User Manual
Contents
1. K2 Top amp Bottom Bags Load the full blood filled bag system in the centrifuge buckets Caution Proper positioning of the bags will prevent burst of the bags during centrifugation 1 2 Centrifuge at 2500 g for 15 minues under 4 C Caution Centrifuge settings may vary according to the centrifuge brand used 3 Place the centrifuged bag to the blood component extractor 4 Continue plasma separation as is identified in the separator using manual 5 6 7 Break the break off part at the opening of the bag by turning left and right Figure 6 Separator device automatically transfers plasma into the transfer bag and redcells into the SAG M bag Seal the tubes after the separation and remove from the set PROTECTION 1 Place the red blood cells immediately at 1 6 C in a blood bank refrigerator which is designed for this purpose 2 Store the plasma in the freezer 3 Ifthe separation takes place within 6 hours after collection it can bestored at 18 C 25 C for 3 months 30 C 40 C for 6 months and at lower temperatures for 12 months TRANSFUSION 1 Inspect the container and blood for any defects 2 Before transfusing the blood make sure that serological test results are acceptable cross match test results match with the recipient If appropriate apply cross match again at bed side Use transfusion set compatible with ISO EN 1135 4 Hold the top part of the T port with one hand and bag2. 2 Squeeze the transfer bag with hands until the air flows into main bag When air bleeding finishes open the clamp again Wait until the blood is filtered and transferred to the transfer bag k After the filtration is completed close the tube connected to the bag from under the Y port Figure 5 No 3 Figure 5 a with tube sealing device Filtration time is averagely 15 minutes at controlled room temperature Caution Do not use the product if the filtration time is less than 5 minutes kt kk 4 58690 Rev 1 Issue Date 27 08 2014 Page 1 2 CAPA NO 125 14 COMPONENT SEPARATION Classic Bags 1 Load the full blood filled bag system in the centrifuge buckets Caution Proper positioning of the bags will prevent burst of the bags during centrifugation Centrifuge at 2500 g for 15 mins under 4 C UYARI Centrifuge settings may vary according to the centrifuge brand Place the centrifuged bag to the blood bag extractor Continue plasma separation as is identified in the separator using manual Break the break off part at the opening of the bag by turning left and right Figure 6 Transfer the plasma into the transfer bag If SAG M bag is used break the break off part of the SAG M Bag and add the SAG M solution to the primary bag over Red Cells Seal the redcells bag tube for cross match In pediatric bags transfer bags are connected to redcells bag until they are finished et ON Se ea
3. 15 Loosen the tourniquet or deflate the pressure cuff ae 16 When blood taking is done to remove the needle hold the hub with one hand between the thumb and index finger while the other hand holding the sterile gauze and pull Ur the hub without exerting pressure completely Let the donor keep sterile gauze on the point of entry of the needle into vein TO 17 Hold the needle with one hand as the tip stay at the upper position wait for flowing off the blood to bag in the blood taking tube 3X AT 18 The clamp on the tube to the bag is closed after that step Put a knot on the systems without sampling bag CAUTION When the needle is locked if the clamp is not SA ae closed there is a risk of blood flushing from the needle safety cover 19 For the blood bag systems with needle safety cover while holding the needle with one hand hold the needle safety cover with the other one than leave the needle pull the Figure 4 needle to the safety cover by pulling the tube under the safety cover and be sure that it is locked Figure 3 No 6 CAUTION To prevent accidental injuries or contamination of the personnel insert the needle into the locked system or throw it to the medical waste 20 The blood taking tube is closed from under the Y port with tube sealing device and the needle is removed from the system Caution Throw locked needle kit to the medical waste 21 Strip donor tubing as completely as possible into bag starting at seal Work quickly to preven
4. Ckansux BLOOD BAGS USER INSTRUCTIONS C 4 1008 BLOOD BAG SYSTEMS WITH WHOLE BLOOD FILTER DESCRIPTION For Leukodepleted Whole Blood or Red cells and Plasma collection separation and storage of human blood components INDICATIONS See Guide to the preparation use and quality assurance of Blood Components GENERAL PREPARATIONS BEFORE USAGE 1 Open the outer wrap at the tear notches and remove one blood bag system 2 Apply blood pressure cuff or tourniquet on donor s arm identify venipuncture site and release the cuff or tourniquet 3 Disinfect the venipuncture site Cover the area with sterilized gauze strip and do not touch until the time of venipuncture CAUTION Beware of iodine sensitive donors 4 Before venipuncture inspect the blood bag system tubing and needle for visual defects and discoloration 5 Signs on the needle protector and hub should be the in the same line Apply some pressure to determine any leakages 6 Place the collection bag below the level of donor s arm 4 7 The anticoagulant and additive solutions should be checked for containing appropriate volume color or particule contaminants CAUTION While opening the blood bag system blood taking tube should be held from needle protector not from the needle safety cover Pay attention not to lock the needle safety cover before collection of blood by mistake USER INSTRUCTIONS 9 BLOOD COLLECTION IF SAMPLING BAG SYSTEM IS USED FOLLOW NUMBER 1 4 IF NOT CO
5. NTINUE WITH NUMBER 5 1 Before the needle protector is uncapped close the clamp on the line connected to collection bag If the bag system has a breakaway part there is no need to close 3 1 the clamp 2 Break the break away part on the tube to the sampling bag holder Figure 1 No 2 Figure 2 No 3 3 Follow the following steps according to the sampling bag system a Tubing System i Blood samples sampling tubes are inserted into the tube holder and necessary blood is taken Figure 1 No 3 ii CAUTION Take the samples to bigger tubes first Figure 1 Figure 2 iii The clamp on the tubing to the bag is opened and blood taking starts Figure 1 No 1 b Sampling Bag System i Take blood to the sampling bag Figure 2 No 5 ii The clamp on the tubing to the sampling bag is closed Figure 2 No 2 iii The clamp on the tubing to the bag is opened and blood taking starts Figure 2 No 1 iv Sampling bag is placed in palm in a position of sampling bag tube holder is to be stayed below Sample tubes are inserted in tube holder connected to 6 the sampling bag and sufficient blood sample is taken Figure 2 No 4 CAUTION Sample blood in the sampling bag should immediately transferred to the tubes otherwise they get coagulated NOTE After sampling break the breakaway part on the tubing to collection bag for the systems with donor line breakaway 4 The tube with the tube holder is hanged on to donor s wrist in a way not to compress the n
6. eedle continue with number 9 5 Ifthe blod bag system does not have a sampling bag samling port put a temporary clamp or knot to blood taking tube 6 Reapply tourniquet or inflate blood pressure cuff until previously selected vein is prominent again 7 Hold the needle from marked side To remove the needle cap twist to break the seal between the needle and its cap and remove it by sliding it down the axis of the needle CAUTION Bu sure not to touch the cannula 8 Apply the venipuncture immediately Venipuncture is very important for a non coagulated blood 9 Strap the needle to the donor s arm 10 Mix blood and anticoagulant gently and periodically approximately in every 45 seconds during collection If a mixer or a collection system is used please refer to their c operator s manual 11 Make sure there is continuous blood flow If there is continuous adequate blood flow and constant agitation blood collection is expected to be completed under 12 minutes CAUTION If it s above 12 minutes collected blood may not be suitable for Platelets Fresh Frozen Plasma or Cryoprecipitate AHF Figure 3 12 Collect the quantity of blood within the limits indicated on the bag label Monitor the blood being drawn 13 After blood collection is finished blood collection mixer collects the desired blood and stops the collection by clamping the blood collection tube 14 Stop the blood taking and agitating device and after opening the clamp of the device
7. f there is visible sign of deterioration on the bags Protect the bag and tubing from sharp objects Do not use if needle protector is opened Bars on the needle should be in the same line Figure 8 Do not recap the opened needles Do not use if fluid path closures are loose and not intact 10 Do not vent 11 Store blood between 1 6 C 12 Do not add medication to blood 13 Cross match the contents of the bag with recipient before transfusion 14 Use transfusion sets in compliance with ISO EN 1135 4 15 Mix thorougly before use and if necessary store under controlled conditions to achieve the appropriate temperature When frozen plastic is more fragile After usage Single use only Throw to medical waster after use Caution In case of reuse there is infection risk OC HONDAARWNE Figure 8 CAUTION This medical device contains di 2 etilhekzil ftalat DEHP Considering the animal data s precautions should be taken to restrict to be a subject of DEHP especially for certain patients affected on their reproduction and development processes These patients are newborn boys infants and children prepubertal boys and pregnant and nursing mothers Please check out the updated literature to give a conscious decision KANSUK LABORATUARI SANAYI VE TICARET AS Eski Londra asfalt Be yol Mah No 4 34295 Sefak y STANBUL T RK YE Tel 90 212 592 15 76 Faks 90 212 580 37 72 www kansuk com e mail kansuk kan
8. from the bottom part of T port with other hand and twist of the upper part by 270 Figure 7 Keep holding the bag from T port remove the cap of the transfusion spike with other hand Insert the spike by 4 of its length into outlet port Do not touch the spike of the transfusion set and open outlet port to prevent contamination After inserting the spike squeeze the bag to the level that transfusion set filter is filled with blood Hook the bag from its holder Sy gee GENERAL CAUTIONS During storage and transportation 1 During shipment up to two blood bags shippers shall be carried at the same time manually or on a trolley Parcels should not be dropped and or crushed and should be loaded in a way to prevent fall over 2 Inthe warehouse up to seven parcels can be stored on top of each other and in a way to prevent fall over Before opening overwrap 3 Store the overwrapped bags at clean dry and cool places 4 Do not use if there is visible sign of deterioration on the overwraps 5 Blood bags are packed with sterilized After opening overwrap 6 Store the bags in their outer wraps at clean dry and cool places 7 Bags should be used within 10 days after removal of the transparent overwrap Before usage Figure 7 Store the closed overwraps at clean dry and cool places Intended for human blood and blood components Sterile and non pyrogenic Steam sterilization Do not use unless solutions are clear Do not use i
9. suk com kt kk 4 58690 Rev 1 Issue Date 27 08 2014 Page 2 2 CAPA NO 125 14
10. t the blood from clotting in the tubing Invert bag several times to mix thoroughly then allow tubing to refill with anticoagulated blood from the bag Repeat this procedure twice Figure 4 22 For cross match purposes seal the tubing attached to the collection bag into segments leaving a segment number clearly and completely readable The closest segment number to the o euna bag should always remain attached to the bag for identification 2 23 Check the blood bag again for any faults 24 Make sure all the donor information required is filled out on the label of the blood bag 25 Immediately after collection whole blood should be placed at 1 6 C in a blood bank refrigerator which is designed for this purpose do not cool the blood but wait under 20 24 C for a min of 1 hour with 45 angle For gaining fresh freezed plasma and platelets finish all the steps within 8 hours after collection FILTRATION ae a SS xN 9 If platelets will be separated Keep Collected blood standing for 2 hours before filtration The main bag filled with blood is hung up to the Filter Hanger which is 150 cm height from the ground Mix the bag gently Break the breakaway part at the Main bag Figure 5 No 1 The blood is filled in the transfer bag by passing through filter by means of the gravity force Remove the air in the transfer bag After the filtration of 90 amount of blood In order to do this close the clamp under the filter Figure 5 No
Download Pdf Manuals
Related Search