FSA 4.0 User`s Manual 2nd Edition
Contents
1. 20 FSA 4 0 User s Manual 2nd Edition 3 3 3 Installing the FSA USB Drivers Hardware software requirements Minimum operating system requirements to use USB are Windows 98 with all updates and patches from the Windows Update site Windows ME Windows 2000 Windows XP Windows 95 and Windows NT are not USB capable Text in brackets applies to the FSA USB Autocalibrator only FSA 4 0 starting at version 196 should automatically install the USB drivers for you along with the software installation if you are installing off of the CD If there is some sort of security setting or unknown Windows glitch that does not allow this to occur you will need to follow the instructions on this page If you get to step 4 below and no Windows Found New hardware bubble pops up your drivers are likely already installed Windows XP 1 Connect your LI6 FSA USB A B cable to an available USB port on your computer 2 Connect your LI6 FSA USB A B cable to your FSA Interface Module or FSA USB Autocalibrator 3 Connect your ACC1010 or ACC2020 FSA Interface Power Supply or ACC 7020 ACC 7021 power supply if installing an FSA USBAutocalibrator to your interface module or Autocalibrator and to a power source 4 A Found New Hardware bubble will appear in the lower right corner of your screen with the message Found New Hardware USB lt gt Serial The bubble will disappear and the Windows Found New Hardware Wizard will appear2. Follow the on screen instructions as follows 5 Insert your FSA software CD into your CD Drive typically D Click Next 6 The Wizard will search your drives and the internet if you are connected for the required drivers and should find the required files on your FSA software CD Do not install the drivers from the manufacturers FTDI website you want the version 1 0 2154 0 drivers Click Next 7 Wait while the Wizard installs the drivers then click Finish 8 The Found New Hardware bubble then the Found New HardwareWizard will appear again to install the USB Serial Port driver Repeat step 6 and 7 above for the USB Serial Port driver You will see another Found New Hardware bubble indicating that your device is ready to use You can now run your FSA device system through the USB port you installed to Windows 98 Windows 2000 similar 1 Connect the LI6 USB cable to your FSA module then to the USB port on your computer 2 Connect your LI6 FSA USB A B cable to your FSA Interface Module or FSA Autocalibrator 3 A New Hardware Found USB lt gt Serial window will appear and another window with a progress bar Windows 98 telling you windows is building a driver information base The Windows Add New Hardware Wizard will appear next 4 Insert the FSA software CD into your CD Drive typically D Click Next 5 The What do you want Windows to do window appears Leave the defau
3. lt Search for the best drivers for your device Recommended selected and click Next 6 De select Floppy Drives Windows Update and Specify a location leaving just the CD Rom option selected Next 7 Windows will search the FSA software CD for the drivers The next windows should indicate that Windows has found the best driver Click Next 8 Please wait while Windows copies the file to your hard drive 9 Click Finish in the window that follows 10 The New Hardware Found USB Serial Port message will appear Repeat above steps 5 through 9 for this device 2006 Verg Inc
Download Pdf Manuals
Related Search