Kestrel Home Series
Contents
1. Qty 1 Infrared Remote Control Part ZSP IR B Qty 2 AA Batteries Radio Frequency Remote Control Part ZSP RF B Low Voltage 3 way Wall Switch Part ZSP WB B IR eye Receiver amp 5 12v trigger cable Part ZSP EYE amp 12V Rev100312 JA www elitescreens com kestrelhome 3 SCREEN OPERATION Setup Remove the controls and wiring from the compartment on the left side of the Kestrel Home Floor Electric Screen as shown in the pictures below Connect the screen to the power supply and switch the power button on Now it is ready for use Power About the Control System 1 5 12V Trigger Input The built in 5 12V trigger input for your new Elite Kestrel Home allows your screen to synchronize its rise and drop with the projectors power cycle The screen rises when the projector powers up and retracts when the projector powers down 2 IR Infrared and RF Radio Frequency The Kestrel Series screen includes both IR and RF receivers that enable the consumer to use either the IR remote control with direct line of sight through the screen s IR receiver window The optional RF remote is best used when the screen is concealed or long distance control is required The RF technology therefore does not require line of sight directly to the screen s IR receiver window Controlling the Kestrel Series with the 5 12V trigger Extended IR eye receiver or 3 way wall box switch not included The following acc2. 3 minutes This is to avoid overload protection shut off If automatic shut off occurs please wait for 20 30 minutes to try again Please visit www elitescreens com should you need to contact us for technical support or service
3. Rev100312 JA www elitescreens com kestrelhome 1 Kestrel Home Series Electric Floor Rising Projection Screen USER S GUIDE IMPORTANT SAFETY NOTES 1 Please read this manual before use and follow the procedures specified a Please retain this manual for future reference b To avoid any damages to the screen do not use any accessories or parts not recommended by Elite Screens c Handle the device carefully during transportation d Do not set up screen on uneven surfaces e To prevent electrical shock or fire never over load the power cord and avoid contacting the motorized components with liquids or foreign objects 2 The tubular motor equipped in the Kestrel Home series features an overheat protection sensor If the screen is consecutively brought up and down between 3 4 minutes the motor will automatically shut off to prevent the motor from sustaining damage through overheating If the automatic shutoff is activated please allow 30 minutes cool down before resuming operation 3 The Kestrel Home Series is equipped with a strong tension cross spring system Please do not attempt any unnecessary repairs It is at your own risk to open the inside cover or dismantle work on the screen Individual modifications to this product are prohibited and will void the user s warranty 4 When using the screen please a Avoid strong wind rain or electrical storms b No direct sunshine UV Radiation or mois
4. essories are not included with your Kestrel Home screen but can be purchases separately Keep this information in a safe place should you decide to obtain these accessories in the future 1 5 12V Trigger Connect the 5 12 volt trigger cable to your projector s trigger output via a separate cable that may or may not be provided by the projector manufacture The trigger feature will not work without an output cable from the projector but it can be tested using a 9 volt battery by simply connecting the Red and Green cable to the 9 volt battery ON OFF IR receiver window Rev100312 JA www elitescreens com kestrelhome 4 2 IR Eye Receiver The IR eye receiver cable provides an extension of the IR sensor should the IR receiver window on the Kestrel s screen is concealed 3 3 w ay wall switch box The 3 way wall switch box allows manual control to operate the screen s UP STOP DOWN commands The RJ 45 input jack is located on the left side compartment which accepts the 5 12V trigger extended IR eye receiver or the 3 way wall switch box Storing the screen Always store the screen flat horizontally Never store the screen in a vertical position Screen Maintenance 1 Always close the screen when not in use 2 Do not touch the screen surface 3 Keep away from direct sun and high low temperatures 4 For indoor use only 5 Clean with soft water 6 Do not drop close screen consecutively for more than
5. ture c Keep away from fire sources and high temperature devices d Turn off t he power before moving this product Keep away from children Keep hands clear from the closing panels Rev100312 JA www elitescreens com kestrelhome 2 NOTE This equipment has been tested and found to comply with the limit s for a Class B digital device pursuant to Part 15 of the FCC Guidelines The products are designed to provide reasonable protection against harmful interference in a residential commercial installation and end user application and may radiate radio frequency energy However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures 1 The power outlet should be close to the unit and easily accessible 2 Re orient or relocate the receiving antenna 3 Increase the separation between the equipment and the receiver 4 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected 5 Consult t he dealer or an experienced radio TV technician f or additional help Kestrel Home Standard Accessory Kestrel Optional Accessories Available for purchase at www shop elitescreens com or your preferred reseller
Download Pdf Manuals
Related Search