Encoder Simulator V1.1 OC Web
Contents
1. and 10KHz DIR Selects Output mode between CW CCW OFF NPN Open Collector Output 5V 24V External Pull Up Resistors Simulator External pullup resistors may require Typical resistor 2 2K 3 3K2. Encoder Simulator Open Collector Output WWW PLCTOOLS COM SPECIFICATION 24V DC 15 40mA max load dependent Power Supply Current Consumption Output Frequency A B 10Hz 100 HZ 1KHz 10KHz Period Z 2500 pulses A B Accuracy at 25 C 2 Encoder Output Isolation None Output Protection None Encoder Signal Output Open Collector model Encoder Signals ABZ Output Type NPN Open Collector Voltage 5V 30V Max Output Current 100mA per channel Operating Temperature 10 45 C Note All signals referenced to the GND terminal and Common of the external power supply Currently the device does not carry any agency approvals and is not compliant with RoHS The Encoder Simulator was developed to assist integrators in application development and troubleshooting for projects with High Speed Counters and Flow Meters It generates high accuracy square wave signals similar to the incremental encoders and flow meters Encoder simulator uses an advanced microcontroller that allows to simulate encoder frequencies up to 10KHz in both directions Frequency selection performed using FREQ pushbutton Output frequencies are 10Hz 100Hz 1KHz and 10KHz Frequency selection is available in any output mode and while output is OFF Output Mode selected by the DIR pushbutton Selections are OFF steady LED CW LED blinking once CCW LED blinking twice Extra 24V and Com terminals can be used to connect Common R
3. eturn wires and pull up resistors if necessary DISCLAIMER This device is intended to provide general assistance with application development and debugging and can t be permanently used in live production systems Accordingly production system must be tested and commissioned with real encoders and signals to ensure safe and reliable operation IN NO EVENT SHALL THE DEVICE MANUFACTURER BE LIABLE FOR ANY DAMAGES OF ANY KIND INCLUDING DIRECT INDIRECT INCIDENTAL CONSEQUENTIAL LOSS OF PROFIT OR DAMAGE The examples and diagrams in this manual are included for illustrative purposes only Because of the many variables and requirements associated with any particular installation the device manufacturer cannot assume responsibility or liability for actual use based on the examples and diagrams Before making any decision or taking any action that might affect your equipment you should consult a qualified professional advisor BA DANGER 380 Encoder Simulator Signals A Encoder Output Channel A B Encoder Output Channel B Z Encoder Output Channel Z Com External PS Common 24V External 24V PS Positive All signals referenced to the Com terminal and Common of the power supply LED Indicator LED Solid ON Indicates selected frequency Output is OFF LED Blinking Output is On in CW direction Once LED Blinking Output is On in CCW direction Twice Pushbuttons FREQ Changes output frequency between 10Hz 100Hz 1KHz
Download Pdf Manuals
Related Search