Manual - Markertek
Contents
1. ING AVenview EXTENDERS SPLITTERS WIRELESS Connecuvity and Beyond CABLES amp ACCESSORIES VIDEO WALLS VIDEO PROCESSORS 4 Port 3G HD SD SDI Splitter DA with Reclocking User s Guide Model SPLIT 3GHDSDI 4RS Compliant 2013 Avenview Inc All rights reserved The contents of this document are provided in connection with Avenview Inc Avenview products Avenview makes no representations or warranties with respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at any time without notice No license whether express implied or otherwise to any intellectual property rights is granted by this publication Except as set forth in Avenview Standard Terms and Conditions of Sale Avenview assumes no liability whatsoever and disclaims any express or implied warranty relating to its products including but not limited to the implied warranty of merchantability fitness for a particular purpose or infringement of any intellectual property right Reproduction of this manual or parts thereof in any form without the express written permission of Avenview Inc is strictly prohibited TABLE OF CONTENTS SEC HON T GETTING STARTED eer ee 3 IMPORTANT SAFEGUARDS cra ue 3 1 2 AE Ip ege C 3 3 REGULATORY NOTICES FEDERAL2. Reclocking SDI signals for cascading and thus longer transmission nter locked power supply for better fixedness 6 PACKAGE CONTENTS Before you start the installation of the converter please check the package contents SPLIT 3GHDSDI 4RS Power Adapter 5V 4A DC VIDEO WALLS VIDED PROCESSORS IN Avenview EXTENDERS SPUTTERS ABLES amp ACCESSORMES 4 Port 3G HD SD SDI Splitter DA with Reclocking USER S MANUAL kn Paneer www avenview com 7 155 e Put the product in an even and stable location If the product falls down or drops it may cause an injury or malfunction e Don t place the product in too high temperature over 50 C too low temperature under 0 C or high humidity e Usethe DC power adapter with correct specifications If inappropriate power supply is used then it may cause a fire Do not twist or pull by force ends of the coaxial cable It can cause malfunction SECTION 2 SPLIT 3GHDSDI 4RS 2 Biel ee DENS NEO FRONT PANEL 3G 3G HD SD SDI Input 2 LED Reserved 3 LED Power Indicator 4 5V DC Power Jack REAR PANEL www avenview com 2 2 MEDIEN Follow these instructions for installation of SPLIT 3GHDSDI 4RS Ensure SPLIT 3GHDSDI 4RSand all other source devices are turned off Connect a camera or other 3G HD SD SDI device to Input of SPLIT 3G4HDSDI 4RS Connect devices equipped with 3G HD SD SDI inputs e g monitors or
3. COMMUNICATIONS COMMISSION FCC 4 1 4 INTRODUC TION t 5 1 5 FEATURE S 5 1 6 OI TIN 5 7 BEFORE INSTALLA ON E 6 SECTION 2 SPUT 3GHDSDI ARS 6 2 1 PANEE DESCRIPTOR P 6 2 2 INS TALLA TIOR m 7 SECTION 3 SPECIFICATIONS 8 SECTION 4 SIGNAL MEASUREMENTS cxscucescnsicheuauecutdeshanctustaonceecnuichagauensedethersaeaneustecenebubeqanesscisne 10 www avenview com SECTION GETTING STARTED AE IMPORTANT SAFEGUARDS Please read all of these instructions carefully before you use the device Save this manual for future reference What the warranty does not cover Any product on which the serial number has been defaced modified or removed e Damage deterioration or malfunction resulting from e Accident misuse neglect fire water lightning or other acts of nature unauthorized product modification or failure to follow instructions supplied with the product e Repair or attempted repair by anyone not authorized by us e Any damage of the product due to shipment e Removal or installation of the product e Causes external to the product such as electric power fluctuation or failure e Use of supplies or parts not meeting our specifications e Normal wear and tear e Any other
4. video processors to SPLIT 3GHDSDI 4RSoutputs Turn ON all devices connected to output of SPLIT 3GHDSDI 4 Plug power adapter to 5V DC power jack of SPLIT 3GHDSDI 4 3G 60m 190 feet SPLIT 3GHDSDI 4 RS 1035150 59 94 60 1080150 59 94 60 1080p24 30 150 500 feet SD NTSC 059 94Hz PAL SOHz 300m 1000 feet 3G HD SD SDI TV 1 3G HD SD SDI TV 2 3G HD SD SDI TV 3 3G HD SD SDI TV 4 JGHDSDOI 4 HD ry 1080p In CABLE INDEX 3G HD SD SDI Source FRONT L9 Output www avenview com SECTION 3 SPECIFICATIONS ITEM DESCRIPTION BEEN DETECTION Yes 3G up to 60m 190ft HD up to 150m 500ft SD up to 300m 1000ft PATTERNS OUTPUT CONNECTORS 4x BNC SDI BNC CONNECTOR 75 inter locked socket Amplitude Within 800mV 3 lt 10 Rise overshoot Less than 296 1096 EYE PATTERN Fall overshoot Less than 296 lt 10 CHARACTERISTICS Long time jitter 0 195 lt I Op Timing jitter 0 195 lt I Op Alignment jitter 0 127 0 2p 5V 4A DC Inter locked power supply 0 Watts max 20 9096 RH no condensation www avenview com Center Conductor Dielectric Bonded Laminated Aluminum Tape Aluminum Braided Shield Un X Dae F PL UN Laminated Aluminum Tape Non Bonded Jacket Plug Jack Letter Millimeters Letter Millimeters Minimum Maximum Minimum Maximum A 0 72 0 76 8 99 9 09 B F
5. causes which does not relate to a product defect e Removal installation and set up service charges 1 2 MEN BM The SPLIT 3GHDSDI 4RS 4 Port 3G 3G HD SD SDI Splitter with Reclocking have been tested for conformance to safety regulations and requirements and have been certified for international use However like all electronic equipments the SPLIT 3GHDSDI 4RSshould be used with care Read the following safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit A Do not dismantle the housing or modify the module Dismantling the housing or modifying the module may result in electrical shock or burn A Refer all servicing to qualified service personnel A Do not attempt to service this product yourself as opening or removing housing may expose you to dangerous voltage or other hazards A Keep the module away from liquids A Spillage into the housing may result in fire electrical shock or equipment damage If an object or liquid falls or spills on to the housing unplug the module immediately A Have the module checked by a qualified service engineer before using it again A Do not use liquid or aerosol cleaners to clean this unit Always unplug the power to the device before cleaning www avenview com REGULATORY NOTICES FEDERAL COMMUNICATI This equipment has been tested and found to comply with Part 15 of the FCC rules These limits are designed to pro
6. lared to meet good B 1 44 7 54 electrical contact C 6 65 6 75 C 7 70 7 80 D 6 22 6 27 D 4 55 5 05 E 7 82 E 4 55 4 85 F 4 35 4 55 F 0 92 1 42 G 3 85 4 39 H 1 27 1 43 J 4 32 4 42 SIGNAL MEASUREMENTS RESULTS WAS TESTED BY TEKTRONIX MEASUREMENT DEVICE USING BELBEN 1694A HD SDI 18 AWG LOW LOSS SERIES DIGITAL COAX CABLE RG 6 U TYPE 18 AWG SOLID 040 BARE COPPER CONDUCTOR GAS INJECTED FOAM HDPE INSULATION DUOFOIL TINNED COPPER BRAID SHIELD 95 COVERAGE PVC JACKET www avenview com SECTION 4 SIGNAL MEASUREMENTS Video Session Jitter Waveform 0 04ns Jitterl HPF 10 Hz Timing litter Waveform Input SDI 3Ga Signal PP O04dns O11UI Effective Auto 1080p GO YCbCr 422 10b 425 2 970 Gbps ux mm Selected Auto Format Auto Structure Auto Transport 352M Payload 89h 00h Olh SAV Place Err Y Stuck Bits Field Length Err C Stuck Bits Line Length Err Line Number Err Ancillary Data Y Present Statistics Status Err Secs Err Fields Err Fields RGB Gamut Error 26 319 0 7779 Cmpst Gamut Error 18 277 0 6755 Luma Gamut Error 18 231 0 5633 Chan CRC Error 0 0000 5 C Chan CRC Error 0 0000 5 Y Anc Checksum Error 0 0000 5 C Anc Checksum Error 0 0000 5 Changed since reset N A Run Time 0 d 00 12 04 Running Jitter2 HPF 100 kHz Alignment All LI 3 us Div 1080p 60 May 26 23 18 52 ID WFM7120 1BFE02 SDI Input A 3Ga Ref Internal Tektronix TE Disab
7. led Jitter Waveform Jitterl HPF 10 Hz Timing Video Session litter Waveform Input SDI A 3Ga Signal 0 06ns__0 17UI Effective Auto 1080p GO YCbCr 422 10b 425 2 970 Gbps ie Selected Auto Format Auto Structure Auto Transport 352M Payload 89h CEh 00h Olh SAY Place Err Y Stuck Bits Field Length Err C Stuck Bits Line Length Err Line Number Err Ancillary Data Y Present Statistics Status Err Secs Err Fields Err Fields RGB Gamut Error 26 319 0 6965 Cmpst Gamut Error 18 277 0 6048 5 Luma Gamut Error 18 231 0 5042 5 Chan CRC Error 0 0000 5 C Chan CRC Error 0 0000 5 Y Anc Checksum Error 0 0000 5 C Anc Checksum Error 0 0000 5 Changed since reset N A Run Time 0 d 00 13 24 Running Jitter2 HPF 100 kHz Alignment All ps Div 1080p 60 May 26 23 20 12 ID WFM7120 1BFEO2 SDI Input A 3Ga Ref Internal Tektronix TE Disabled www avenview com aN Avenview TECHNICAL SUPPORT CONTACT US Phone 866 508 0269 fe Email support avenview com Xe USA Head Office Avenview Corp 275 Woodward Avenue Kenmore NY 14217 Disclaimer While every precaution has been taken in the preparation of this document Avenview Inc assumes no liability with respect to the operation or use of Avenview hardware software or other products and documentation described herein for any act or omission of Avenview concerning such products or this documentation for an
8. vide reasonable protection against harmful interference in a residential installation Any changes or modifications made to this equipment may void the user s authority to operate this equipment Warning symbols Description ONLY USE THE PROVIDED POWER CABLE OR POWER ADAPTER SUPPLIED DO NOT TAMPER WITH THE ELECTRICAL PARTS THIS MAY RESULT IN ELECTRICAL SHOCK OR BURN DO NOT TAMPER WITH THE UNIT DOING SO WILL VOID THE WARRANTY AND CONTINUED USE OF THE PRODUCT THE VIDEO BOARDS ARE VERY SENSITIVE TO STATIC PLEASE ENSURE IF RACK MOUNTED OR INSTALLED ON A SURFACE IT SHOULD BE INA GROUNDED ENVIROMENT Read amp understand user guide before using this device Failure to follow the proper installation instructions could result in damage to the product and preventing expected results www avenview com 1 4 NODU The Avenview SPLIT 3GHDSDI 4RSreceives one SDI input perfectly duplicates it and re transmits four SDI outputs for real time multi viewing It is a reliable video device splitting a SDI HD SDI or 3G SDI video source to four SDI compliant displays at the same time 1 5 FEATURES 3G HD SD triple rate distribution Four separately buffered and reclocked outputs Cable equalization Belden 16944 and signal retiming Dual color LED indication of input lock and rate Pass all ancillary data A Provides automatic input cable equalization up to 300m 1000ft SD 150m 500ft HD and 60m 1 90ft
9. y interruption of service loss or interruption of business loss of anticipatory profits or for punitive incidental or consequential damages in connection with the furnishing performance or use of the Avenview hardware software or other products and documentation provided herein Avenview Inc reserves the right to make changes without further notice to a product or system described herein to improve reliability function or design With respect to Avenview products which this document relates Avenview disclaims all express or implied warranties regarding such products including but not limited to the implied warranties of merchantability fitness for a particular purpose and non infringement www avenview com
Download Pdf Manuals
Related Search