RAD-ZIPI Manual
Contents
1. DOUG FLEENOR DESIGN 805 481 9599 Remote Address Device w ZIPI model RAD ZIPI Operation Manual The RAD ZIPI is a hand held battery powered device which can test and set the DMX address for Altman Spectra PAR and the Color Kinetics Color Blast fixtures Power The RAD is powered by a standard 9 volt battery The battery can be changed by removing the back cover Power is turned on or off using the slide switch To set a fixtures address The RAD ZIPI is connected to the DMX input of the power supply which is driving the fixtures Doug Fleenor Design power supplies must be set to 000 ONLY fixtures to be set should be connected All fixtures connected to the power supply will be set to the new address when the RAD ZIPI SET button is pressed Turning the RAD ZIPI on After connecting the RAD ZIPI to the power supply s DMX input turn on the RAD ZIPI by using the slide switch on the bottom The display will show ZIP briefly It will then show 001 Setting a DMX address Set the desired DMX starting address for the fixture using the buttons located below each digit of the display The fixture will accept values from 1 510 inclusive When the display shows the desired DMX address push the SET button on the RAD ZIPI The fixture s red LED s will turn on followed by a number of brief flashes The programming takes about 3 seconds After the programming is complete the power to the fixture may need to be cycled Testing a fixtu2. re Test the fixture by press the TEST button on the RAD ZIPI The address displayed on the RAD ZIP will be tested The fixture should flash red green blue continuously The address being tested may be changed while the test is in progress The RAD ZIPIs display digits chase during the testing operation to show that you are in the test mode The test mode is exited by pushing the TEST button again or by pushing the SET button Note that pressing the SET button will cause the test to stop and the RAD Z P will begin programming the fixture to the address shown on the display Power saver feature If the RAD ZIPIis left on and is not in test mode it will go into a power save mode after about 30 seconds of inactivity A segment of the center digit s display will blink in this mode To exit the power save mode press any button once This will cause the RAD Z P to resume normal operation The keystroke used to get out of power save mode will be ignored talc Doug Fleenor Design Inc 396 Corbett Canyon Road ESTA Arroyo Grande CA 93420 805 481 9599 voice and FAX z 888 4 DMX512 toll free 888 436 9512 EE web site http www dfd com ENTERTAINMENT SERVICES amp e mail info dfd com TECHNOLOGY ASSOCIATION
Download Pdf Manuals
Related Search