BM300 POWER BUBBLE MACHINE
Contents
1. INVOUC AL BM300 POWER BUBBLE MACHINE USER MANUAL Please read over this manual before operation the machine C Introduction Thank you for choosing this Bubble Machine You now own a rugged and powerful state of the art machine Prior to use we suggest that you carefully read all of the instructions By following the suggestions found in this user manual you can look forward to exceptional performance from your Bubble Machine for years to come Please follow these operation safety and maintenance instructions to ensure along and safe life for your Bubble Machine Specifications Model No BM300 Remote Control Tank Capacity 2 5L Approx Bubble Projection 5meters Weight 14kg Voltage 220 250V 50 60Hz Power 300W Size 45 39 41cm Unpacking amp Inspection Open the shipping carton and check that all equipment necessary to operate the system has arrived intact In addition to the Bubble Machine you should receive the following items 1 This user manual 2 A set of remote control Before beginning initial setup of your Bubble Machine make sure that there is no evident damage caused by transportation Inthe event that the unit s housing or cable is damaged do not plug it in and do Setup 1 Remove all packing materials from the bubble machine not attempt to use it until after contacting your dealer for assistance 2 Place bubble machine on a flat surface 3 Loosen the side screws and lift the housing upward2. s You will see a liquid tank 4 Pour bubble liquid into the liquid tank being careful not to exceed the maximum fluid level Do not overfill 5 When the container is full lower the housing and tighten the screws IMPORTAN SAFETY NOTICE Ensure your bubble machine is unplugged from the mains electrical supply before attempting to open the housing To help avoid accidental exposure to dangerous live AC mains voltage two safety screws are fitted that require a screwdriver to remove Once these are removed the finger screws can be undone by hand Once the screws are removed the lid of the housing can be carefully swung upwards as shown above Take care not to spill any of the bubble fluid inside the unit The fluid tank is designed to fit only one way around Make sure you insert it correctly as shown above with the lower edge facing into the machine Never aim the output at open flames Position output of bubbles away from persons OPERATION Turn on the power switch located on the back of the bubble machine You will notice that the internal bubble drum and fan are activated Bubbles are now produced
Download Pdf Manuals
Related Search