Home Series - Primo Water Store
Contents
1. Position bottle glass pitcher or cooking pot below spout 2 Slide red button away from you and depress control downward to start water flow 3 Release control once desired fill level is achieved MAINTENANCE For best taste performance and hygiene clean the cold tank at least every 3 months and your cabinet controls and spout each time you change your water bottle Empty and clean drip tray as needed To minimize mineral deposits use only high quality purified bottled water such as Primo For instructions and videos for maintaining your dispenser please visit http store primowater com SpecialPages CustomerCare aspx LIMITED WARRANTY Primo Water Corporation Vendor warrants to the original purchaser of this dispenser and to no other person that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it then for a period of one 1 year from the date of purchase all parts in such dispenser shall be free from defects in material and workmanship Vendor may require reasonable proof of your date of purchase from an authorized retailer or distributor Therefore you should retain your sales slip or invoice The Limited Warranty shall be limited to repair or replacement of parts which prove defective under normal use and service and which Vendor shall determine in its reasonable discretion upon examination to be defective Before returning any parts you should contact Vendor2. s Customer Care Department using the contact information listed below If Vendor confirms after examination a defect covered by this Limited Warranty in any returned part and if Vendor approves claim Vendor will replace such defective part without charge If you return defective parts transportation charges must be prepaid by you Vendor will return replacement parts to original purchaser freight or postage prepaid The Limited Warranty does not cover any failures or operating difficulties due to accident abuse misuse alteration misapplication improper installation or improper maintenance or service by you or any third party or failure to perform normal and routine maintenance on the dispenser as set out in the User s Manual In addition the Limited Warranty does not cover damages to the finish such as scratches dents discoloration or rust after purchase The Limited Warranty is in lieu of all other express warranties Vendor disclaims all warranties for products that are purchased from seller other than authorized retailers or distributors AFTER THE PERIOD OF THE ONE 1 YEAR EXPRESS WARRANTY VENDOR DISCLAIMS ANY AND ALL IMPLIED WARRANTIES INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE FURTHER VENDOR SHALL HAVE NO LIABILITY WHATSOEVER TO PURCHASER OR ANY THIRD PARTY FOR ANY SPECIAL INDIRECT PUNITIVE INCIDENTAL OR CONSEQUENTAL DAMAGES Vendor assumes no responsibi
3. sure red switch on back of dispenser is ON Nightlight Isn t Working Not on All Models Make sure the power cord is properly connected to a working outlet Make sure nightlight switch on back of dispenser is ON Dispenser Is Noisy Make sure the dispenser is positioned on a level surface PN 0 075 2012 Primo Water Corporation
4. IMPORTANT Do Not Return Dispenser to Store If you have questions or issues please contact 1 866 429 7566 for expert assistance os l PRIMO Home Series Spill Proof Water Dispensers A WARNING TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE USER MUST READ THIS MANUAL BEFORE ASSEMBLING INSTALLING amp OPERATING DISPENSER SAVE THIS MANUAL FOR FUTURE USE This Home Series water dispenser has been designed and manufactured to provide dependable and safe service if installed set up operated and maintained as directed Follow all instructions in the order provided SET UP All hardware is included Set up requires a Phillips screwdriver not included Locate Dispenser Notice Do NOT plug power cord into wall outlet until instructed 1 Place dispenser upright 2 Locate dispenser on a hard and level surface in a cool shaded location near a ground fault interrupting receptacle 3 Position dispenser so the back is at least 4 inches from wall and there are at least 4 inches of clearance on both sides Install Bracket CAUTION Dispenser must be securely anchored to wall as shown to prevent accidental tip hazard 1 Clip bracket onto back right corner of dispenser as shown in illustration 2 Install plastic anchor directly into sheet rock using a Philips screwdriver DO NOT d
5. ind center spout will light If you do not want a nightlight leave switch in off position bottom side pushed in Register at Club Primo While you wait for the water to get to the desired temperatures please register your dispenser This will be helpful should you need customer service assistance in the future Go to www PrimoWater com and click on Club Primo OPERATION This Home Series water dispenser has been tested and sanitized prior to packing and shipping During transit dust and odors can accumulate in the tank and lines Dispense and dispose at least one quart of water prior to drinking any water 1 l L q q q q q q N N q N q q q q N N q N q q q q q q q N q q q q q q q q q q q q q N q N q q q q N q N q q q q N q N q q q q q N i q q q q q q N q N q q q q q N q q N q q q q q N q N q q q q q q N q q q q q q N N q q q q q q N P l l 1 i 1 1 l l l l 1 I I i l l l l L 1 i 1 l l l l 1 I I L l l l l 1 i I 1 l l l l I 1 I 1 l l l l 1 i 1 i l l l l 1 I 1 1 l l l l L L I 1 l l l l 1 1 I 1 l l l l 1 1 1 1 l l l l 1 I 1 I l l l l 1 1 L 1 l l l l 1 1 I L l l l l L WARNINGS amp SAFETY PRECAUTIONS To reduce risk of injury and property damage user must read this entire guide before assembling installing amp
6. lectric shock do NOT immerse cord plug or any other part of dispenser in water or other liquids Ensure dispenser is unplugged prior to cleaning Never allow children to dispense hot water without proper and direct supervision Unplug unit to prevent unsupervised use by children Do not dispense hot water if water bottle is empty Service should be performed only by a certified technician Please contact us at 866 429 7566 for assistance Dispensing Cold Water After setup it will take 1 hour to get water to maximum cold temperature During this time the compressor will run continuously This is normal 1 Position bottle glass pitcher or cooking pot below spout 2 Depress cold water control dark blue downward to start water flow 3 Release control once desired fill level is achieved Dispensing Cool Water Not on All Models 1 Position bottle glass pitcher or cooking pot below spout 2 Depress cool water control light blue downward to start water flow 3 Release control once desired fill level is achieved Dispensing Hot Water Not on All Models CAUTION This unit dispenses water at temperatures that can cause severe burns Avoid direct contact with hot water Keep children and pets away from unit while dispensing Never allow children to dispense hot water without proper and direct supervision Unplug unit to prevent unsupervised use by children After setup hot water will be available in 15 20 minutes 1
7. lity for any defects caused by third parties This Limited Warranty gives the purchaser specific legal rights a purchaser may have other rights depending upon where he or she lives Some jurisdictions do not allow exclusion or limitation of special incidental or consequential damages or limitations on how long a warranty lasts so the above exclusion and limitations may not apply to you Primo Water Corporation 104 Cambridge Plaza Drive Winston Salem NC 27104 www PrimoWater com TROUBLESHOOTING Water is leaking Bottle may have a leak that is too large for the Leak Guard feature to stop Remove bottle dispense one quart of water and install new bottle If leak remains remove bottle and call 866 429 7566 for assistance No water is coming from the spout Make sure the bottle is not empty If empty replace it Make sure to push the water controls in fully Cold water is not cold It takes up to one hour after setup to dispense cold water Make sure the power cord is properly connected to a working outlet Make sure the back of the dispenser is at least 4 inches from a wall and there is free airflow on all 4 sides of the dispenser Make sure green switch on back of dispenser is ON If water still isn t cold please call 866 429 7566 for assistance Hot water is not hot Not on All Models It takes 15 20 minutes after setup to dispense hot water Make sure the power cord is properly connected to a working outlet Make
8. n Use when cleaning Caution Water can flow at extremely high temperatures Failure to use properly can cause personal injury 11 Plug amp Cord Only plug into a ground fault interrupting receptacle Install Water Bottle Bottle not included Requires standard 3 4 or 5 gallon water dispenser bottles Visit www PrimoWater com to find Primo Water at a store near you 1 Remove tamper seal from top of bottle cap Do NOT remove plastic cap 2 Clean bottle cap and neck with a cloth and warm soapy water then rinse 3 Lift bottle and insert onto the probe Apply slight pressure until the plug inside the cap pushes in and the bottle is seated Water will begin to flow into the reservoirs causing air bubbles in the bottle Provide Electricity Plug cord into a ground fault interrupting receptacle Activate Cold Switch Notice This unit will not dispense cold water until the switch is activated To activate push top side of the green switch in to start cooling water If you do not want cold water leave switch in off position bottom side pushed in Activate Hot Switch Not on All Models Notice This unit will not dispense hot water until the switch is activated To activate push top side of the red switch in to start heating water If you do not want hot water leave switch in off position bottom side pushed in Activate Nightlight Not on All Models To activate push top side of the blue switch in The LED bulb beh
9. operating dispenser Failure to execute the instructions in this manual can cause personal injury or property damage Models that heat water dispense at very high temperatures Failure to use properly can cause personal injury When operating this dispenser always exercise basic safety precautions including the following e Prior to use this dispenser must be properly assembled and installed in accordance with this manual This dispenser is intended for water dispensing only Do NOT use other liquids Do NOT use for other purposes Never use any other liquid in the dispenser other than known and microbiologically safe bottled water For indoor use only Keep water dispenser in a dry place away from direct sunlight Do NOT use outdoors Install and use only on a hard flat and level surface Do NOT place dispenser into an enclosed space or cabinet Do NOT operate dispenser in the presence of explosive fumes Position back of dispenser no closer than 4 inches from wall and permit free airflow between wall and dispenser There must be at least 4 inches clearance on the sides of the dispenser to permit airflow The dispenser is intended to be plugged into a ground fault interrupting receptacle Do not use an extension cord with your water dispenser Always grasp plug and pull straight out from outlet Never unplug by pulling on power cord Do NOT use dispenser if cord becomes frayed or otherwise damaged To protect against e
10. rill hole into sheet rock first when using this anchor 3 Secure by installing screw through bracket and into the anchor Note Remove screw to free dispenser for cleaning or relocating Install Drip Tray amp Grid 1 Remove drip tray and grid from protective packaging 2 Slide drip tray assembly into position until it is secure Join Club Primo at PrimoWater com for more useful information instructional videos tips and special offers FEATURES amp FUNCTIONS Front 1 Spill Proof Bottle Receptacle with Leak Guard For fast easy spill proof loading Reduces leaks from worn amp damaged bottles 2 Water Dispensing Controls Depress to dispense 3 Function Lights Not on All Models Green light below snowflake indicates dispenser is cooling water Green light below wavy lines indicates dispenser is heating water 4 Spout s Amount vary by model Water dispenses here 5 Bottle Support s Not on All Models Helps align sports bottles and glasses with spout s to eliminate spills 6 LED Nightlight Not on All Models Located behind bottle support s Helps in low light situations 7 Drip Tray Dishwasher safe Slides in and out Red float rises to top to inform you it is time to empty the tray Back oe Activation Switch for Cooling Green 9 Activation Switch for Heating Red Not on All Models 10 Activation Switch for LED Nightlight Blue Not on All Models 11 Hot Tank Drai
Download Pdf Manuals
Related Search