CP5-Series User Manual
Contents
1. 2 Press the MODE key again The display will flash CAL followed by the calibration weight value see chart 3 Place the calibration weight on the center of the weighing platform Make sure you are using the correct weight for your specific model 4 Once the weight is accepted the display will show PASS then return to normal operation V Error Codes 1 OUTZ Zero range has shifted Perform calibration adjustment If the problem persists the load cell may be permanently damaged due to overloading 2 O Ld Maximum capacity exceeded Remove the extra weight to avoid damaging the load cell 3 UnST Unstable Use in a more stable position DZ4 600 Max Capacity 600g Readability 0 1g Two 2 AAA Batteries Dimensions 3 0 x 3 9 x 0 6 in Platform Dimensions 1 9x 3 5 in Warranty 90 Day Limited Warranty For warranty and support please email warranty digitzscales com2. DZ4 600 Manual I Operation 1 Place the scale on a flat level surface and press the ON OFF key to turn the scale on 2 Once the start up process completes and the scale goes to zero you are ready to weigh 3 Place the quantity to be weighed onto the weighing platform 4 Wait a couple seconds for the display to stabilize before taking a weight reading Il Changing the Unit of Measure 1 Press the MODE key to change the scales displayed unit of measure 2 If the scale is turned off then back on it will default to the last unit used DZ4 600 Units g gram oz ounce ozt troy ounce dwt pennyweight lll Using the Tare Feature You can use this scale s tare feature to subtract the weight of an empty container or vessel for net weight determination NOTE The weight of the container will subtract from the available capacity 1 Place the empty container or vessel on the weighing platform 2 Press the TARE key once The display will then reset to zero If the container is removed it s weight will be displayed as a negative number 3 You may now fill the container with the quantity to be weighed The display will show the net weight of the contents 4 To return to normal weight display gross weight remove any items from the weighing platform and press the TARE key again to re zero the scale IV Calibration Adjustment 1 Press and hold the MODE key until the display shows CAL
Download Pdf Manuals
Related Search