- abusemark.com
Contents
1. Atromini AMAZE nAw rev3 6 ESC Servo y Headers Default front orientation GND 5V up to 16V Signal Status LEDs Blue Power p Red Green Various B i uzzer signal output connect to buzzer SWD Header o c cnocakav i CT RC channels 5 to 8 for AUX redirect softserial or LED output 1 2 7 mm pitch 2useMar K com bootloader pads short with paperclip ADC5 current sense or RSSI or pitot Battery voltage monitor 1S 6S TX2 UART2 for GPS or Serial RX B GND I2C pads for external SCL E mt devices 3 3V only SDA RX2 RX 3v RX TX GND 5UQ Serial RX Jus JE S e e Spektrum satellite or s bus inverter built in Z PPM RC input Configure Flash serial port Signal 5V GND 3V RX TX GND Note 3V pin must NOT receive 5V If using 5V USB gt Serial Adapter then connect to RX TX GND 5V Board can be powered by 3 3V up to 16V when connected to pads marked 5V or to the servo power pins There is no 5V regulator so high voltage will be passed to receiver as is 3V pad can be used to power Spektrum satellite or some other low current 3 3V device up to 100mA To use buzzer connect 5V to buzzer pin and connect the beep pad to buzzer pin To use battery voltage monitor connect battery to vbat pad To make baro useful cover it with some foam When using Serial RX and choosing s bus receiver inverter will be enabled on RX2 pad The res2. t of configuration is the same as for Naze32 This hardware cannot be used with any DII frames This includes FlameWheel 330 450 550 or any future or past frames released by DJI Using this hardware with anything other than supplied baseflight firmware will immediately make the end user Ineligible for any kind of Support or warranty Designed May 2015 by AbuseMarK
Download Pdf Manuals
Related Search