Vacuum Sealer Instruction Manual
Contents
1. Vacuum Sealer Instruction Manual Model CD204 A Safety Tips e Position on a flat stable surface e A service agent qualified technician should carry out installation and any repairs if required Do not remove any components on this product e Consult Local and National Standards to comply with the following o Health and Safety at Work Legislation o Fire Precautions o IEE Wiring Regulations o Building Regulations e DO NOT immerse the appliance in water e The sealing bar becomes hot during use DO NOT touch the sealing bar during or immediately after operation e Do not turn Off at the plug to halt operation always use the Stop Start button e Do not use the appliance for anything other than its intended use e Only use bags recommended by the supplier manufacturer with the appliance e Always switch off and disconnect the power supply to the appliance when not in use e Not suitable for outdoor use e Keep all packaging away from children Dispose of the packaging in accordance to the regulations of local authorities e If the power cord is damaged it must be replaced by a APURO agent or a recommended qualified technician in order to avoid a hazard e This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their2. bag not placed above sealing bar Move end of bag over sealing bar Technical Specification Vacuum Dimensions Voltage Current Pressure h x w x d mm approx CD204 A A 230V 50Hz 110W 711mBar 97 5 x 390 x 160 MEN Electrical Wiring The plug is to be connected to a suitable mains socket This appliance is wired as follows e Live wire coloured brown to terminal marked L e Neutral wire coloured blue to terminal marked N e Earth wire coloured green yellow to terminal marked E This appliance must be earthed using a dedicated earthing circuit If in doubt consult a qualified electrician Electrical isolation points must be kept clear of any obstructions In the event of any emergency disconnection being required they must be readily accessible Compliance The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste To help prevent possible harm to human health and or the environment the product must be disposed of in an approved and environmentally safe recycling process For further information on how to dispose of this product correctly contact the product supplier or the local authority responsible for waste disposal in your area APURO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international independent and federal authorities APURO products have been approved to carry the
3. following symbol All rights reserved No part of these instructions may be produced or transmitted in any form or by any means electronic mechanical photocopying recording or otherwise without the prior written permission of APURO Every effort is made to ensure all details are correct at the time of going to press however APURO reserve the right to change specifications without notice DECLARATION OF CONFORMITY Equipment Type Vacuum Packing Machine Model CD204 A Legislation C Tick AS NZ 3820 Essential Safety Requirements for Low Voltage Electrical Equipment Standards AS NZS CISPR 14 1 2013 AS NZS 60335 1 2010 IEC 60335 2 45 A1 2008 A2 2011 Producer Name Apuro Producer Address 15 Badgally Road Campbelltown NSW 2560 I the undersigned hereby declare that the equipment specified above conforms to the above Legislation and Standard s Date 30 10 14 Signature i anu Full Name Richard Cromwell Position Commercial Director CD204 A_V2
4. safety e Children should be supervised to ensure that they do not play with the appliance Introduction Please take a few moments to carefully read through this manual Correct maintenance and operation of this machine will provide the best possible performance from your APURO product Pack Contents The following is included e APURO Vacuum Pack Machine e Instruction Manual APURO prides itself on quality and service ensuring that at the time of packaging the contents are supplied fully functional and free of damage Should you find any damage as a result of transit please contact your APURO dealer immediately Telephone Helpline 1300 225960 Controls and Features Machine Lid Accessory Port Seal Rubber Upper Seal Gasket Seal Wire Chamber Room Down Seal Gasket Control Panel Operation The Vacuum Sealer automatically comes on when plugged in indicator light will turn green The Vacuum Sealer is now ready for use Vacuum Packing Food 1 a CES O T 8 Place the food inside in the bag and remove any excess liquid or food residue Allow minimum of 25mm 50mm of space at the top of bag to ensure a good seal Place the open end of the bag across the Sealing Strip keeping opening within the chamber ring and close lid Press Vac amp Seal button Indicator light will turn on Vacuum pump will engage until required vacuum level is achieved Machine will automatically go into
5. seal mode Pulse function can be used if not requiring full vacuum of bag i e for delicate items that may be damaged Pressing pulse button until desired vacuum result is achieved Press Seal button to seal bag When sealing is complete lid will raise slightly Remove bag and inspect bag and seal Note A good seal will look clear upon inspection If the seal is spotty incomplete wrinkled white or milky remove sealed portion and run vacuum and seal process again 9 To abort process press Cancel button Extended Seal time Seal time can be extended by pressing the extended seal button This may be necessary if using thick vacuum bags or using in a cold environment Cleaning Care amp Maintenance e Always allow to cool before cleaning e Use warm soapy water and a damp cloth to clean the appliance e Dry thoroughly after cleaning e A APURO dealer or qualified technician should carry out repairs if required WARNING Do not allow any water to spill into the appliance when cleaning Telephone Helpline 1300 225960 Troubleshooting The unit is not working The Unit is not switched on Check the unit is plugged in correctly and switched on Appliance does not remove all the air from the Bags are not sealing correctly Moisture in bag under the sealing bar Ensure inside of the bag is dry and free from moisture where it is to be sealed Incorrect bags used Call Vacuum Pack machine supplier End of
Download Pdf Manuals
Related Search