are making percise movements TIP FOUR Adjusting your camera angle At any time you can rotate your camera 270 degrees around the body of the ROV the LED flood light also tracks along with it The photo displays how the camera will hold the angle you set it to as
Download Pdf Manuals
Related Search