2.Specs. - Global Sources
Contents
1. basis of the pre set condition when GSM signals get back all the event alerts will be auto sent to the authorized numbers or monitoring platform server but the logged tracking data should be loaded to the monitoring platform via SMS command 5 10 Alarms Note All Alarms will be sent to Central Number 5 11 Low battery alarm 5 11 1 Send SMS lowbat password space 1 to activate the function it will send SMS low battery latitude longitude to central number when voltage of battery is below about 3 6V 5 11 2 This function disactivates as default send SMS lowbat password space 0 to deactivate 5 12 Power off alarm 5 12 1 Send extpower password space 1 to activate it will send SMS power alarm latitude longtitude to central number when external power is cut off 5 12 2 This function disactivates as default Cancel Send SMS extpower password space 0 to deactivate it 5 13 Geo fence alarm Set up a geo fence for the tracker device to restrict its movements within a district The unit will send SMS to the central number when it detects alarm Remark 0 represents close alarm 10 represents out fence alarm 01 represents enter fence alarm 11 represents out and enter fence alarm 5 13 1 Set Up Send SMS stockade password space semi diameter space alarm type to unit to set the restricted district In case of breach it will send SMS stockade geo info to the central number For example send2. 4 Set IP and Port 5 5 5 gt 5 5 5 5 5 5 5 5 5 5 5 15 5 5 5 5 5 5 5 5 5 3 5 5 6 7 Cautions cecsdeccectavcacs Faults amp the Solutions Contents Cbba nunn Installation attentions NOTE device front side towards the sky When install in car if the windscreen glued by metal thermal insulation layer or heating layer it will reduce the GPS receive signal and lead to GPS work disorder Under rear windshield NOTE device front side towards the sky Attentions Device light 1 No yellow light failed to read SIM card need reinstall SIM card 2 Blue light flash no GPS signal make sure device started outside 3 Three lights off lights entered sleep mode make a call can wake up Device failed located 1 Failed located message replied with all 0 make sure device started outside not in room 2 Can t reach the call make sure SIM card has balance and installed properly Device can t track on platform 1 Check three lights are stable lighting on Make sure device can communicate by sending SMS and make a call 2 Check the Vehicle State Send SMS command check password to the tracker device to check the IP port etc info 1 Summary Working Based on existing GSM GPRS network and GPS s
3. GPS GSM GPRS GPS Tracking System User Manual Model TK06B Thank you for purchasing the tracker This manual shows how to operate the device smoothly and correctly Make sure to read this manual carefully before using this product Please note that specification and information are subject to changes without prior notice in this manual Any change will be integrated in the latest release Installation attentions Attentions e NSU AY eneen 2 SPECS ceceeaecteacoseaneanattads 3 Installation instructions 4 Wires connection Function setting 1 Initialization 2 Change Password 3Authorization 4 Set up monitor central number po Single Tracking cccrccssenseartercenss 6 Continuous Tracking Automatically J ACCU Tracking esseen 8 Modes switch between track amp monitor 9 Data logging 10 11 lt 12 13 14 16 A7 18 sD 2 pall 22 23 24 29 25l Alarms osese Low battery alarm Power off alarm Geo fence alarm Movement alarm Overspeed alarm ACC working alarm Vibration alarm Set all alarm mode Cut off the Oil and Power Resume the Oil and Power Check the Vehicle State Device Resetting IMEI Checking Time Setting GPRS Setting Set APN 25
4. SMS stockade000000 500 1 stands for based on device current coordinates as center 500 is semi diameter set 1 as out fence alarm type 5 13 2 Cancel Send SMS nostockade password to deactivate this function 5 14 Movement alarm Device will send movement alarm once vehicle moved 100 meters The function is default activate if detected vehicle ACC ON When vehicle ACC OFF stands for closing movement alarm Note this function must connect ACC wire 12 5 15 Overspeed alarm 6 8 7 1 Set up Send SMS speed password space 80 to the unit suppose the speed is 80km h and it will reply speed OK When the target moves exceeding 80km h the unit will send SMS speed Geo info to the central number 5 15 1 Cancel Send SMS speed password space 0 to deactivate the overspeed alarm Remark It is recommended that the speed alarm is set at not less than 30km h For below that rate it may cause the excursion of the GPS signal influenced by clouds etc 5 16 ACC working alarm 5 16 1 This function is disabled as default To active this functions send A CC password Space 1 to tracker it will reply ACC CONFIG OK And tracker will send ACC on latitude amp longitude to central number when detect ignition action that means the vehicle has been started 5 16 2 Send ACC password Space 0 to disabled this function tracker will reply ACC CONFIG OK 5 17 Vibration alarm Send SMS vibrate password space 0 t
5. atellites this product can locate and monitor any remote targets by SMS or GPRS NOTE Please turn on small switch inside SIM card hole after install SIM card 2 Specs Content Specs Dim 84 mm x47 5 mm x 15 mm Weight 50g Network GSM GPRS GPS Band 850 900 1800 1900 Mhz GPS chip UBLOX 7020 GSM module MT6260A GPS sensitivity 159dBm GPS accuracy 5m Time To First Fix Cold status 45s Warm status 35s Hot status 1s Work voltage 9V 36V Storage Temp 40 C to 85 C Operation Temp 20 C to 45 C Humidity 5 95 3 Installation instructions 3 1 Preparation 4 1 1 Open the package to check the device model number is correct be with full accessories or else please contact your supplier 4 1 2 Choose SIM card need insert a GSM SIM card into the device please refer to the suggestion of your supplier for SIM card choice Notice Please insert SIM card before turning the device power switch to on The SIM card need open the GPRS function Please make sure SIM card with full balance 3 2 Installation The device is hidden type installation we suggest the device installing by professional institution Please pay attention to the following points 3 2 1 To avoid the thieves destruction the device installation place should be as far as hidden 3 2 2 Avoid putting the device with reversing radar car burglar alarm and any other vehicle communication devices 3 2 3 Can fix the dev
6. eply reset ok 5 23 IMEI Checking 5 23 1 Send SMS command getimei password to the unit E g Send SMS command getimei123456 to the tracker device an IMEI number in 15 digits will reply to your cell phone 5 23 2 Send SMS command setimei password space 15 digits IMEI number to the unit E g Send SMS command setimei123456 123456789012345 to the tracker device it will reply SMS SETIMEI CONFIG OK 5 24 Time Setting 5 24 1 Send SMS command timezone123456 space time to the tracker unit If succeed It will reply time OK 5 24 2 For example Send SMS timezone123456 8 8 is Chinese time zone If your country time zone is minus send SMS time zone123456 8 5 25 GPRS Setting User must send SMS via cell phone to set up APN IP and port before starting 15 tracking by GPRS on tracking system 5 25 1 Set APN 6 22 1 1 APN standards for Access Point Name and differs from country to country For more information about your local APN please inquire with your local GPRS network operator 5 25 2 Send SMS APN password spacet tlocal APN space APN name space APN password via a cell phone and if succeeded the tracker will return the message APN OK 5 25 3 E g Send SMS command APN123456 CMNET If succeeded it will reply SMS APN OK Notes CMNET is the APN of one of china GPRS Network Operator China mobile it has no APN name and Password 5 25 4 Set IP and Port Send SMS admin
7. ice by ribbon or wide sponge powerful two side glue stick 3 2 4 The device has built in GSM and GPS antenna make sure the receive side upward and there is no metal shielding 3 2 5 Recommended installation place The hidden place in the board below the front windscreen The hidden place around former dashboard nonmetal material for skin The hidden place in the board below the back windscreen Notice If the windscreen glued by metal thermal insulation layer or heating layer it will reduce the GPS receive signal and lead to GPS work disorder then please change the installation place 3 3 Device light description Light Signal Red light Power Yellow light GSM signal Blue GPS signal 4 Wires connection 1 Red wire connects to vehicle power anode 2 Black wire connects to vehicle power cathode 3 Yellow wire connects to oil or circuit control wires 4 Green wire connects to ACC wire 2A FUSE gt battery 12VR24V 5 Function setting 5 1 Initialization Send SMS begin password to the unit it will reply BEGIN CONFIG OK and initialize all the settings to default factory settings default password 123456 For example send SMS begin123456 it will reply BEGIN CONFIG OK The in the command please don t type space means press the space keyboard on your cell phone 5 2 Change Password 5 2 1 Send SMS password old password space new pass
8. info 5 6 Continuous Tracking Automatically 5 6 1Send SMS command IT V password space moving time interval space static time interval to the tracker device 5 6 2 For example send SMS ITV123456 10 500 it will report data to server at 10s time interval when vehicle is moving 500s time interval when vehicle is static 5 7 Cell ID Tracking 5 7 1 You must set up the APN of your local GSM network for the SIM card in tracker first before using this function if there is user name and password for GPRS login Please refer to following to configure the APN user name and password for GPRS login 5 7 2 After configure the APN send SMS cell password to device it will reply cell ID info This function need platform support 5 8 Modes switch between track amp monitor 5 8 1 The default mode is track track mode 5 8 2 Send SMS command monitor password to tracker device of vehicle 10 terminal it will reply MONITOR CONFIG OK and switch to monitor mode In this mode the user can dial up the tracker device to monitor the voice 5 8 3 Send SMS command tracker password to tracker device of vehicle terminal It will return TRACKER CONFIG OK and restore to track mode 5 9 Data logging This function must insert TF card Auto logging When the tracker device lost GSM signals or fall offline from GPRS tracker will log the tracking position and alerts automatically in the SD card on the
9. ip password space IP Address space port number If succeeded it will reply ADMINIP CONFIG OK E g Send SMS adminip123456 116 205 4 114 8169 to the tracker device 116 205 4 114 is IP 8169 is port 6 Cautions Please comply with the instructions to extend the unit life 1 Keep the unit dry Any liquid i e rain moisture may destroy or damage the inside circuitry 2 Don t use amp store the unit in dusty places 16 3 Don t put the unit in overheated or overcooled places 4 Handle carefully Don t vibrate or shake it violently 5 Clear the unit with a piece of dry cloth Don t clean in chemicals detergent 6 Don t paint the unit this may cause some foreign materials left in between the parts 7 Don t disassemble or refit the unit 8 Please read the user manual carefully before installation and operation learn something more about the voltage range Otherwise it won t work properly or destroy the product 7 Faults amp the Solutions Startup Fail Please check SIM card hole small switch turn on or not Location report in digits of zeros Make sure device work outside not in room IMonitor Fail CRE ee Check if the authorized number is setup Can t show online Platform Check if IP and APN SMS are setup
10. o deactivate this function Send SMS vibrate password space 1 15 to set up vibrate level from 1 to 15 1 is strongest level 15 is lowest level 13 5 18 Set all alarm mode Send SMS KC password space 0 to tracker to close the function Send SMS KC password space 1 to tracker to choose alarm by SMS Send SMS KC password space 2 to tracker to choose alarm by calling 5 19 Cut off the Oil and Power System Send SMS command DY password to the tracker device it will reply DY CONFIG OK to your cell phone from the tracker device and stop your car oil pump or elec as well 5 20 Resume the Oil and Power System Send SMS command TY password to the unit It will reply TY CONFIG OK and resume your car oil pump or elec as well 5 21 Check the Vehicle State Send SMS command check password to the tracker device in the vehicle it will reply following SMS CHECK imei 13579024681 122 0 apn IP 220 231 161 156 696 9 Cnum Gps 1 Gsm 60 itv 30 T Z 0 0S 0 GF 0 0 0 Door 0 Cnum center number GSM 60 means GPS signal value GPS 1 1 means GPS located 0 means not located itv 30 time interval is 30 seconds TZ 8 time zone is GMT 0 14 GF 500 1 1 Geo fence function 500meters OS 0 means deactivate 1 means activate door 1 means door alarm function open 5 22 Device Resetting SMS Reset Send SMS reset password to tracker device to reset the GSM module and GPS module of the tracker device it will r
11. word to the unit to change the password For example send SMS password123456 888888 to the unit If succeeded PASSWORD CONFIG OK will reply to your cell phone from the device tracker 5 2 2 Make sure the new password is in 6 digits or else the tracker cannot recognize the password 5 3Authorization There are 5 numbers to be allowed to authorize in the tracker at most 5 3 1 Authorization Send SMS admin password space cell phone number to set up an authorized number the other central number should be set by the first authorized number if the number is successfully authorized the unit will reply ADMIN CONFIG OK by SMS 5 3 2 Delete authorization Send SMS noadmin password space authorized number to delete the authorized number 5 4 Set up monitor central number All alarms will be received by central number 5 4 1 Setup send command centernum password space number to tracker it will reply centernum ok After setup monitor center number the messages of auto track by SMS will be set to this center number if all alarms need to be sent to this number too then this center number must be setup as authorized number 5 4 2 Cancel Send centernum password to tracker it will reply CENTERNUM CONFIG OK 5 5 Single Tracking Make a missed call to device number or Send SMS smslink123456 to device number it will reply a real time tracking message include Long amp Lat
Download Pdf Manuals
Related Search