IINDUSTRIAL RFID ACCESS CONTROLLER Locky – BF
Contents
1. contri E Si R itions Bulgaria 7019 Ruse 11 V Levski Blvd tel 359 82862862 fax 359 82860555 hal info teracom cc www teracom cc o IINDUSTRIAL RFID ACCESS CONTROLLER Locky BF Short description Locky BF is an electronic device designed to control the access to electric and electronic devices The controller works with RFID tags in the form of cards key fobs and stickers It is formed as a button in which are embedded controller and the reading antenna Options Can be programmed by service tag adding and group deleting identifiers Can be programmed by hand held terminal HT500 or PC Supports wired and wireless communication with hand held terminal HT500 Credit mode for each tag can be set number of usage Statistic mode every usage of tag is counted Specifications Operating temperature range 10 40 C Power supply 8 24 VDC Maximum consumption with switched on relay 70 mA Contact rating 60V 0 3A Reading range lt 3cm Dimensions D 38mm x 36mm RFID tags 125kHz EM4102 compatible Memory non volatile for up to 500 tags Pin outs and dimensions Normally open contact Common contact Rx 0 5V Normally closed contact Tx 0 5V GND 5VDC 8 24 VDC GND Front panel variants Label 1 Label 2 Label 3 yellow key gray background blue background Bulgaria 7019 Ruse 11 V Levski Blvd tel 359 82862862 email info teracom cc Mode2. Deleting all identifiers The controller enters in this mode when the service tag is put and hold in the range of antenna The indicator goes out After 8 seconds memory erasure begins the process is indicated by sequentially flashing and issuing a series of short beeps The end of the process is indicated by two long beeps flashing simultaneously and return the device in operating mode In this mode service tag is not deleted Programming by hand held terminal HT500 Allows you to add new and change the status of already memorized tags Changeover can be made without tag Performed with hand held terminal model HT500 in two ways wire with cable Cable converter Locky USB TTL or wireless with hand terminal positioned in front of controller The programming is explained in the user manual of the hand terminal Programming by PC Specialized program LockyMonitor is utilized It can be downloaded from www teracom cc The interconnection between the controller and PC is through Cable converter Locky USB TTL Special mode for advanced users only The functionality of controller can be changed to Locky BP or Locky BF by handy terminal HT500 or by LockyMonitor software For details see www teracom cc Bulgaria 7019 Ruse 11 V Levski Blvd tel 359 82862862 email info teracom cc
3. s The controller Locky BP might be one of the following modes Operating mode Adding new identifiers by the service identifier Deleting all identifiers by the service identifier Programming by hand held terminal HT500 Programming by PC Operating mode In this mode the indicator shines consistently red or green The color depends on the condition of the built in relay green for on normally open contact is closed or red for off If a valid tag is put in the range of antenna the controller issued a short beep accompanied by a switching relay and the indicator changes color If an invalid tag is put in the range of antenna the controller issued six long beeps without relay switch and indicator flashes three times in the red If a service tag is put in the range of antenna Locky BF enters in adding or deleting modes Adding new identifiers The controller enters in this mode when the service tag is put in the range of antenna The indicator lights up in yellow and the controller issues a single beep When a new tag is put in the range of antenna the controller issues two beeps and LED flashes once If the tag has been previously programmed Locky BF issue consistently one short and three long beeps to ban new record Going back to operating mode can be done either by put the service tag in the range of antenna the controller issues four beeps or automatically 30 seconds after the last identifier was approached
Download Pdf Manuals
Related Search