MIL-STD-461F Test Kit 399295 - ETS
Contents
1. SETS LINDGREN Sonn An ESCO Technologies Company MIL STD 461F Test Kit Safety Information The ETS Lindgren MIL STD 461F Test Kit is for use with the Model 3301C Active Monopole Antenna and complies with the MIL STD 461F standard For complete safety information see the Model 3301C user manual The MIL STD 461F test kit includes these parts kit shown assembled ONLY QUALIFIED PERSONNEL should install operate or service this equipment CONTACT ETS LINDGREN PRIOR TO SERVICING Servicing or modifying the unit by yourself Cable 27 in may void your warranty If you attempt to service the unit by yourself disconnect all electrical power before starting There are voltages at many points in the instrument that could if contacted cause with BNC connector personal injury Only trained service personnel should perform adjustments and or service procedures upon this instrument Capacitors inside this instrument may still be CHARGED even when instrument is disconnected from its power source Warranty Information For warranty information see the Model 3301C user manual Ferrite bead NETS LINDGREN An ESCO Technologies Company USA Headquarters 1301 Arrow Point Drive Cedar Park TX 78613 Phone 512 531 6400 support ets lindgren com BNC bulkhead connector Please see www ets lindgren com for a list of all ETS Lindgren offices Right angle bracket Copyright 2008 2011 by ETS Lindgr2. angle bracket www ets lindgren com
3. en L P All Rights Reserved No part of this document may be copied by any means i without written permission from ETS Lindgren L P Note ETS Lindgren may substitute a similar part or new part number with the same functionality for another part part number Contact ETS Lindgren for questions about part numbers and The ETS Lindgren logo is a trademark of ETS Lindgren L P t ordering parts Revision Date A Initial Release September 2008 C Add monopole info July 2011 399295 Rev C gs el AU a www ets lindgren com www ets lindgren com WETS LINDGREN An ESCO Technologies Company VAN Before assembling read Safety Information on the back page of this document Monopole centerline 41 0 in 1040 mm Counterpoise 1200 mm eee antenna base 1 Attach ferrite bead at cable midpoint Tripod or other support not included t n p 23 6 in 600 mm Ground plane Ground plane Top of monopole MIL STD 461F Test Kit Assembly Instructions For information on the monopole rod element see the Model 3301C user manual 1 Disconnect the Model 3301C from power 2 Attach the ferrite bead at the midpoint of the BNC cable 3 Attach the angle bracket to the ground plane screws not included Connect BNC cable to OUTPUT 4 Plug the BNC cable into OUTPUT on the Model 3301C 5 Plug the other end of the BNC cable into the BNC bulkhead connector in the right
Download Pdf Manuals
Related Search