Owner`s Manual - GreenCupboards
Contents
1. X Treme Electric Scooters X 600 Electric Scooter Owner s Manual PLEASE BE SAFE WHEN RIDING ALWAYS WEAR AHELMET AND OBEY ALL LAWS Pagel d IMPORTANT K BATTERY MAINTENANCE and CHARGING INSTRUCTIONS You MUST charge completely prior to initial use Follow charging instructions in your Product Handbook Charge immediately after each use Charge before storage You must charge every 30 days if not in use Charge the unit for 6 8 hours or until the light on the charger turns red amp green DO NOT allow this unit to deep discharge the battery For safety purposes DO NOT charge for over 24 hours Turn the unit OFF when not in use Failure to follow these INSTRUCTIONS will VOID YOUR WARRANTY This PRODUCT IS NOT INTENDED FOR EXTREME or OFF ROAD Use Please take care of your X 600 DO NOT JUMP or ABUSE THIS PRODUCT DO NOT RIDE IN WET ICY CONDITIONS Failure to follow these instructions will VOID YOUR WARRANTY Page2 IMPORTANT PLEASE READ THIS BEFORE USING THIS PRODUCT READ THIS FIRST WARNING This product does not conform to Federal Motor Vehicle Standards and is not intended for operation on public streets roads or highways Serious injury can result from the unsafe operations of this product Operator can minimize these risks by using certain safety equipment such as safety helmet goggles gloves elbow and kneepads and appropriate footwear DO NOT operat2. DO NOT OVER TIGHTEN OR IT WILL DAMAGE THE BEARINGS ADJUSTING THE CHAIN The chain will come adjusted from the factory However it may be necessary to adjust the chain from time to time The chain must be well aligned onto the sprockets in order to avoid uneven wear This will result in shortened chain life How tight should the chain be m If the chain is skipping or jumping on the sprockets this is too loose and may be harmful m f the chain is making a humming sound when the wheel is turning this is too tight and may cause the chain to snap m The correct tension is achieved by adjusting the chain from its loose position to when it becomes lightly tense Page 12 To tighten the chains Slightly loosen the two axle bolts on both sides of the rear wheel Fig 14 Then slowly adjust the two adjusting screws on each side of the rear tire Fig 15 until chain reaches the proper tension Rotate the rear wheel to make sure the chain is aligned Finally lock and tighten the rear axle bolts prior to riding MAINTENANCE SCHEDULE Proper care of your X Treme X 600 will insure optimal performance and longer life span The following are a few maintenance suggestions that will keep your X Treme X 600 running in top condition Daily Maintenance Perform each time you ride your X 600 Clean the exterior of the unit with a soft damp rag DO NOT WASH WITH A HOSE Check that all nuts and bolts are securely tightened L
3. FUSE INSTALLATION 2 ccc cece eee ee eee ee eee ee eee ee eaten enna 7 8 CHARGING RIDING amp BRAKING 0c eee eee eee eee eee anaes 9 FOLDING AND STORAGE 0c cece cece eee eee eens ence eee e ease anne nena eae 10 BRAKING S VOUE Wi eaieaety till isa ahaa hoa hae cael eel ie een Lal tls 10 PUA Eee ER OU a sree Gainers ate ered a as ha RGN ei ie eae eh Ae Gals 11 MAINTENANGE oiciieccs inte a e EE a E OA A dined eeecdeasee ate 12 13 TROUBLESHOOTING GUIDE siniraan a a E S 14 OTHER OUES TIONS sasra eon E RE 13 GENERAL INFORMATION TECH SUPPORT 0 c ceceeee cent eee ee ee eeeeaes 15 DO NOT RETURN TO STORE Do not use this vehicle for the first time until you have inflated the tires to the correct PSI and completely charged the battery Failure to follow these instructions may damage your vehicle and void your warranty CALL TOLL FREE OR GO ONLINE 1 800 772 3852 www x tremescooters com support For General Information or Parts Visit www x tremescooters com PageS GETTING TO KNOW YOUR X TREME X 600 Variable Speed Throttle X Tre me X 600 Optional Seat Kit Included a Front amp Rear t Hand Brakes Lock and Fold Design for easy Storage ir Brakes F Rear Shocks e Front Shocks Powerful x owerfu Mi 600 Watt Motor Front Disc Brakes g i BF Chain Driven 10 Aluminum heels ee 12 Volt Batteries The X600 Scooter comes with
4. adjustment screw on the front brake assembly located above the front wheel Tighten or loosen as necessary For Further Rear Brake Adjustment 5 Locate the adjustment screw on the rear brake assembly located on the left side of the back wheel Tighten or loosen as necessary The brakes may squeak before they are broken in This is normal and will not affect the function or performance of the brakes With continued use the squeak should go away TIRE PRESSURE The tire must be inflated to a maximum of 50 P S I It is also recommended to use a tube additive like Slime available from any motorcycle shop to avoid inconvenient punctures Empty all air from the tire prior to loosening the bolt to split the rim MAINTENANCE RECOMMENDED TOOLS To adjust and service the X Treme X 600 you will need the following tools E Allen Wrenches 3 4 5 6 mm Pagel1 Wrenches 10 13 13 mm Open end wrench Large Adjustable Crescent Wrench Philips Head Screwdrivers Oil Grease or Lubricant ADJUSTING THE HEAD UNIT The head unit will come adjusted from the factory However riding on rough terrain and general use may cause the head unit to become loose over time It may be necessary to adjust the head unit from time to time To adjust the head unit 1 Rotate the handle bar as far right as it will go to expose the HEAD UNIT see fig left 2 Using a large adjustable wrench gently turn the BEARING LOCK clockwise to tighten
5. gently rotate the THROTTLE GRIP on the right side of the handlebars The X 600 will begin to move on its own power Your scooter has a variable speed hand throttle You can control the speed of your scooter by the amount of pressure you use when rotating the hand throttle The more you rotate the faster you will go STOPPING amp BRAKING 1 To brake release the THROTTLE GRIP and depress the BRAKE LEVERS on the Page9 left right side of the handlebars Depressing the brake will disengage power to the motor When the unit feels like it is loosing power or not accelerating to full speed the scooter is ready to be re charged NOTE If the on off switch is left in the ON position for more than 10 15 minutes without moving Smart Power will shut itself OFF To reset turn the unit OFF wait a few seconds and then switch it back ON again FOLDING amp STORAGE When you are done riding the X 600 you can fold it down for compact storage and transportation First remove the seat post and seat then using one hand push down on the folding handle while gently pushing down on the handlebars BE CAREFUL NOT TO HIT YOUR HEAD WITH THE HANDLEBAR Push down until you feel the mechanism lock into the down position BRAKING SYSTEM The X 600 uses a pinch braking system for the front and a disc caliper system for the rear They are both activated by a hand brake lever on the left and right side of the handlebar Squeezing the hand brake leve
6. Smart Charger Tool Kit and 3 12 Volt Batteries Photo s may vary Page6 PACKAGE CONTENTS Your X Treme X 600 comes with the following items in the box Please locate all of the following X Treme X 600 Scooter 36V Battery Charger Seat Seat Post amp Clamp a ea GETTING STARTED Tool Kit User Manual and 20amp Fuses Please read and understand these instructions and the OPERATING PROCEDURES section prior to starting or riding your X 600 1 2 Page7 Assembly Carefully remove the X 600 from the box To unfold the X 600 begin by pressing down on the FOLDING HANDLE with one hand while gently pulling up on the handlebars with the other Fully extend the handlebars to their upright position until you feel the mechanism lock into place Attach the handlebars by inserting the silver handlebar clamp onto the handlebar post stopping just below the top Be sure to orient the bars in the correct riding position with the throttle on the rider s right side Secure the handlebars to the post by tightening the bolts on the clamp with the enclosed Allen wrench as shown Secure the hand brakes in place by using the provided Allen Wrench to first loosen the tension bolts Adjust the levers to a comfortable position and tighten the bolts BE CAREFUL NOT TO PULL ON THE CABLES Pages Assembly Cont 6 Insert the 20amp fuse by opening the footplate cover as shown Insert the fuse into t
7. e rain and never spray or wash off your scooter with water Do not place the battery near fire or heat To avoid damage to the battery do not use the charger if it has been damaged in any way Keep hands face feet and hair away from all moving parts Do not touch the motor or wheels while they are rotating Brakes are designed to control speed as well as stop the scooter Practice braking for proper slowing down and smooth stops Maintain your X Treme X 600 as recommended in this Product Handbook Use only quality replacement parts as recommended by the manufacturer Inspect the entire scooter prior to each use Replace any part that is cracked chipped or damaged before use NEVER ALLOW CHILDREN TO OPERATE THE SCOOTER WITHOUT ADULT SUPERVISION NEVER ATTEMPT TO OPERATE THE SCOOTER WHILE UNDER THE INFLUENCE OF ALCOHOL If a situation arises that is not covered in the manual proceed with caution and use good judgment Contact your dealer or X Treme www x tremescooters com support if you need further assistance Page4 TABLE OF CONTENTS IMPORTANT HINFOCR MATION 1ciicstenscsatinune E E A 2 3 QUICK REFERENG Es vciiissccnaceluieieseted uel avnormn aie dda shediaa hia aba eaeeheneee 4 TABELE OF CONTENTS rora a a a 5 GETTING TO KNOW YOUR X TREME X 600 0 0 ccceee eens tees tenet eens 6 PACKAGE CONTENTS amp GETTING STARTED 0 cc ceeeeeeeeee ee eee eee 7 GETTING STARTED maneni en a E a E 7 ASSEMBLY
8. e this product in traffic on wet frozen oily or unpaved surfaces or under the influence of drugs and or alcohol Avoid uneven surfaces potholes surface cracks and obstacles DO NOT use a water hose to clean this product See Product Handbook for more information This product is recommended for riders 14 YEARS OF AGE and older SAFETY Persons without excellent vision balance coordination reflex muscle and bone strength and good decision making capabilities should not use this product Minors without adult supervision should not use this product Persons unwilling or unable to take responsibility for their own actions should not use this product The user of this product assumes ALL risks associated with its use To minimize these RISKS the user must wear safety helmet goggles gloves elbow and kneepads and appropriate footwear This product is ELECTRIC DO NOT ride this product in wet conditions puddles or rainy weather Page3 QUICK REFERENCE SAFETY GUIDE SAFETY GUIDE The recommended minimum age for riding this scooter is 14 years old To avoid damage to the motor and footplate do not overload the scooter Never ride with more than one person Inspect your scooter thoroughly before each use for loose or missing parts Avoid unintentional starts by turning the scooter off while not in use To avoid the risk of a short circuit in the electrical parts do not use your X Treme Electric scooter in th
9. he fuse holder then close the footplate cover Attach the seat post to the seat post receiver then attach the clamp to the top of the seat post Pull the upper seat post to the desired position and tighten the clamp securely Attach the seat to the upper seat post and tighten the seat bolts as shown CHARGING Your scooter comes charged out of the carton We still recommend charging the unit for 6 8 hours prior to it s first use We also recommend charging your scooter after each use and prior to storage WARNING Do not allow your scooter to go into deep discharge as this will damage the batteries 1 Make sure unit is turned off 2 Open the charging socket cover located on the right side of the scooter frame under the footplate 3 Locate your Battery Charger Find the charger socket end that has a three prong socket and plug it into the scooter 4 Next plug the AC plug into a wall outlet When first plugged in the charger has one red light that will illuminate at the same time indicating that the charging process has started Once the light on the charger turns red amp green you may remove the charger and close the safety cap RIDING 1 Make sure that all of the exposed bolts and screws are tightened 2 Raise the kickstand to its upright position 3 Push the on off switch located on the left handlebar to the ON position 4 Put one foot on the deck of the X 600 while pushing off with the other foot
10. r with your left hand activates the rear brake Squeezing the hand brake lever with your right hand activates the front brake Make sure to release the HAND THROTTLE GRIP when engaging the brakes Your X 600 is equipped with switches on each brake lever that will disengage power to the motor when the brake levers are depressed Practice braking on a smooth dry surface to get used to the feel of the braking system Braking distance is affected by wet conditions and loose and uneven riding surfaces Adjusting the Brakes The Brakes on the X 600 should come fully adjusted from the factory However it may be necessary to adjust the brakes from time to time To adjust the rear brakes For brakes that are adjusted too loose 1 Adjust the tension screw on the right hand brake lever by rotating it counter clockwise until the wheel spins freely For brakes that are adjusted too tight 2 Tighten the tension screw on the right hand brake lever by rotating it clockwise until the wheel has a slight drag Page1l0 SQUEAKY BRAKES To adjust the front brakes For brakes that are adjusted too loose 3 Adjust the tension screw on the left hand brake lever by rotating it counter clockwise until the wheel spins freely For brakes that are adjusted too tight 4 Tighten the tension screw on the left hand brake lever by rotating it clockwise until the wheel has a slight drag For Further Front Brake Adjustment 4 Locate the
11. rtant phone numbers please go to the X Treme website at www x tremescooters com Thank you for purchasing an X Treme X 600 and please tell your friends how much fun you re having on the X Treme X 600 Page 14 DO NOT RETURN TO STORE IF YOU NEED HELP CALL TOLL FREE OR GO ONLINE 1 800 772 3852 www x tremescooters com support For General Information or Parts Visit www x tremescooters com
12. ubricate the chain with any silicone spray 3 amp 1 oil or any good clean motor oil Check battery charger for any frayed cut wires Page 13 SYMPTONS POTENTIAL CAUSE SOLUTION The charger light turns green amp red right away Batteries do not hold a charge Unit does not have specified travel range Unit moves intermittently or very slow Unit will not move when throttle lever is activated Unit stops abruptly during use This indicates the batteries are adequately charged Bad Fuse or open connection between charger socket and batteries Batteries have reached the end of their useful life Charger is malfunctioning Batteries not fully charged Loose Wire Bad Throttle or controller Batteries not fully charged Brake switches out of adjustment Batteries have reached the end of their useful life Fuse Blown Loose or broken wire Continue to charge the batteries for 6 8 hours prior to initial use Check Fuse Look for loose or disconnected wire Replace Batteries Replace Charger Unit Charge or replace batteries Check for loose wires Replace Replace batteries or charger Loosen brakes Replace batteries Replace Fuse Check for loose or broken wires and repair replace OTHER QUESTIONS For additional questions service instructions further information and impo
Download Pdf Manuals
Related Search