installation and user instructions refrigerated food display
Contents
1. 5 TECHHICAl 8 10 51 5 55 5 PACK CONLCINS 5 Spare parts 5 6 Connecting to the electricity 6 Operating 7 7 Cleaning and 7 DEVICE INFORMAUON 8 Conditions of 68 8 USE OF FOOD DISPLAY BARS AND PREPARATION BARS The Food Display Bars and Preparation Bars are intended to be used on counter tops to display chilled food products placed in Gastronorm GN containers IS277 ECN2885 Page 3 SAFETY INSTRUCTIONS WARNING Basic safety precautions including the following should be followed to reduce the risk of personal injury Make sure you have read all of these instructions before switching on the unit Keep this User Guide in a safe place for future reference for you and your staff Do not clean the unit with a water jet REMOVAL OF PACKAGING In the interest of hygiene you should clean the product after unpacking and ensure all plastic coatings are removed before use This unit is heav2. AL INSTALLATION AND USER INSTRUCTIONS REFRIGERATED FOOD DISPLAY BARS amp REFRIGERATED FOOD PREPARATION BARS IS277 ECN2885 Dear Customer Thank you for purchasing this Lincat product This is just one of over 300 different items of catering equipment available which is constantly being extended and improved Details are available from your local distributor or direct from us Used for the purposes for which it is intended and with careful maintenance as outlined in this User Guide your Lincat product will give years of trouble free use IMPORTANT INFORMATION Please read all of the safety and operating instructions carefully before using this product Please pay particular attention to all sections of this User Guide that carry warning symbols and notices WARNING This is a Warning symbol This symbol is used throughout the user guide whenever there is a risk of personal injury Ensure that these warnings are read and understood at all times CAUTION This is a Caution symbol This symbol is used throughout the User Guide whenever there is a risk damaging your Lincat product Ensure that these warnings are read and understood at all times sore NOTE This is a Note symbol This symbol is used throughout the User Guide to provide additional information hints and tips IS277 ECN2885 Page 2 CONTENTS Contents Page Safety 4 PFOGUCT 5 S irria
3. extreme temperature conditions If the ambient Operating air temperature exceeds the one shown in the Technical Specification P 5 damage to the refrigeration system could occur The feet must not be removed as this will damage the supply cable and eventually the internal components For safety regulations the plug must always be accessible NOTE Q Leave the product to stand for three hours before connecting to the power supply and switching on CONNECTING TO THE ELECTRICITY SUPPLY 0 Ensure that the voltage of your electricity supply corresponds to the serial plate details The product is supplied with a 13 Amp plug To replace the plug follow these instructions e green and yellow wire to E or Earth e blue wire to N Neutral brown wire to L Live THIS APPLIANCE MUST BE EARTHED IS277 ECN2885 Page 6 OPERATING INSTRUCTIONS Connect the unit to the electricity 4 La supply Switch the unit on green switch insert empty Gastronorm Temperature Display SA H 2 On Off Switch containers with lids and wait until the temperature display shows 2 C At this point introduce your chilled food product Itis good working practice 1 to periodically monitor the food temperature and to use lids on GN containers The unit is not designed for long term storage 3 Cable 4 Filter Position well of the unit not the temperature of the food product
4. NOTE The temperature display relates to the temperature measured in the DEFROSTING The unit is not designed to defrost automatically For best performance you should carry out the following defrosting instructions daily Switch the unit off disconnect from the electricity supply and remove the containers After 30 minutes some water may form in the well Dry with a cloth CLEANING AND MAINTENANCE CLEANING Disconnect the product from the electricity supply before starting to clean Use a mild detergent in hot water and a soft cloth Do not use abrasive creams or scourers Use a suitable polish on the exterior metal surfaces by spraying onto the cloth not directly onto the steel MAINTENANCE It is recommended that a qualified refrigeration service engineer checks this unit annually It should not be necessary to alter the digital controller as it has been factory set Slide out use a soft brush to remove particles and replace Do not place the filter in water For best performance you should clean the filter weekly see Picture 1 IS277 ECN2885 Page 7 SERVICE INFORMATION For help regarding the installation maintenance and use of your Lincat equipment please contact our Service Department 4 01522 875520 All service work other than routine cleaning should be carried out by one of our authorised service agents We cannot accept responsibility for work carried out by other persons To ensure
5. y Take care when moving it GENERAL Do not try to modify this product Ensure that the electrical supply cable is not damaged lf the supply cable is damaged it should be replaced by Lincat Ltd or suitably qualified persons in order to avoid a hazard IS277 ECN2885 Page 4 PRODUCT SPECIFICATION Food Display Bar FDB4 FDB5 FDB6 FDB8 FDB10 Food Preparation Bar FPB5 FPB7 FEATURES Stainless steel body Electronic control Static refrigeration Manual defrost 230V 50Hz single phase TECHNICAL SPECIFICATION Max Operating Model FDB4 FDB5 FDB6 FDB8 FDB10 FPB5 FPB7 als els owls 7 capacity 7 Le 25 25 25 25 25 25 25 Watt 170 170 170 170 170 170 170 mm 1045 1222 1399 1753 2107 1225 1580 mm 375 375 375 375 375 375 375 mm 245 245 245 245 245 262 262 kg 22 24 25 29 32 25 29 litres NA NA NA NA NA NA NA litres NA NA NA NA NA NA NA R134a PACK CONTENTS Refrigerated Food Display Bar or Preparation Bar with cable and 13 Amp plug Glass section or stainless steel lid if ordered with unit User Guide and Guarantee Card SPARE PARTS LIST Component Part no Tangential fan FA51 Condenser G CDO1 ALL FDB amp FPB Compressor G CR10 MODELS Removable filter G F125 Digital stat S E0486 Switch SW67 IS277 ECN2885 Page 5 INSTALLATION 9 Ensure the unit is installed on a sound level surface and not in direct sunlight damp or
6. your call is service enquiry is handled as efficiently as possible you need to have the following details available Brief details of problem Product code type number and serial number of unit both on serial plate Code number of spare part see spare parts list if Known Lincat reserve the right to carry out any work under warranty during normal working hours i e Monday to Friday 8 30 a m 5 30 p m GUARANTEE This unit carries a comprehensive UK twelve month warranty The guarantee is in addition to and does not diminish your statutory or legal rights The guarantee does not cover e Accidental damage misuse or use not in accordance with the instructions in this User Guide or consumable items e Damage due to incorrect installation modification or unauthorised service work The manufacturer disclaims any liability for incidental or consequential damages IS277 ECN2885 Page 8
Download Pdf Manuals
Related Search