User`s Manual
Contents
1. CONNECTOR m lt 4 o INNER MOTOR iV SHAFT SHAFT lr pect INSTRUCTIONS Cleaning The Rotary Tool may be cleaned most effectively with compressed dry air D Lubrication Do NOT add any grease to the inner shaft anytime Improper lubrication will shorten the life of your tool 3 Motor Brushes Only WECHEER replacement brushes Model 25299 specially designed for your tool should be used After replacing brushes the tool should be run at no load for 5 minutes before loading or using the tool This will allow the brushes to seat properly and will give you more hours of life from each set of brushes Thanks you for purchasing WECHEER professional heavy duty power tool kit Please feel free to contact with your local supplier for our other fine tools and accessories Customer Service for more information contact WECHEER at http www wecheer com2. HEER Multi Use Heavy Duty Power Tool Kit a Models 330 340 Series WECHEER Heavy Duty Power Tool is a recognized and approved system by CSA authority It can be used with hundreds of different rotary tool accessories for grinding sanding polishing cleaning drilling carving shaping and much more This precision designed tool will give you years of trouble free performance with proper use SAFETY RULES 1 Before connecting the tool be sure voltage supplied is the same as that specified on the nameplate of the tool Always make sure your power tool is unplugged when you change accessories or collets Do not touch the bit or collet after use The bit and collet are too hot to be touched by bare hands after use Keep dust out of eyes and lungs by using a protective eyewear or a dust mask Always wear safety goggles when cleaning tools with compressed air Change direction only after the motor has completely stopped reversible motors only to prevent damage to the device and or causing dangers a e wy ASSEMBLY INSTRUCTIONS 1 Inner Shaft Loosen the screw on the connector of the inner shaft then slide it onto the motor shaft Tighten the screw onto the flat in the motor shaft 2 Outer Shaft Tighten the coupler to the motor 3 Handpiece Attach the handpiece by pushing it on the outer shaft Be sure that the tip of the inner shaft is properly lined up with the slot in the rear of the handpiece MOTOR 1 orn
Download Pdf Manuals
Related Search