User manual
Contents
1. ADJUSTABLE COMBS e This hair clipper has a detachable comb with various measurements Hair cut length varies between 4 16mm of hair length amount of hair that will be cut e To attach the comb hold it with its teeth upward and slide it along the sides of the hair clipper until the comb firmly adjusts onto the sides and you hear the click sound e Toremove the comb simply pull the comb upward and away from the clipper OIL e To maintain your clipper in peak condition the blades should be oiled every few haircuts Do not use hair oil grease oil mixed with kerosene or anv solvent CUTTING LENGTH amp CONTROL WHEEL e The control wheel allows you to gradually change the closeness of your haircut by changing the position of the comb e 4 levels exist on the control wheel Each level is a different hair cut level that range between 4 16mm Control Wheel Level Hair Cut Length mm 1 4 2 7 3 10 4 16 CHARGING THE BATTERY Before using the SY HC32 for the first time it must be fully discharged and then fully charged 1 Ensure the on off switch is downwards 2 Insert the plug of the mains adaptor into the power jack of the hair clipper 3 Plug the mains adaptor into a power socket NOTE The indicator light will not go out when the battery is fully charged e lt takes approximately 8 hours to charge the battery After this time the clipper must be detached from the adaptor to avoid battery degradation and over heating2. IOVTEGH BRAAS Ob UK AC Hair Clipper SY HC32 Instructions Manual WELCOME Thank you for purchasing the new hair clipper SY HC32 In order to benefit fully from this product please read the following instructions carefully Store the instructions manual in a safe place for future reference IMPORTANT SAFEGUARDS Before the first use of the appliance check that the voltage indicated on the rating label corresponds to the mains voltage in vour home For home use oniv Do not use for industrial purposes Do not use the appliance for any other purposes than described in this instruction manual Do not use outdoors Always unplug the appliance from the power supply before cleaning and when not in use To prevent risk of electric shock and fire do not immerse the appliance in water or any other liquids However if this does occur DO NOT TOUCH the appliance unplug it immediately and contact your near service center Do not take this product to a bathroom or use near water Do not immerse the recharging stand or adaptor in water Never charge the unit near water This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety Children should be supervised to ensure that they do not play with the ap
3. e The usage time with a completely charged battery is approx 50 mins USING THE CLIPPER WHILE CHARGING To use the SY HC32 without the battery being charged is also possible Connect the adaptor to a wall outlet and to the hair clipper 1 Connect the hair trimmer as described in the section Charging the battery 2 Unplug the adaptor after use INSTRUCTIONS FOR HAIR CUTTING BEFORE STARTING THE HAIR CUT e Check the clipper making sure that there is no oil between the cutting blade teeth Turn the unit on to distribute the oil and to make sure it is running smoothly before using Wipe off any excess oil This should be done before each use e Seat the person so the head is approximately at the eye level This allows ease of visibility while cutting and a better control of the clipper Place a towel around the neck and shoulders of the person getting the haircut Before cutting always comb the hair so it is tangle free REMINDERS Cut the hair in an even and slow manner Use short strokes only and work gradually over the entire head Always take off a little hair at a time you can always trim off additional hair later As you work comb the hair frequently back into the style to which you are cutting When cutting with this hair clipper it is better to leave the hair dry not wet With dry hair it is much easier to control the amount of the hair being cut Cutting hair requires practice so it is always better to leave the hair
4. longer for the first few haircuts until you become used to the hair clipper levels and how much hair does each level cut BLADES CLEANING AND MAINTENANCE Before cleaning and maintaining this hair clipper please ensure that the switch is disconnected and that no water is present around the area where you are cleaning the unit Remove the adjustable comb by simply pulling it upwards Pull the shaving head towards the back and remove it 1 Using the brush brush out all the extra hairs from the shaving head insert the area behind the shaving head when it has been removed 2 Put 2 3 drops of oil on the blades Reinsert the shaving head by inserting the latch of shaving head into the casing and press it until you hear a click sound 3 BLADE LIFE This hair clipper is equipped with stainless steel blades It provides high sharpness and a longer life span of the blades If your clipper stops cutting your cutting blades have worn out Replace them with new blades Blade life will vary according to the frequency and length of use STORAGE Keep the appliance in a dry place The blades must be oiled during storage period SPECIFICATIONS Rechargeable Hair clipper Stainless Steel blades Water resistant IPX6 5 haircut settings 4 7 10 13 16mm Direct Drive Use your trimmer through AC current or internal rechargeable battery Charger stand included Powerful and silent motor LED indicator pilot 50 min
5. pliance Do not leave the appliance switched on when not in use Do not use other attachments than those supplied Do not operate after any malfunction cord damage battery leak charging stand damage or adaptor damage Do not attempt to repair adjust or replace any parts of the appliance Check and repair any damages by contacting Sytech Service Center Keep the cord away from sharp edges and hot surfaces Do not place or store the appliance where it can fall or be pulled into a tub or sink Do not pull twist or wrap the power cord around the appliance Never insert any objects into the openings of the appliance Before use make sure that blades are adjusted properly Do not place the appliance while it is operating on any surface it may cause injury or damage Do not use the appliance with a damaged comb or with teeth missing from the blades as injury may occur NOTE KEEP THE BLADES OILED Do not use the hair clipper when the skin is infected Do not use the hair clipper on animals The manufacturer reserves the right to introduce minor changes into the product design without prior notice unless such changes influence significantly the product safety performance and functions PARTS OF THE SV HC32 1 Cutting head Adjustable comb Cutting length Control wheel On off switch Light indicator Charging stand Adaptor Oil bottle Cleaning brush 10 Socket 11 Adjustable comb lever ON OONOO RF
6. utes usage when fully charged Complete charge in 8 Hours Accessories included Charger stand comb scissors brush oil bottle Power source AC 239V 50Hz DC 3 8V 300mA DECLARATION OF CONFORMITV Manufacturer Name Satvatrade S L Address Pol Ind La Raya C Guadalguivir 2 Camarma de Esteruelas 28816 Madrid Tel 902 430 967 Fax 91 8864285 NIF B83254763 Manufacturing countrv China sytech SY HC32 complies with the following directives EMC Standard Directive 2004 108 EC EN 55014 1 2003 EN 55014 2 1997 A1 2001 EN 61000 3 2 2006 EN 31000 3 3 1995 A1 2001 A2 2005 ROHS standard 2002 95 EC Restriction of Hazardous Substance Signed Ajeet Nebhwani Utamchandani Sole Administrator
Download Pdf Manuals
Related Search