Home

User Manual - Moon

image

Contents

1. HOW TO MOUNT THE HEADLIGHT TO HELMET 1 Remove the belt from one side of the helmet mount 2 Place the helmet mount into the suitable location on helmet 3 Wrap belt around helmet and attach the end of the belt to itself tightly 4 Insert the headlight into the helmet mount until it clicks into place 5 Press down release lever to remove INSTALL gt SSS y m a _ RELEASE RELEASE To adjust the vertical beam angle when mounted on the helmet loosen the screw knob and rotate the light up or down to your preferred angle then tighten the screw knob to secure the light in place BEAM ADJUSTMENT To adjust the horizontal beam spin the headlight left to right for your best side to side beam angle To adjust the vertical beam angle loosen the mounting and rotate the light up and down to your best vertical beam angle then tighten the mounting Co A The beam is widely dispersed besides its high brightness To prevent from blinding the oncoming vehicles on the public roads you d better adjust the angle downward SIMPLE PROBLEMS ANALYSIS AND SOULUTION 1 Problem The light is not on Solution Check if the battery still has power Check if the power button is pressed hard Check if the battery is installed correctly 2 Problem The light turns off over rough terrain Solution Check i
2. Power button Over drive J Fast press Flashing h High beam mes E sive e Standard lt J 4 SOS Low Fast press 2 times 3 Press and hold the on off button around 0 5 second to turn off Power button J wy PRESS Hold 0 5 sec OVER HEAT PROTECTION The over heat protection device can ensure the bicycle light in a good running temperature condition so that to protect the LEDs without burning case When the bicycle light is running and without adequate air flow this protection device will automatically start to dim the light to standard brightness mode it can reduce the heat of the light and ensure the LEDs won t get damage due to over heat Once the air flow condition of the light is improved the running temperature of the light will go down then the over heat protection device will cut the brightness of the bicycle light will get back to the beginning of the selected mode HOW TO MOUNT THE HEADLIGHT 1 Insert the handlebar bracket into the bottom slot of the light 2 Spin the below part of the bracket counter clockwise to loosen the screw 3 Unlock the bracket and put the light in suitable place of your handle bar 4 Twist the screw clockwise to lock the bracket 5 The bracket fits 22 31 8mm handle bar Additional shims are included and you can use them when necessary
3. Several factors can influence the battery s durability type of cell strain the maintenance routine the temperature and etc Normally speaking the higher the battery capacity the longer the burn time 9 The battery capacity may become ineffective about 80 of its value after 300 500 charge discharge cycles The battery may have 3 years life span under good care 10 The battery voltage and capacity decrease apparently at low temperatures especially near or below ice point The capacity decreases 5 10 at freezing burn time decreases 50 At 20 C the capacity decreases 30 burn time decreases 70 The battery performance will return normal when the temperate gets up to 70 F 20 C The battery will lose around 1 of its capacity per day when you store the battery at normal room temperature Battery temperate should never exceed 104 F 40 C it will lose about 5 of its Capacity per day 11 If you donot use the battery for a long time be sure to make it a fully recharge every 3 months before storing again Please keep the battery in cool and dry place when storing HOW TO INSTALL AND RELEASE THE BATTERY Light body point INSTALL eon RELEASE Battery installation 1 Align the point O to the light body point Install the battery into the light body 2 Turn right to close the battery door until the point L align the light body point Battery release 1 Turn left to open the battery door and the
4. ITIITI LIGHT THE WAY YOU RIDE ON USER GUIDELINE Thank you for choosing MOON X power series headlight For using this product safely and conveniently and keeping it well preserved please read this manual carefully before using Please save this manual for future reference Due to the improvement of the product the product you bought may not be exactly in accordance with the introduction of this manual We apologize for that SPECIFICATION CREE XM L U2 high brightness LED Quick release rechargeable lithium ion battery 3 6V 3200mAh USB rechargeable Water resistant headlight with durable zinc alloy light cap 7 lighting modes Over drive High Standard Low Flashing Strobe SOS Quick release handlebar mount fits 22 31 8mm Quick release helmet mount Low battery charging and fully charged indicator Automatic fully charged cut off system Precision optical lens CONTECTS INCLUDED CONTENTS X power 780 Lithium ion battery USB cable Handlebar bracket Helmet mount bracket Optional acessoires Wall charger Helmet mount bracket LIGHT OPERATION 1 Press the power button to choose the modes In this method four modes are cycle Power button Over drive _ High beam 1 Standard Z Low PRESS 2 Fast press two times the power button to change into the strobe and flashing modes Fast press two times back to the first cycle
5. battery will pop out slightly 2 Pull the battery out from the light body Attention To maintain smooth battery installation release use bicycle friendly grease to lubricate the battery opening and battery o ring HOW TO CLEAN AND CARE THE LIGHT Make sure to clean the dust and dirt on the light with soft damp cloth after every ride Water resistant is for rain water only Do not submerge the battery or the whole light into water when cleaning Once you start using the light you d better keep using it When you have to stop using for a long time please take off the battery to keep well A CAUTION When riding at night please follow the guidelines below Carrying a flash light is recommended Use caution when handing the light may get hot Unplug the battery and headlight if no use Unplug the battery and charger if no use Unplug connector by the plug never by the cable Use the provided charger only when charging Do not amend or replace any parts with Non MOON parts Do not dismantle the headlight and battery case Provide sufficient airflow to the headlight for cooling during use Do not control any part of the system under water Do not look directly at light Do not leave the light on and unattended Keep headlight and battery away from fire and combustible materials Do not store head unit when hot or straightway after use Unplug
6. f the battery is fully inserted O HOW TO CHARGE BATTERY Attention MOON would like to recommend you to use the original supplied smart charger or USB cable to charge the battery The battery will be damaged if you use any other smart chargers or USB cables to charge the battery Unplug the light charger and cable once the battery is fully charged Please make sure the smart charger is never used in outdoors When the indicator turns flashing red it means the battery is low You d better charge the light right now aa A Power button Low battery indicator 100 75 Blue 75 50 Green 50 25 Steady Red 25 0 Flashing Red Low battery amp charging indicator Charging indicator Flashing blue charging Soild blue charged Rubber cover USB port 1 Find the charging place under the head part of the light 2 Lift the rubber cover and you ll see the charging port 3 If using USB cable connect it to your computer USB port 4 If using wall charger connect it to the wall outlet 100 to 240 volts 5 Charge time may depend on computer or wall charger 6 When the battery is fully charged please unplug the USB cable or wall charger Then replace the rubber cover 7 It is normal that the battery may get high temperatures during charging up to 104 F 40 C as the chemical in battery is in reaction If the battery is not drained completely before charging it may also get warm 8
7. s necessary please refer to the following instructions We recommend that items be sent by a traceable method such as FedEx or UPS MOON is not responsible for lost or misdirected packages Please include your full contact information name address phone number and email if applicable and a description of the issue Address items to local dealer or regional distributor What is not covered MOON Lights are covered by a ONE YEAR LIMITED WARRANTY from the date of purchase This covers the lights and cables only It does not cover the battery or battery internals Batteries are covered by 120 days warranty For more information please contact us at cs moon sport com WA moon xp 780
8. the USB cable when fully charged This light is for bicycle use only X POWER 780 Total Angle 100 Spot angle 19 Emax LUX Distance M 780 LUMENS RUN TIME mode tumen runtime weight E7g Over drive 780 Up to 1 hour 30 mins High 550 Up to 2 hours 50 mins 4 hours Standard 400 Up to 3 hours 20 mins 177g by wall charger Low 200 Up to 7 hours 30 mins Flashing 400 Up to 5 hours 20 mins Strobe 400 Up to 5 hours 20 mins Charge time dependent on wall charger or computer WARRANTY MOON warrants to the original purchaser of this product that the product is free from defects in material and workmanship for a period of one year This warranty does not apply to damage due to heat physical damage resulting from abuse neglect improper repair improper fit or alterations of the fixture This warranty is in lieu of all other agreements and warranties general or specific express or implied and no representative or person is authorized to assume liability on behalf of MOON in connection with the sale and use of this product MOON reserves the right to request the return of any product submitted for warranty consideration All customers should contact the local dealer or regional distributor for warranty service To make a claim first call local dealer or regional distributor Some issues may be resolved upon the initial call If return of the product i

Download Pdf Manuals

image

Related Search

Related Contents

Lincoln Electric NA-5N User's Manual  ZTE-G S511 Téléphone mobile Manuel d`utilisateur  報道関係者各位 2011年10月20日  ASRock Fatal1ty Owner's Manual  Radio StarFire RTK de 900 MHz - stellarsupport global  manuale istruzioni  GENUINE RIGGING-PARTS AND ACCESSORIES  取扱説明・IH用    CALENDARME USER MANUAL March 16, 2007 LOGGING IN  

Copyright © All rights reserved.
Failed to retrieve file