Tube Reverb tube reverb user manual
Contents
1. 19 Protecting the environment 8 Protecting the environment Disposal of the packaging mate rial Disposal of your old device themann MUSIC IS OUR PASSION For the transport and protective packaging environmentally friendly materials have been chosen that can be supplied to normal recycling Ensure that plastic bags packaging etc are properly disposed of Do not just dispose of these materials with your normal household waste but make sure that they are collected for recycling Please follow the notes and markings on the packaging This product is subject to the European Waste Electrical and Electronic Equipment Directive WEEE Do not dispose with your normal household waste Dispose of this device through an approved waste disposal firm or through your local waste facility When discarding the device comply with the rules and regulations that apply in your country If in doubt consult your local waste disposal facility tube reverb 20 Notes Tube Reverb th mann MUSIC IS OUR PASSION 21 Notes th mann tube reverb MUSIC IS OUR PASSION 22 Musikhaus Thomann e K Treppendorf 30 96138 Burgebrach Germany www thomann de2. caution is indicated Even if a plug fits into the socket an incorrect connection may result in a destroyed power amp a short circuit or just in poor transmission quality Unbalanced transmission is mainly used in semi professional environment and in hifi use Instrument cables with two conductors one core plus shielding are typical representatives of the unbalanced transmission One conductor is ground and shielding while the signal is trans mitted through the core Unbalanced transmission is susceptible to electromagnetic interference especially at low levels such as microphone signals and when using long cables In a professional environment therefore the balanced transmission is preferred because this enables an undisturbed transmission of signals over long distances In addition to the conduc tors Ground and Signal in a balanced transmission a second core is added This also transfers the signal but phase shifted by 180 tube reverb 18 Plug and connection assignment Since the interference affects both cores equally by subtracting the phase shifted signals the interfering signal is completely neutralized The result is a pure signal without any noise inter ference 1 4 TS phone plug mono unbalanced 1 Signal R 2 Ground shielding 1 4 TRS phone plug mono bal anced 1 Signal in phase a 2 Signal out of phase N 3 Ground Tube Reverb th mann MUSIC IS OUR PASSION
3. thomann de you will find lots of further information and details on the following points Download This manual is also available as PDF file for you to download Use the search function in the electronic version to find the topics of Keyword search interest for you quickly Our online guides provide detailed information on technical basics Online guides and terms Personal consultation For personal consultation please contact our technical hotline If you have any problems with the device the Service A S S customer service will gladly assist you Tube Reverb th mann MUSIC IS OUR PASSION General information 1 2 Notational conventions This manual uses the following notational conventions Letterings The letterings for connectors and controls are marked by square brackets and italics Examples VOLUME control Mono button 1 3 Symbols and signal words In this section you will find an overview of the meaning of symbols and signal words that are used in this manual th mann tube reverb MUSIC IS OUR PASSION General information Signal word Meaning DANGER This combination of symbol and signal word indicates an immediate dangerous situation that will result in death or serious injury if it is not avoided NOTICE This combination of symbol and signal word indicates a pos sible dangerous situation that can result in material and environmental damage if it is not avoided Warning signs Type of
4. PASSION Safety instructions themann MUSIC IS OUR PASSION DANGER Electric shock caused by short circuit Do not modify the mains cable or the plug Failure to do so could result in electric shock death or fire If in doubt seek advice from a registered electrician NOTICE Risk of fire Do not cover the device nor any ventilation slots Do not place the device near any direct heat source Keep the device away from naked flames NOTICE Operating conditions This device has been designed for indoor use only To prevent damage never expose the device to any liquid or moisture Avoid direct sunlight heavy dirt and strong vibrations tube reverb 10 Safety instructions NOTICE Power supply Before connecting the device ensure that the input voltage AC outlet matches the voltage rating of the device and that the AC outlet is protected by a residual current circuit breaker Failure to do so could result in damage to the device and possibly injure the user Unplug the device before electrical storms occur and when it is unused for long periods of time to reduce the risk of electric shock or fire Tube Reverb th mann MUSIC IS OUR PASSION 11 Features 3 Features Tube reverb unit In and output 1 4 phone sockets Controls Dwell Mixer Tone Foot switch included th mann tube reverb MUSIC IS OUR PASSION 12 Notes on use 4 Notes on use Unpack and carefully check that there is n
5. Schelle Tube Reverb tube reverb th mann user manual MUSIC IS OUR PASSION Musikhaus Thomann e K Treppendorf 30 96138 Burgebrach Germany Telephone 49 0 9546 9223 0 E mail info thomann de Internet www thomann de 16 10 2014 ID 344876 Table of contents Table of contents 1 General information sees eee 4 1 1 Further information 1 2 Notational conventions 1 3 Symbols and signal Words sss 6 Safety instructions u sesidnieenniins keiten enden 8 Features un aana oaos SaaS AT eSEE NESNA Nisaa Nerea CSa aN Notes on use uueeeenseneensensennsennenneenn Connections and operating elements Technical specifications Plug and connection assignment essere on AO vu A V N Protecting the environment u unneneeneenenensnnensennssennen Tube Reverb th mann MUSIC IS OUR PASSION General information 1 General information This manual contains important instructions for the safe operation of the unit Read and follow the safety instructions and all other instructions Keep the manual for future reference Make sure that it is available to all those using the device If you sell the unit please make sure that the buyer also receives this manual Our products are subject to a process of continuous development Thus they are subject to change th mann tube reverb MUSIC IS OUR PASSION General information 1 1 Further information On our website www
6. danger Warning high voltage N Warning danger zone Tube Reverb th mann MUSIC IS OUR PASSION Safety instructions 2 Safety instructions Intended use themann MUSIC IS OUR PASSION This device is intended to be used for sound processing of signals from musical instruments with electromagnetic pickups Any other use or use under other operating conditions is con sidered to be improper and may result in personal injury or property damage No liability will be assumed for damages resulting from improper use This device may be used only by persons with sufficient physical sensorial and intellectual abilities and having corresponding knowledge and experience Other persons may use this device only if they are supervised or instructed by a person who is responsible for their safety tube reverb Safety instructions Safety DANGER Danger for children Ensure that plastic bags packaging etc are disposed of properly and are not within reach of babies and young children Choking hazard Ensure that children do not detach any small parts e g knobs or the like from the unit They could swallow the pieces and choke Never let children unattended use electrical devices DANGER Electric shock caused by high voltages inside Within the device there are areas where high voltages may be present Never remove any covers A There are no user serviceable parts inside Tube Reverb th mann MUSIC IS OUR
7. lder Power indicator This LED lights constantly red during operation DWELL Control to adjust the reverb effect depth INPUT 1 4 TS phone socket for the input signal from the instrument If you patch the unit to the effects loop of the ampli fier connect this input to the SEND out of the amp s effect loop MIXER Control to adjust the amount of effect in the output signal Tube Reverb th mann MUSIC IS OUR PASSION 15 Connections and operating elements 7 TONE Control to shape the sound 8 OUTPUT 1 4 TS phone socket to connect an amp or active speaker If you patch the unit to the effects loop of your amplifier connect this output to the RETURN in of the amp s effect loop th mann tube reverb MUSIC IS OUR PASSION 16 6 Technical specifications Tubes Operating supply voltage Power consumption Dimensions W x H x D Weight Technical specifications 1 x 6V6 1 x 12AX7 and 1 x 12AT7 AC 220 240 V 50 60 Hz 20 W 480 mmx 285 mmx 190 mm 8 3 kg Tube Reverb th mann MUSIC IS OUR PASSION 17 Plug and connection assignment 7 Plug and connection assignment Introduction Balanced and unbalanced trans mission themann MUSIC IS OUR PASSION This chapter will help you select the right cables and plugs to connect your valuable equip ment in such a way that a perfect sound experience is ensured Please note these advices because especially in Sound amp Light
8. o transportation damage before using the unit Keep the equipment packaging To fully protect the device against vibration dust and moisture during transportation or storage use the original packaging or your own packaging material suitable for transport or storage respectively Handle the unit with care The built in tubes are especially in heated state very sensitive to vibration e g during transport and setting the device down Do not attempt to disassemble or repair the device yourself if it should not work All repairs and service as well as the replacement of tubes must only be performed by authorized per sonnel Always replace a blown fuse with a new one of the same type The tube reverb is suitable for use with transistor and tube amplifiers For best sound results you should always connect the device to the clean channel of the amplifier To achieve an overdrive effect we recommend to use a distortion pedal in front of the tube reverb or to patch the reverb unit to the amp s effects loop and connect the instrument to the distortion channel of the amp and to set the input gain appropriately Tube Reverb th mann MUSIC IS OUR PASSION 13 Connections and operating elements 5 Connections and operating elements Operating panel DWELL INPUT MIXER OUTPUT th mann tube reverb MUSIC IS OUR PASSION 14 Connections and operating elements ON OFF Mains switch Turns the device on and off FUSE Fuse ho
Download Pdf Manuals
Related Search