Height Right™Chair
Contents
1. Keeping the Early Pelvic Positioner centered on the seat plate lift front edge of insert 7 Peel off paper to Lower front edge back onto seat plate Adhesive patches will contact wooden seat plate Do not reposition the cushion for 24 hours to allow adhesive to bond Install Small loop strap by sliding long straps through the Smaller loop strap openings Q From the rear of the chair Slide seat plate and Early Pelvic Positioner in 1ST rung above top metal cross bar until Early Pelvic Positioner mates with backrest Wood back amp Insert mate Thread top metal cross bar through hanging loops under Early Pelvic Positioner seat 1 1 Reinstall top metal cross bar using original 12 Install Tray Clips Screws 1 3 Installing Tray and using Clips Attach the Right Tray Clip as shown ZA with 2 Supplied Screws Repeat Top Metal Cross Bar for Left T Primary 13a Spring Lock When Tray is properly installed an audible click will be heard from primary lock b Engage the second safety Latch Lever by pushing it forward into the primary spring lock 1 4 TIGHTEN ALL SCREWS BOTH SIDES IN ORDER 1 5 DO NOT OVER TIGHTEN Back Rest 3 Top Metal Cross Bar 4 NC Bottom a Metal Cross Bar Front Support Back Leg Supports 5 Year Limited Warranty Bergeron by Design warrants to the original retail purchaser of the Height Right Chai2. be ternational 1 315 429 8407 o E P Oo e repaired or replaced at Bergeron by Design s discretion free of charge Warranty service may be performed by an authorized service center or at Bergeron by Design s discretion Fax 1 315 429 8862 61000000 This warranty does not cover normal wear and tear or damage caused by accident or misuse Product Care Clean chair with damp cloth then wipe To exercise this limited warranty the user should first obtain a Return Authorization dry With normal use over time screws Number from Bergeron By Design The product must be delivered charges pre paid UPS recommended to the factory or to an authorized service center together with a copy of the original invoice the Return Authorization Number and a written description of the problem may loosen Please maintain tight screws Use chair on smooth level surface Notice Use only Height Right Chair accessories and parts Height Right Chair parts are not interchangeable with other manufacturers products Replace any worn parts immediately for safety O 2013 Bergeron By Design bapor CE 3 HEIGHT RIG AGES 3 YEARS AND UP EN DARTS En CHAIR Early Pelvic Positioner TRAY NENNEN CONVERSION TO E HEIGHT RIGHT chair Early Pelvic Positioner Tray l FOR CHILDREN UNDER 3 YEARS OF AGE ABLE TO SIT INDEPENDENTLY Amato AWARNING For children under 3 years of age able to sit independently N
3. EVER Use the Tray without the use of the Early Pelvic Positioner Early Pelvic Positioner and Tray sold separately AWARNING Prevent serious injury or death from falls or sliding out AWARNING e Always secure child in the restraint e Never leave child unattended e Always keep child in view e Secure straps tightly e Never use as a stepping Stool e he front edge of the footrest should never extend beyond the bottom edge of the front supports at floor leve e Always use char on smooth level surface AWARNING The child should be secured in the chair at all times by the restraining system The tray is not designed to hold the child in the chair It is recommended that the chair be used only by children capable of sitting upright unassisted The Early Pelvic Positioner is ALWAYS required when using the Tray for children under 3 years of age OPTIONAL Early Pelvic Positioner HEIGHT RIGHT CHAIR 2 long straps pre installed 1 short strap OPTIONAL TRAY WITH COVER CHAIR CONVERSION 1 Loosen Screws 3 Using Allen key Hemove top metal cross bar Fe OR CHILD 4 Place seat plate flat on table gare STD Res ky N Thread restraint straps up through Early Pelvic Positioner Click V 11 S 5 Center Early Pelvic Positioner on Seat Plate A Front lip of Insert will overhang and mate to front edge of seat plate
4. UMHRO3 13LIT HEIGHT RIGHT chair AGES 3 YEARS AND UP EN CHAIR ASSEMBLY ages 3 years and up EN CONVERSION TO CHAIR Early Pelvic Positioner TRAY under 3 years of age Special amp i moto AWARNING J amp TM e E Height Right Chair e Always secure child in the restraint e Never leave child unattended e Always Keep child in view AWARNING The Height Right Chair is a e Secure straps tightly youth chair and is designed for use by children 3 years e Never use as a stepping stool of age and up e he front edge of the footrest snould never AW ARNING EM extend beyond the bottom edge of the front Prevent serious injury or death supports at floor level from falls or sliding out e Always use chair on a smooth level surface A WARN NG the Height Right Chair can be converted to a High Chair with the use of the Early Pelvic Positioner in conjunction with the Tray The Early Pelvic Positioner is ALWAYS required when using the Tray for children under 3 years of age Early Pelvic Positioner and Tray can be Purchased Separately Parts HO TT ji O 2 BACK SUPPORTS Back 2 Back Supports Front Support 2 Metal Cross Bars Allen Key c d a b m i e Oy m SS Foot Rest 8 pcs 4pcs 4pcs 8 pcs 6 pcs Right Left Cap 1 an 2 SUPPORT IS SHORTER HARDWARE a 3pcs d 3pcs e 3pcs Logos this side HARDWARE a 1pcs d 1pcs Ins
5. e appropriate height for the occupant See the Seat and Foot Adjustment section for proper placement of the Seat and Foot Rest IF TOP METAL CROSS BAR IS NOT NECESSARY END WITH 4 Seat and Foot Adjustment 3 Point Belt Operation Height The seat is placed at optimal height when the child s elbows are level with the top of the table The foot plate is placed at optimal height when the child s foot can rest flat on it s surface Lap Strap OI i gt lt 7 Depth For optimal depth of the seat position Crotch child s back against backrest with seat Strap supporting 3 4 of thigh For safety the footrest should not exceed the front legs of the chair o e Place child in seat Crotch strap comes up between child s legs Teen Adult Use Both Lap Straps come around child from the back and Remove Seat Plate amp Top metal cross bar CLICK into Crotch Strap Adjust length of Lap straps to secure child in seat Use the Foot Rest as the Seat Plate for a larger seating surface e Press center button on Crotch Strap buckle to release child from belt TIGHTEN ALL SCREWS 5 Year Limited Warranty Bergeron by Design warrants to the original retail purchaser of the Height Right Customer Service Chair product that if any part or component proves defective in material or Toll Free 1 866 529 8407 Height Right Chair workmanship within five years of the purchase date the defective part will
6. ert a Wood Nut a as shown into the inner holes of the Back Insert a Wooden Dowel e into the larger hole in each of the Back Supports and Front Support Insert a Wood Nut a as shown into the niet holes of Attach the Back as shown and insert a Long Screw d Loosely the 3 Supports Attach the 3 Wooden Supports as shown and insert Long tighten the Long Screw into Wood Nut through the Left Side Screws d Loosely tighten the Long Screws into Wood Nuts through the with the Allen Key Left Side with the Allen Key Labeling on the Rear Supports should be visible d HARDWARE b HARDWARE a 4pcs c 4pcs d 4pcs e 3pcs Insert the rest of the Dowels Wood Attach the 2 Metal Cross Bars Nuts and Screws as needed to as shown and insert Screws c attach the Right Side of the chair Loosely tighten the Screws c into the Metal Cross Bars through DO NOT FULLY TIGHTEN SCREWS Both sides with the Allen Key 5 TIGHTEN ALL SCREWS BOTH SIDES IN 6 Caps ORDER 1 5 DO NOT OVER TIGHTEN Attach Black Caps with 2 small Screws As the child grows x b as shown above Repeat for Left the TOP metal cross 1 e Back Rest bar CAN be removed i HARDWARE b 4pcs Top Metal Cross Bar Bottom Metal Cross Bar Back Leg Supports Front Support Slide in the Seat and Foot Plate with the curved edge facing forward Make sure that the Seat and Foot Rest are at th
7. r product that if any part or component proves defective in material or workmanship within five years of the purchase date the defective part will be repaired or replaced at Bergeron by Design s discretion free of charge Warranty service may be performed by an authorized service center or at Bergeron by Design s discretion This warranty does not cover normal wear and tear or damage caused by accident or misuse To exercise this limited warranty the user should first obtain a Return Authorization Number from Bergeron By Design The product must be delivered charges pre paid UPS recommended to the factory or to an authorized service center together with a copy of the original invoice the Return Authorization Number and a written description of the problem Product Care Clean chair with damp cloth With normal use over time screws may loosen Please check regularly Only use chair on smooth level surface Notice Use only Height Right Chair accessories and parts Height Right Chair parts are not interchangeable with other manufacturers products Replace any worn parts immediately for safety 2013 Bergeron By Design 9 by design CE
Download Pdf Manuals
Related Search