User Manual
Contents
1. P Slide it onto and along the track of left and right side of the housing unit the front of the combs firmly sits against the clipper blade Comb position Short comb Long comb Imm length is achieved without any combs To remove the comb gt Holding the clipper with the blades facing away from you firmly push the comb upward and away from the blades gt The comb attachment is marked accordingly on its outside middle surface 3 21 mm amp 24 42mm e INSTRUCTIONS FOR HAIR CUTTING Note For even cutting allow the comb attachment blade to cut its way through the hair Do not force it through quickly If you are cutting for the first time start with the maxi mum comb attachment STEP 1 Nape of the neck PICTURE Set the comb attachment to 3mm or 6mm gt Hold the clipper with the blade teeth pointing upwards Begin starting at the centre of the head at the base of the neck gt Slowly lift the clipper working upwards and outwards through the hair trimming just a little at a time STEP 2 Back of the head PICTURE 2 gt With the comb attachment set on 12mm or 18mm cut the hair at the back of the head STEP 3 Side of the head PICTURE 3 Set the comb attachment to 3mm or 6mm guide to trim sideburns Then change the setting to 9mm and continue to cut to the top of the head STEP 4 Top of the head PICTURE 4 Use the longer length comb attachment and set it to 24mm or 27mm then cut hair2. grease from the blades It is not necessary to remove the small moving blade from the unit gt If the moving blade has been removed this can be re fitted by slotting the coated blade holder over the pin in the centre of the interior product head The groove on the coated blade just below the teeth rests on a metal plate at the opposite side to the screw holes The fixed blade is fitted with the raised profile pointing outwards and fixed with the 2 screws Note that if the blades are not correctly aligned then cutting efficiency will be impaired P Place a few drops of cutter or sewing machine oil onto the blades Wipe off excess oil CAUTION Do not use liquid cleaners on the blades or harsh or corrosive chemicals on the blade casing Always use a soft brush to remove the accumulated hairs Unplug the charge adaptor from the power outlet when fitting or removing attachments or while cleaning the product Always store this appliance and cord in a moisture free area Do not wrap the cord of the charging adaptor around the appliance w gt e IMPORTANT SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF BURNS ELECTROCUTION FIRE OR INJURY TO PERSONS An appliance should never be left unattended when plugged into a power outlet Keep the power plug and cord away from heated surfaces Make sure the power plug and cord do not get wet Do not plug or unplug the product with wet hands Do not use t
3. on top of the head against the direction in which the hair normally grows P For longer hair on top use the longer length comb attachment 24 42mm to achieve desired style Always work from the back of the head STEP 5 The finishing touches PICTURE 5 gt Use the clipper without an attachment comb for close trimming around the base and sides of the neck Use the ear comb guides to get a clean line around each ear For the required ear comb guide angle the clipper and lightly stroke around each ear to the back of the neck gt To produce a clean straight line at the sideburns reverse the hair clipper Place the reversed clipper at right angles to the head tips of the blades lightly touching the skin and then work downwards SHORT TAPERED STYLES FLAT TOPS amp SHORT CUTS gt Starting with the longest comb attached 24mm 42 cut from the back of the neck to the crown Hold the guide comb flat against the head and slowly move the clipper through the hair as shown PICTURE 1 Use the same procedure from the lower side to the upper side of the head as illustrated Then cut the hair against the direction in which it grows and level with the sides PICTURE 3 To give a flat top look the hair on top of the head must be cut over the top of a flat comb Usea closer guide comb to taper the hair down to the neckline as desired e ENGLISH CARE FOR YOUR HAIRCLIPPER Your clipper is fitted with high qu
4. Model No HC5150 10 UK HC5150 Version 03 10 Part No T22 29458 REMINGTON is a Registered Trade Mark of Spectrum Brands Inc or one of its subsidiaries VARTA Consumer Batteries GmbH amp Co KGaA Alfred Krupp Str 9 73479 Ellwangen Germany www remington europe com 2010 SBI eS C x e E U e E e S W o gt Nn i 21 E o D a o Uu o a 9 c o o 9 lt PN RS REMINGTON PRO POWER HAIR CLIPPER 1 VIN REMINGTON 1 REMINGTON SERVICE HOTLINE United Kingdom 44 0800 212 438 free call Rayovac Europe Ltd Watermans House Kingsbury Crescent The Causeway Staines Middlesex TWI8 3BA UNITED KINGDOM www remington co uk Thank you for choosing Remington Our products are designed to meet the highest standard of quality functionality and design We hope you enjoy using your new Remington product Please read the instructions for use carefully and keep in a safe place for future reference CAUTION Use this appliance only for its intended use as described in this manual Do not use attachments not recommended by Remington Do not use this product if it is not working correctly if it has been dropped or damaged or dropped into water DESCRIPTION I On Off switch 2 Blade set 3 2 attachment guide combs 4 Charging ind
5. ality blades To ensure long lasting performance of your clipper clean the blades and unit regularly Always keep the attachement guide comb on the trimmer blade AFTER EACH USE Ensure the clipper is switched off and disconnected from the mains gt Brush the accumulated hair from the blades Do not submerge the clipper in water clean the unit wipe with a damp cloth and dry immediately Gently brush the remaining hairs away from the trimmer comb and trimmer blade Do not rinse the cutter assembly under water Note Ensure that the clipper is turned off when cleaning CLEANING CAUTIONS Only the adjustable trimmer comb and cutter assembly may be removed from the trimmer for cleaning Cleaning should only be done with a soft brush such as the brush supplied with the product Only use the light grade oil supplied or sewing machine oil on the blades Do not use harsh or corrosive cleaners on the units or their cutters Do not apply pressure or hard objects to cutters Do not disassemble cutter assembly gt Do not submerge in water as damage will occur e Note Ensure that the hair clipper is turned off when cleaning EVERY SIX MONTHS At regular intervals the Blade Set should be removed and cleaned Remove the 2 screws retaining the fixed blade with a screwdriver Do not remove blade set gt Brush out hairs from between the blades with soft cleaning brush Do not remove the lubricating
6. he product with a damaged cord A replacement can be obtained via the nearest Remington Service Centre Charge use and store the product at a temperature between 15 and 35 C Always unplug from the mains when cleaning Only use the parts supplied with the appliance The trimmer is not washable If it falls into water ensure the power outlet is switched off before removing Keep this product out of reach of children The use of this appliance by persons with reduced physical sensory or mental capabilities or lack of experience and knowledge can give cause to hazards Persons responsible for their safety should give explicit instructions or supervise the use of the appliance vvvvv v vvv PROTECT THE ENVIRONMENT SO Niem gt The product contains a Nickel Metal Hydride cell unit Do not dispose the trimmer in household waste at the end of its useful life Disposal can take place at our service centres or appropriate collection sites CAUTION Do not put in fire or mutilate your battery packs as they may burst or release toxic materials j mmm For further information on recycling see www remington europe com ENGLISH BATTERY REMOVAL P The battery must be removed from the appliance before it is scrapped gt The appliance must be disconnected from the supply mains when removing the battery gt Ensure the clipper is discharged of all power and disconnected from the mains gt Lif
7. icator light 5 Charging adaptor GETTING STARTED CHARGING YOUR HAIRCLIPPER Before using your hair clipper for the first time charge for 14 16 hours Ensure the product is switched off gt Connect the charging adaptor to the product and then to the mains gt When the cord is connected to the mains the charging indicator light will light up Your clipper cannot be overcharged However if the product is not going to be used for an extended period time 2 3 months unplug it from the mains and store Fully recharge your hairclipper when you would like to use it again To preserve the life of your batteries let them run out every six months then recharge for 14 16 hours ENGLISH CORDED USE gt Connect the charging adaptor to the product and then to the mains When the cord is connected to the mains the charging indicator light will light up CAUTION Extended mains only use will result in the reduction of the battery life CORDLESS USE gt When the unit is switched on and fully charged the product will provide you with a usage time of 30 minutes which will decrease during usage HOW TO USE Before starting the cut gt Inspect the clipper making sure that it is free from hair and dirt gt Seat the person so that their head is approximately at your eye level Before cutting always comb the hair so it is tangle free and dry To attach a comb gt Hold the comb with its teeth upward
8. t or pry the screw cover and unscrew screw located on the back housing of the clipper gt Life or pry the clipper halves apart exposing the battery on the printed circuit board gt Cut the tabs on both ends of the battery and remove it from the printed circuit board gt The battery is to be disposed of safety SERVICE amp WARRANTY This product has been checked and is free of defects We warrant this product against any e defects that are due to faulty material or workmanship for a 2 year period from the original date of consumer purchase If the product should become defective within the warranty period we will repair any such defect or elect to replace the product or any part of it without charge provided there is proof of purchase This does not mean an extension of the warranty period In the case of a warranty simply call the Remington Service Center in your region This warranty is offered over and above your normal statutory rights The warranty shall apply in all countries in which our product was sold via an authorised dealer This warranty does not include cutters which are consumable parts Also not covered is damage to the product by accident or misuse abuse alteration to the product or use incon sistent with the technical and or safety instructions required This warranty shall not apply if the product has been dismantled or repaired by a person not authorised by us
Download Pdf Manuals
Related Search