IF Reach DC User Manual
Contents
1. is on left hand side of the handle bar for easy operation When the power is ON there are three different mode of power for selection Battery Pack Removable battery pack allows user to recharge at different locations or replace secondary back up battery Speed Sensor The speed sensor measures the rpm of the rear wheel The controller cuts off the power when the speed reaches 25 km hr Switch operation Press the yellow button to turn on and off the power When power 1 Power and 4 Motor Power System Battery Lock To fix and secure the battery pack Do not leave the key on the keyhole while riding Motor System The motor controller and pedal sensor is all sealed in the same unit is on the motor is in standby mode you will see the orange indicator light on Press the yellow button again to turn off the power When battery status is low the red indicator starts blinking The mode indicator operates in 3 ways Economy mode is the default setting every time when you turn on the power green indicator off Standard mode green indicator on and Turbo mode green indicator blinking Mode Switch Li Mode Switch 0 w Mode Indicator Green IF Reach DC User Manual Power Switch Mode Indicator Orange IF Reach DC User Manual Assembly procedures Unfolding 1 Opening the box 1 an 100 assembled IF Reach 2 seat seat post assembly 3 battery c2. IF Reach DC User Manual Preface Congratulations on the purchase of an exceptional bike from Pacific Cycles These instructions will take you through getting the most out of your new IF Reach dc Read them carefully before using your new bike Introduction IF Reach dc operates like a normal bike when in power off mode With the design of Intelligent Preferred Pedal Activated Power IPPAP the motor of IF Reach dc provides power proportionate to what it senses from pedaling The motor automatically delivers optimized power output when dealing with various road conditions to save battery and optimize mileage IF Reach dc provides three different output modes Economy less power output and least energy consumption Normal output based on pedaling force Turbo maximum output ideal for uphill riding IF Reach dc also features Simple switch the compact switch box fixed on the handlebar can be easily accessed Auto power off mode after 3 minutes of inactivity Auto warning the orange and green indicator will blink when abnormal detected Auto protection The system will power off when 25km h is reached Specification MODEL pF Reach Battery pack Lithium 24V 9Ah Charge time Charge Charge voltage 110 V 240V Battery life 500 charges Motor 250W DC brushless motor with 25km h speed limit Average travel range per full charge ook wi Bike and parts description Power Mode Switch The power and mode switch
3. ace without direct sunlight Keep battery pack out of reach of children When the battery is worn out please recycle do not dispose in fire IF Reach DC User Manual Maintenance 01 02 03 04 05 06 07 08 09 10 11 12 13 O PO FO PXO gt gt O PO PFO gt O O TO PO The orange indicator doesn t light after pressing power button Please check the battery is in correct position and the connector points are clean If the circuit malfunctions the red light will keep blinking Motor not responding while pedaling The speed may exceed the limit This also occurs when riding downhill Or the battery needs recharged Battery renewal The battery normally lasts one to one and half year under normal use The warranty is 1 year Maintenance location Contact your local dealer for warranty terms Can t find the throttle on IF Reach dc With the design of Intelligent Preferred Pedal Activated Power IPPAP the motor of IF Reach dc is controlled to supply power in proportion to that it senses from pedaling Therefore no throttle is required Should I always turn the power on When power is turned on the motor is in standby mode and ready to work when pedaling When it s off the IF Reach dc is just normal bike Noise or smell while riding Please turn off power immediately and safely remove the battery Contact your local dealer The battery is charged for hours but th
4. e indicator doesn t show fully charged The charge cycle of your battery may exceed Please replace a new one If it s still under warranty please send the battery back to your dealer Battery and charger are hot when charging It s normal The temperature is around 40 to 50 Celsius while charging Both battery and charger have sensors which automatically stop charging when temperature is over the range can feel the heat from the motor while riding It s normal The heat is radiating to keep the operation normal The motor is equipped with a temperature sensor to keep from overheating The battery is fully charged but the working hour is short The battery capacity reduces when not using for a long time Set to Turbo mode and riding uphill also rapidly depletes the battery How to make the best of external gear system with the 3 mode motor system When going uphill turn to Turbo mode and shift external to low speed gear will maximize the battery life For long distance travel set Economy mode and shift external to high speed gear How long should I charge the battery At least once a month to prolonged storage Move the battery from the bike if you don t ride the bike for a long time 2010 Pacific Cycles Inc
5. harger b Wa E ENAN aa 2 Begin by raising the handle bars to close the stem 3 Secure the stem hinge by rotating the locking hinge lever toward the stem 4 To unfold the IF Reach insert the seat post into si Move your right hand away from you and then seat tube and clamp place your left hand on the back in a clockwise motion and your left hand handle bar left grip with right hand holding the slightly pushing the frame forward saddle IF Reach DC User Manual N o 6 Use your right palm to push the top tube by the seat 7 Secure the frame together by rotating the frame tube to put the frame into position WARNING locking lever forward and down into the front Never place your hands and fingers inside the connector folding part mechanism 8 Securely lock the locking lever in place by securing 9 Adjust seat tube and clamp Note Do not raise the quick release clamp into the closed position the seat post higher than the minimum insertion mark 10 Lock the battery in position IF Reach DC User Manual Folding 1 Press pedals outer body inward toward frame and 2 While standing on the left side of the bike open the rotate body upward to fold compact quick release lever s a M i 3 With an open hand press the locking lever toward the 4 frame and upward 5 Begin with your left hand on the left handle bar grip and 6 Rock the frame upward with your right hand and pul
6. l the your right hand on the saddle The frame will hinge front backward and together in one motion so the open by pulling your left hand toward you and either wheels meet and the magnet catches pushing away with your right hand or holding the rear in place os TN N 7 Make sure the magnet on both wheels tightly fit 8 To make the bike more compact open the seat post quick release and push the seat post into the frame IF Reach DC User Manual NATE lt a E 9 Fold the handle bar to the side by opening the stem 10 Return the stem locking lever back forward against locking lever Rotate the lever rearward to release the stem when the handle bars are folded CAUTION Never place your hands and fingers inside the following folding part mechanism IF Reach DC User Manual Battery pack IF Reach dc is equipped with 24 volt 9Ah Lithium battery pack Full charge will take 6 hours and an average range can reach 50 km Cycle time is up to 500 charges and weight only 1 7kg per battery pack Stand alone design allows user to recharge freely at any place with separate charger Battery pack removal Electricity level display button Recharge case and pull left directly immediately when one red light is blinking Recharge the battery at least once a month if you are not a frequent user It will maintain battery in its best performance Do not clean the battery with water directly Put it in shade and dry pl
Download Pdf Manuals
Related Search