installation guide for wall mount kit of pp-8000 series
Contents
1. into the plastic cotter and screw in but leaving about 7 mm or i 9 32 of screw neck exposed from wall surface These 2 screws will then be used for hanging the printer 2 Please note that on bottom of the printer there are 2 holes 80 mm apart for hanging the printer over the screws on wall as indicated in the upper right picture Hang the printer onto the wall with the 2 screw heads going into these 2 holes 3 Now push the hood release button of the printer the hood will now fully open Insert the paper roll shaft in the paper roll and put the whole Paper paper roll inside the printer into Roll the guides on both sides till it Shaft holds in position for wall mount application as indicated in lower right picture Close the hood and tear off the excessive paper 4 To prevent any confusion as a Guide result from different paper roll position in wall mount application please change in service window DIP switch 1 position 5 to ON So that the printer won t respond to host as busy just by paper near end signal caused by this position change Of course you may also leave this setting unchanged and do the sensor position adjust carefully for the specific paper roll used particularly for wall mount application according to the User s Manual of PP 8000 series 5 Please make all necessary cable connections to the printer then the printer is ready for wall mount operation2. POSIFLEX INSTALLATION GUIDE FOR WALL MOUNT KIT OF PP 8000 SERIES Rev Original KIT PART NUMBER 39776001010 KIT CONTENT Besides this guide Drill pattern on wall Fig 1 Kit content besides this guide Printer not included PART NUMBER _ DESCRIPTION 10642035162 Self Tapping Screw 3 50 16L Pa 10241000021 Plastic Plug za 103 19770201010 Paper Roll Shaft KIT APPLICATION This kit can be used to hang Posiflex thermal POS printer PP 8000 series for wall mount application INSTALLATION 1 Please first determine a suitable area on a rigid wall surface to support firmly the weight of the printer for its wall mount application In this area the environmental condition should be adequate for a reliable service of the printer Considerations include sufficient ventilation and effectively protected against unwanted contamination Keep the printer away from direct sunshine excessive heat or moisture Please then follow the Printer Wall Mount Installation Guide 1 P N 19770901010 POSIFLEX preparation procedures described below Drill 2 holes 3 15 or 80 mm apart at same height on the rigid wall Hole diameter should be 1 4 or 6 35 mm each Hole depth should be at least 1 and 3 16 or 30 mm Please then insert one plastic plug into each hole leaving the flat end with hole of the plastic plug at the outside opening of the hole on wall Use a hammer to tap the plastic plug in gently if necessary Insert the attached screws
Download Pdf Manuals
Related Search