ematrix quick reference guide
Contents
1. treatment parameters select the Program and the RF fluence according to the skin type severity of the skin s condition treatment area bone proximity etc Perform several low energy test pulses if skin response and patient s tolerance allows gradually increase treatment parameters e Place the applicator on the skin with the tip perpendicular to the skin s surface and in full contact with it Each tip is designated for the treatment of one patient only to prevent cross contamination For more detailed instructions refer to the Clinical Guide Chapter in the appropriate User Manual Syneron Powered by elos e Begin treatment with conservative parameters on a small area Emit 5 7 pulses on soft tissue e g preauricular and assess the feedback bar in case of low impedance ORANGE pulses wipe the skin with alcohol or any strong degreasing agent and wait 5 minutes In case of RED pulses clean the tip and re pulse assuring full contact of the tip with the skin e When a Clean tip Check Contact message appears clean tip with an alcohol moistened gauze pad then dry with gauze e When using high energy levels clean the tip every 5 pulses e After completing a full pass on the entire treatment area if untreated patches of skin are apparent re treat these patches Post Treatment Care e Post treatment emollient cream may be applied to the treatment area e If the patient feels post treatment discomfort you may cool the2. Syneron Powered by elds Sublative RF Quick Reference Guide Systems eElOS PIUS ewo eMatnx Treatment Parameters Program A Low Impact mJ Pin Program B Medium Impact mJ Pin Program C High Impact mJ Pin 10 15 20 25 30 32 36 40 44 48 50 53 56 59 62 C RF Energy levels should be reduced by 20 for Asian patients and Skin Types V amp VI and when treating on boney areas Pre Treatment e Shave any hair in the treatment area e Thoroughly wash the treatment area with cleanser and lukewarm water dry it thoroughly e If required apply a topical anesthetic gel on the entire treatment area Use the anesthetic according to manufacturer guidelines Post anesthesia wipe off the gel with a dry gauze pad and thoroughly wash the skin with cleanser and lukewarm water and dry Ensure that all the anesthetic gel has been removed and that the skin is completely dry before commencing treatment e No lotion gel or coupling medium should be used during treatment e Open the sealed pack of a Sublative iD tip connect the tip to the distal port of the applicator with the T symbol on the tip aligned with the top of the applicator and ensure that the tip is secured in place Treatment Procedure e Ensure skin is completely clean and dry during the entire treatment If skin moistens during treatment i e perspiration etc re wipe the skin with a gauze pad and continue treatment e Set
3. treated area with air cooling such as SynerCool or cold not frozen compresses may be used e Tiny scabs of less than 1 mm diameter will usually form 24 72 hours post treatment and may remain for a few days The scabs should not be touched or scratched and should be allowed to shed off naturally e The patient should use a high factor sunscreen at least 30 SPF and protect the treated area from sunlight during the entire course of treatment and for at least one month after e The patient should use plenty of moisturizing cream between treatments For more detailed instructions refer to the User Manual Copyright June 2012 Syneron Medical Ltd All rights reserved Part PB73545EN
Download Pdf Manuals
Related Search