User manual
Contents
1. www philips com welcome f you contact Philips you will be asked for the model and serial number of your product The model number and serial number are on the back or bottom of your product Write the numbers here odel No Serial No 3 Your SoundBar Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your SoundBar at www philips com welcome Main unit 4 Standby On e Switch the SoundBar on When the SoundBar is on standby the standby indicator is red 2 SOURCE Select an audio source GB lt Volume Increase or decrease volume LED indicator Blink when a remote control button is pressed Source indicators Light up when the source is selected saind mode indicators DTS Light up when you play a source with DTS e DOLBY D Light up when you play a source with Dolby Digital e DVS Light up when you select DVS mode Remote control 4 Standby On Switch the SoundBar on When the SoundBar is on standby the standby indicator is red Q Seun buttons AUX Switch your audio source to the AUX connection e OPTICAL Switch your audio source to the optical connection e COAXIAL Switch your audio source to the coaxial connection e MP3 LINK Switch your audio source to the MP3 link connection G SURROUND e Switch2. 20 Hz 20 kHz 3dB Signal to noise ratio gt 65 dB CCIR A weighted Input sensitivity e AUX 1 0 V e MP3 LINK 0 5 V S PDIF Digital audio input e _ Coaxial IEC 60958 3 e Optical TOSLINK Power supply 110 240 V 50 60 Hz Power consumption 20 W Standby power consumption lt 1 W mpedance 4 ohm woofer 4 ohm tweeter Speaker drivers 65 mm 2 5 woofer 38 mm 1 5 tweeter Frequency response 150 Hz 20 kHz Dimensions WxHxD 945 x 93 x 58 mm Weight 1 7 kg Subwoofer mpedance 3 ohm Speaker drivers 165 mm 6 5 woofer Frequency response 20 Hz 150 Hz Dimensions WxHxD 123 x 309 x 369 mm Weight 3 81 kg Cable length 4 m Wall Mount Dimensions WxHxD 260 x 40 x 15 mm Weight 0 16 kg PHILIPS 2011 Koninklijke Philips Electronics N V All rights reserved sgptt 1123 05 _v1
3. COAXIAL Connect to the coaxial audio output on a TV or digital device 3 AUDIO IN AUX L R Connect to the analogue audio output on a TV or analogue device Back connector SUBWOOFER 39 SUBWOOFER Connect to the subwoofer 5 Use your SoundBar This section helps you use the SoundBar to play audio from connected devices Before you start Check that you make the necessary connections Play audio from TV or other devices ed 1 mes Press the Source buttons to select the audio output of the connected device Adjust the volume EEE famat i vrs e E BASS voL TREBLE To increase or decrease volume press VOL e The LED indicator on the front panel lights up for five seconds when the volume is set to maximum To mute sound press MUTE L gt The LED indicator on the front panel blink continuously e To restore the sound press MUTE again or press VOL Choose your sound This section helps you choose the ideal sound for your video or music Change treble or bass Change the high frequency treble or low frequency bass settings of the SoundBar to suit your video or music BASS VOL TREBLE Press TREBLE or BASS to increase or decrease treble or bass e The LED indicator on the front panel lights up for five seconds when the treble or bass is set to maximum Change virtual surround m
4. Register your product and get support at www philips com welcome HTS3111 User manual PHILIPS Contents 1 Notice Compliance Mains fuse UK only Trademarks NN ND 2 Important Safety Product care Disposal of your old product and batteries Contact us A A A WW 3 Your SoundBar Main unit Ui UI Remote control 5 4 Connect your SoundBar 7 Connectors N 5 Use your SoundBar Before you start Play audio from TV or other devices Adjust the volume Choose your sound Apply factory settings O oo OO OO 6 Wall mount your SoundBar 9 7 Product specifications 10 1 Notice Compliance C This product is in compliance with the essential requirements and other relevant provisions of Directives 2006 95 EC Low Voltage 2004 108 EC EMC Mains fuse UK only This product is fitted with an approved moulded plug Should it become necessary to replace the mains fuse this must be replaced with a fuse of the same value as indicated on the plug example 10A 1 Remove fuse cover and fuse 2 The replacement fuse must comply with BS 1362 and have the ASTA approval mark If the fuse is lost contact your dealer in order to verify the correct type 3 Refit the fuse cover Note To conform with the EMC directive 2004 108 EC the mains plug on this product must not be detached from the mains cord Trademarks Digital Surround Manufact
5. ode DVS Dolby Virtual Speaker technology creates a highly compelling 5 1 channel listening experience from as few as two speakers Press SURROUND to switch DVS mode or stereo mode L gt n DVS mode the DVS indicator lights up on the top panel Change night mode For quiet listening decrease the volume of loud sounds when you play discs Night mode is only available for Dolby encoded DVD and Blu ray discs Press and hold SURROUND to switch night mode on or off L gt When the night mode is on the indicators dim Apply factory settings You can reset your SoundBar to the default settings programmed at the factory In AUX mode press TREBLE VOL and BASS within three seconds L gt When the restore factory settings process is complete the standby indicator blinks five times Your SoundBar automatically switches off and back on again 6 Wall mount your SoundBar For detailed steps about how to wall mount your SoundBar refer to Quick start guide Note e You can remove the three rubber feet at the bottom of the SoundBar before wall mount e Ifthe rubber feet are removed you cannot place them back again at the bottom of the SoundBar 7 Product specifications Note Specification and design are subject to change without notice Amplifier Audio Main Unit Total output power 100W RMS 30 THD 75W RMS 10 THD Frequency response
6. ontrol may contain a coin type battery which can be swallowed Keep the battery out of reach of children at all times Product care Only use microfiber cloth to clean the product Disposal of your old product and batteries cs Your product is designed and manufactured with high quality materials and components which can be recycled and reused E When this crossed out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002 96 EC Please inform yourself about the local separate collection system for electrical and electronic products Please act according to your local rules and do not dispose of your old products with your normal household waste Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health p54 Your product contains batteries covered by the European Directive 2006 66 EC which cannot be disposed with normal household waste Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health Contact us WN Warning e Risk of electric shock Never remove the casing of the product To keep the warranty valid never try to repair the product yourself f you have problems using this product register your product and get support at
7. ort circuit or fire Before you connect the product to the power outlet ensure that the power voltage matches the value printed on the back or bottom of the product Never connect the product to the power outlet if he voltage is different Risk of injury or damage to the SoundBar For wall mountable products use only the supplied wall mount bracket Secure the wall mount to a wall that can support the combined weight of the product and the wall mount Koninklijke Philips Electronics NV bears no responsibility for improper wall mounting that results in accident injury or damage Never place the product or any objects on power cords or on other electrical equipment If the product is transported in temperatures below 5 C unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet Risk of overheating Never install this product in a confined space Always leave a space of at least four inches around the product for ventilation Ensure curtains or other objects never cover the ventilation slots on the product Risk of contamination Risk of swallowing batteries Danger of explosion if battery is incorrectly replaced Replace only with the same or equivalent type Remove battery if it is exhausted or if the remote control is not to be used for a long time Battery contains chemical substances it should be disposed of properly The product remote c
8. to DVS mode or stereo mode e Press and hold to set night mode 4 TREBLE ncrease or decrease treble VOL ncrease or decrease volume 6 BASS ncrease or decrease bass T MUTE ute or restore volume Replace battery WN Warning e The product remote control may contain a coin type battery which can be swallowed Keep the battery out of reach of children at all times KN Caution e The battery contains perchlorate material handle it with care For information see www dtsc ca gov hazardouswaste perchlorate Open the battery compartment Insert one CR2025 battery with the polarity as indicated Close the battery compartment 4 Connect your SoundBar This section helps you connect your SoundBar to a TV and other devices For information about the basic connections of the SoundBar and accessories see the Quick start guide Note Refer to the type plate at the back or bottom of the product for identification and supply ratings Before you make or change any connections ensure that all devices are disconnected from the power outlet Connectors Side connector 5 MP3 LINK Audio input from an MP3 player Bottom connectors OPTICAL COAXIAL oe DIGITAL wal AUDIO IN 4 DIGITAL IN OPTICAL Connect to the optical audio output on a TV or digital device DIGITAL IN
9. ured under license under U S Patent Hs 5 451 942 5 956 674 5 974 380 5 978 762 6 487 535 amp other U S and worldwide patents issued amp pending DTS and the Symbol are registered trademarks amp DTS Digital Surround and the DTS logos are trademarks of DTS Inc Product includes software DTS Inc All Rights Reserved OQI DOLBY DIGITAL PRO LOGIC I VIRTUAL SPEAKER Dolby Pro Logic and the double D symbol are trademarks of Dolby Laboratories 2 Important Read and understand all instructions before you use your SoundBar If damage is caused by failure to follow instructions the warranty does not apply Safety Risk of electric shock or fire Never expose the product and accessories to rain or water Never place liquid containers such as vases near the product If liquids are spilt on or into the product disconnect it from the power outlet immediately Contact Philips Consumer Care to have the product checked before use Never place the product and accessories near naked flames or other heat sources including direct sunlight Never insert objects into the ventilation slots or other openings on the product Where the mains plug or an appliance coupler is used as the disconnect device the disconnect device shall remain readily operable Disconnect the product from the power outlet before lightning storms When you disconnect the power cord always pull the plug never the cable Risk of sh
Download Pdf Manuals
Related Search