the electronic version of the updated User Manual by
Contents
1. Power Indicators e 4 blue LEDs indicating battery capacity each indicating 25 of capacity e red LED indicating wireless charging 11 Charging Modes e Wired and wireless charging up to two devices at the same time e Recharging power bank wired or wireless charging disabled e Pass through charging 12 Dimension Length Width Height e Device 6in x 2 87in x 0 49in 153mm x 73mm x 12 5 mm e Packaging 6 5in x 3 94in x lin 180mm x 144mm x 25 mm 13 Weight 10 90z 310g 14 Portability Easy to carry with travel bag or laptop bag or to use in cars2. reach of small children to prevent danger Always comply with regulations for battery disposal to avoid causing explosion and or pollution Do not use damaged power cords or plugs or loose electrical sockets Recharge using only standard 5V USB chargers such as wall chargers car chargers or computer USB ports If you use an incompatible adapter the built in battery may not be charged fully or be damaged Use only Qi standard conforming wireless receivers to connect with the transmitting terminal Please stop using power bank immediately if it bulges leaks or smells During charging or recharging the battery may increase its temperature due to internal resistance Thus the battery may feel warm when the charge is complete This is normal 5 Operating Instructions 1 Turning On and Off e To turn on the device quick press the power button The device enters standby mode and the blue LEDs will be on In the standby mode the device will turn off automatically within 5 minutes when not charging To turn on the wireless transmitter press and hold the power button for three seconds until the red LED is on When the red LED is on press and hold the power button for three seconds to turn off the wireless transmitter and the red LED will be off 2 Recharging Power Bank Connect the micro USB connector of a USB cable included into the input port and connect the other end of the cable into a USB charger not included Blu
3. MobilePal 8000mAh and 10000mAh Wireless Power Bank User Manual Thank you for selecting the MobilePal Wireless Power Bank Before operating please read this manual carefully and follow the instructions to operate properly 1 General Information This device is a carefully designed wireless charger and portable power bank It provides you convenience of wireless charging at home or in your office It also serves as portable backup power on the go for your smartphones tablets digital cameras MP3 MP4 players and other electronic devices 2 Feature Overview 1 Integrated Qi wireless charging transmitter for wirelessly charging all devices conforming to the Qi charging standard It can also be used as a wireless charging pad or charging station in the pass through mode 2 Integrated high capacity rechargeable lithium polymer battery at 3 7V 8000mAh or 10000mAh capacity as labeled on the device 3 Simultaneous wireless charging via Qi transmitter and wired charging via USB cables 4 Intelligent charging to prevent overcharging 3 I O Ports Buttons and Indicators 1 Micro USB Input 5V DC 1A USB1 Output SV DC 1A i USB2 Output 5V DC 2 1A LED indicators blue and red Power button Center of wireless transmitter a a ee 4 Safety Information and Precautions i 10 11 12 13 14 15 16 17 Keep your device dry Humidity and liquid may damage your device Store and charge your devic
4. USB1 1A jack to charge a device USB2 is disabled due to insufficient current Pass Through Wireless Charging While the power bank is connected to a USB charger press and hold the power button so that only the red LED is on Place a mobile device on top of the power bank and align the center of its wireless receiver with that of the wireless transmitter within 2 cm 0 6 inch 6 Troubleshooting 1 If only one blue LED light is on or flashing after the power button is turned on the battery is running low Please recharge the power bank 2 This product can automatically identify a Qi device on the wireless terminal If no device is on it the wireless charger will power off within 5 minutes automatically 3 If the center of the receiving terminal deviates from the center of wireless transmitter by more than 20mm 0 8in the wireless charger will power off automatically The larger the deviation the lower the charging efficiency becomes 4 If the transmitting terminal detects that the wireless charging current is too high it will automatically disable the output ports to prevent damage Remove and then reposition the wireless receiver on the charging pad to restart charging 5 If the device detects the overall current of wire and or wireless charging is over the rated current it will disable the output ports automatically You must remove some devices being charged to reduce the current to within the rated limit and then restart char
5. e LEDs will flash one by one When fully charged all blue LED lights will be on By default the wireless transmitter and the output USB jacks are disabled To turn on the wireless transmitter while the power bank is connected to a USB charger press and hold the power button until the red LED is on Now wireless transmitter and output USB1 1A are enabled and battery recharging and output USB2 are disabled 3 Charging Other Electronic Devices Wired Charging with Built in Battery Quick press the power button to enter standby mode and blue LEDs will be on Connect the USB connector of a USB cable into either the USB1 1A or USB2 2 1A output jack and connect the other end of the cable into the electronic device to be charged One of the blue LEDs will flash during charging Each glowing or flashing blue LED indicates 25 of the battery capacity Wireless Charging with Built in Battery Press and hold the power button for three seconds until the red LED is on and the wireless transmitter is then enabled Place a mobile device on top of the power bank and align the center of its wireless receiver with that of the wireless transmitter within 2 cm 0 6 inch One of the blue LEDs will flash during charging Each glowing or flashing blue LED indicates 25 of the battery capacity Pass Through Wired Charging While the power bank is connected to a USB charger press and hold the power button so that only the red LED is on You can now use the
6. e in cool and ventilated place Do not touch the device if your hands or feet are wet Never dispose the battery in water to avoid causing internal short circuit over heating smoking fire deformation or even explosion of the battery Do not store or charge your device in very hot or very cold areas Extreme temperatures can damage the device and reduce the charging capacity of the battery It is recommended to use your device at temperatures from 41 to 95 degrees Fahrenheit 5 to 35 degrees Celsius Never dispose the battery or device in fire Never place the battery or device on or in heating devices such as microwave ovens stoves or radiators The battery may leak and your device may explode when overheated Do not expose your device to direct sunlight for an extended period of time Do not use your device outdoor during a thunderstorm Never crush puncture disassemble or modify the device as this can damage the device or cause fire or explosion Avoid exposing the battery to high external pressure which can lead to an internal short circuit and overheating Do not store your device together with metal objects such as coins keys and necklaces Do not short circuit the battery Doing so may cause electric shock or fire and the battery may malfunction or explode Do not store your device near strong magnetic fields Your device may malfunction or the battery may discharge from exposure to magnetic fields Keep batteries out of
7. ging by pressing the power button 7 Warranty Information The manufacturer warrants this device is free from defects in material and workmanship under normal use and service for twelve 12 months commencing upon the date of purchase by the first consumer purchaser Proof of purchase is required for warranty claims The consumer should never attempt to open or disassemble the device and doing so may cause damage that voids your warranty This warranty does not apply to devices purchased from unauthorized dealers During the warranty period manufacturer will at its sole discretion repair or replace any defective devices Repaired or replaced devices will be warranted for a period equal to the remainder of the original Limited Warranty on the original device or for ninety 90 days whichever is longer The customer is responsible for the shipping cost to the repair center and the manufacturer will cover the cost to ship to the customer 8 Packaging List e Wireless power bank 1 piece e USB cable 1 piece micro USB or 2 in 1 lightning micro USB e User Manual 1 piece 9 Technical Specifications 1 Capacity 38000mAh or 10000mAh as labeled on device at 3 7V 2 Input 4 8 5 2V DC 1A 3 USBI Output SV DC 1A 4 USB2 Output SV DC 2 1A 5 Wireless Output SW 6 Charging Frequency 100 200KHz 7 Wireless Distance 1 10mm 8 Qi Compatibility Compatible with all products conforming to the Qi standard 9 Efficiency gt 70 10
Download Pdf Manuals
Related Search