yakima whispbar roof racks k549 fit kit installation instructions help
Contents
1. n K549 ea Fitting Kit a GB Fitting Instructions for Basic Carrier Revision No 1 0 Fitting Kit 549 First Time Installation Remove parts from packaging and check contents Contact your Prorack dealer if parts are missing or damaged a os i a This kit fits type A B C and D These instructions show type A crossbar fitted They also apply to type B C and D T D NOTE Clamp images in these instructions may not be representative of the clamps in this kit Fitting Kit K549 Use keys to remove covers ee Use hex screwdriver to reverse adjusting screw 10 turns Press adjusting screw and pull crossbar legs out Refer to the crossbar instructions for crossbar adjustment Ensure each end of the crossbar is adjusted equally Fitting Kit 549 Remove locking screw Apply protective strip as shown Trim if required Clamp TETA It is important to put the clamps in the correct position on the vehicle Letters refer to the part numbers stamped on T oN clamps O oO Clamp Part Number A 450A B 761A Fitting Kit 549 Attach clamp to each leg NOTE clamps may have labels showing their positions on the vehicle For example Front Right Refit locking screw so that it goes through the hole in the clamp Do not begin to tighten the locking screw Fit rubber pads supplied with fitting kit2. to foot Pad may vary in shape to that shown Fitting Kit K549 Make sure the pad fits into the holes underneath the foot Fitment Place crossbar on vehicle Minimum recommended spacing between the bars is 700mm unless otherwise stated Please check the rear of this manual for information relating specifically to your vehicle Locate vehicle s fixed points Adjust the legs on the crossbar so that they are positioned equally from the ends of the crossbar and the clamps engage firmly on the body work of the vehicle Clamps directly to edge of roof under the doors pin locates in hole on vehicle on front clamps Fitting Kit K549 Tighten adjusting screw to 5 Nm Tighten locking screw on both legs evenly Check crossbar is securely attached to the vehicle Fitting Kit K549 Use keys to fit and lock covers Energising Door Seal Measure doors as shown for starting placement of door seal Repeat for all doors Ensure door seal positioned as shown Fitting Kit 549 Install door seal Check placement CAUTION Recheck all fasteners immediately after a load is applied to the crossbars Regularly check screws are tight
Download Pdf Manuals
Related Search