User Manual
Contents
1. Soundweb soundweb London BLU BIB Installation Guide 18 0766 A DECLARATION OF CONFORMITY Manufacturer s Name BSS Audio Manufacturer s Address 8760 S Sandy Parkway Sandy Utah 84070 USA declares that the product Product name BLU BIB Note Product name may be suffixed by the EU Product option all requires Class II power adapter that conforms to the requirements of EN60065 EN60742 or equivalent conforms to the following Product Specifications IEC 60065 01 Amd 1 55022 2006 55024 1998 Part 15 Safety EMC Supplementary Information The product herewith complies with the requirements of the Low Voltage Directive 2006 95 EC EMC Directive 2004 108 EC RoHS Directive 2002 95 EC WEEE Directive 2002 96 EC With regard to Directive 2005 32 EC and EC Regulation 1275 2008 of 17 December 2008 this product is designed produced and classified as Professional Audio Equip ment and thus is exempt from this Directive Roger Johnsen Vice President of Engineering 8760 S Sandy Parkway Sandy Utah 84070 USA Date June 9 2010 European Contact Your local BSS Audio Sales and Service Office or Harman Music Group 8760 South Sandy Parkway Sandy Utah 84070 USA Ph 801 566 8800 Fax 801 566 7583 U K MAINS PLUG WARNING A molded mains plug that has been cut off from the cord is unsafe Discard the mains plug at a suitable disposal facility NEVER U2. Dimensions Mains Voltage 12V DC external power supply included AC Power Input to Adapter 19W BTU Rating lt 65 BTU hr Operating Temperature Range 5 41 to 35 95 degrees C degrees F Dimensions H x W x D 1 65 x 8 63 x 7 75 42mm x 219mm x 197mm Weight 2 96lbs 1 34kg Channel Assignment CHANNELS DIP SWITCH SETTINGS CHANNELS DIP SWITCH SETTINGS CHANNELS DIP SWITCH SETTINGS CHANNELS DIP SWITCH SETTINGS 1108 Bd en soos PERPE moan MONO ores hihi anon 56 M 14510 152 We anion Fa Ol 81 to 88 I m 2 O Ol ON 891096 fal al 153 to 160 217 to 224 lu 23 5 1 ON 161 to 168 225 to 232 2 1 I m Z z lt 97 to 104 _ m z Ol 105 to 112 arm 233 to 240 11310 120 6 aj ON 241 to 248 1 E o z Ol by HARMAN 121 to 128 am Note Lowest channel of 8 channel range is always input 1 of BLU BIB UdMpungas by HARMAN NENNEN SENE by HARMAN BSS Audio 8760 South Sandy Parkway Sandy Utah 84070 801 566 8800 www bssaudio com Printed in the USA
3. may require the use of a differ ent line cord attachment plug or both depending on the available power source at installation Connect this equipment only to the power source indicated on the equipment rear panel To reduce the risk of fire or electric shock refer servicing to qualified service personnel or equivalent If connected to a 240V supply a suitable CSA UL certified power cord hall be used for this supply POWER ADAPTER Ensure a minimum of 8 inches of clearance and ventila ion around the adapter If you want to dispose this product do not mix it with general household waste There is a Separate collection system for used electronic products in accordance with legislation that requires proper treatment recovery and recycling w requires prop Y ycling Private household in the 25 member states of the EU in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer if you purchase a similar new one For Countries not mentioned above please contact your local authorities for a correct method of disposal By doing so you will ensure that your disposed product undergoes the necessary treatment recovery and recycling and thus prevent potential negative effects on the environment and human health Soundweb BLU BIB 48V The 48V LED illuminates for each channel when the channel is selected The S
4. NDER ANY CIRCUM STANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET Do not use the mains plug without the fuse cover in place Replacement fuse covers can be obtained from your local retailer Replacement fuses are 13 amps and MUST be ASTA approved to BS1362 IMPORTANT SAFETY INSTRUCTIONS RISKOFELECTRIC SHOCK DONOTOPEN ATTENTION RISQUEDECHOCELECTRIQUE NEPASOUVRIR WARNING to REDUCETHERISKOFFIREORELECTRIC SHOCK DO NOTEXPOSETHISEQUIPMENTTORAINORMOISTURE The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner s manual These symbols warn that there are no user serviceable parts inside the unit Do not open the unit Do not attempt to service the unit yourself Refer all servicing to qualified personnel Opening the chassis for any reason will void the manufacturer s warranty Do not get the unit wet If liquid is spilled on the unit shut it off immediately and take it to a dealer for service Disconnect the unit during storms to prevent damage ELECTROMAGNETIC COMPATIBILITY This device complies with part 15 of the FCC Rules and the Product Specifications noted on the De
5. claration of Conformity Operation is subject to the following two conditions this device may not cause harmful interference and this device must accept any interference received including interference that may cause undesired tion Operation of this unit within significant electromagnetic fields should be avoided use only shielded interconnecting cables SAFETY INSTRUCTIONS NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER WARNING THIS APPLIANCE SHALL BE CONNECTED TO A MAINS SOCKET OUTLET WITH A PROTECTIVE EARTHING CONNECTION The cores in the mains lead are coloured in accordance with the following code GREEN and YELLOW Earth BLUE Neutral BROWN Live As colours of the cores in the mains lead of this appliance may not correspond mi coloured markings identifying the terminals in your plug proceed as follows The core which is coloured green and yellow must be connected to the terminal in the plug marked with letter E or with the earth symbol or coloured green or green and yellow The core which is Hone blue must be connected to the terminal marked N or coloured black The core which is coloured brown must be connected to the terminal marked L or coloured red This equipment may require the use of a different line cord attachment my or both depending on the available power source at installation If the attach ment needs to be changed refer
6. de also prevents all LED s from illuminating except for the Power LED which is useful for installations that require low profile operation of the BLU BIB To Enter Stealth Mode from Normal Mode e Hold Ch Buttons 1 4 for three seconds To Exit Stealth Mode to Normal Mode e Hold Ch Buttons 1 4 for three seconds e Signal LEDs blink YELLOW e Enter the lockout code 1 2 3 4 Ifthe code is not entered within 30 seconds the BLU BIB will return to the regular operation of Stealth Mode Normal Mode Normal Mode prevents the user from making any changes to the input gain and Phantom Power on any channels Normal Mode also provides indication of signal presence applied input gain and Phantom Power To determine a channel s applied gain Select a channel by pressing one of the Ch Buttons 1 through 8 e GREEN LED will illuminate behind one of the gain level indicators 0 6 12 18 24 30 36 42 48 Edit Mode allows the user to adjust each channel s input gain and Phantom Power To adjust the applied gain or enable disable Phantom Power on a given channel Select a channel by pressing one of the Ch Buttons 1 through 8 e The Signal LED above that channel will blink YELLOW Use the Up Down buttons to adjust gain e Use the 48 Button to enable or disable Phantom Power To enter Edit Mode from Normal Mode e Hold Ch Buttons 1 8 for one second e Signal LEDs flash GREEN twice e After 60 second
7. ignal LED illuminates for each channel where a signal is present dB Gain The dB Gain LEDs indicate the gain setting for the selected channel Power The Power LED illuminates when the BLU BIB device is powered on When a valid Digital Audio Bus connection is present the Power LED will illuminate When no valid Digital Audio Bus connections are present the Power LED will flash on and off Channel Buttons Each Channel Button can be pressed to select that channel 48 Button While in Edit Mode this button enables disables 48V phantom for the selected channel dB Gain Up Down Buttons While in Edit Mode pressing either button steps through the gain setting for the selected channel BLU BIB 12VDG Power Adapter The BLU BIB Break In Box input expanders are powered by a 12V DC adapter that is included with the device Use only the adapter provided BLU link In Out The Soundweb London Digital Audio Bus also known as BLU link is a high bandwidth fault tolerant bus of 256 channels at 48kHz and 128 channels at 96kHz Devices are connected using Cat 5e or Cat 6 cable in a ring from the OUT connector of one device to the IN connector of the adjacent device The distance between devices in the ring can be up to 100m on Cat 5e or Cat 6 or up to 10km on single mode fiber using the MC 1 fiber media converter The ring topology allows any single cable faul
8. s of inactivity Normal Mode will automatically be entered To exit Edit Mode to Normal Mode e Hold Ch Buttons 1 8 for one second The Signal LEDs flash RED twice The following diagram shows the actions required to enter and exit the various modes of Edit Mode operation Hold 1 4 for 3 seconds Then enter lockout code 1 2 3 4 Hold 1 8 for 1 second de Stealth Normal Mode 4 Mode i Hold 1 4 for 3 seconds Hold 1 8 for 1 second Soundweb EE by HARMAN TECHNICAL SPECIFICATIONS Front Panel LED Indicators Signal Preset Clip per input 48V per input Gain 0 6 12 18 24 30 36 42 48dB and Power Spundweb Analog Inputs 8 electronically balanced on Phoenix Combicon removable screw connectors Mic Line Inputs Nominal gain OdB electronically switchable up to 48dB in 6dB steps Input Impedance 3 0kOhm Maximum Input Level 20dBu with OdB input gain 8dBu with 12dB gain CMRR gt 40dB at 1kHz Input Noise E I N 123dBu typical with 150 Ohms source Phantom Power 48V nominal selectable per input A D Latency 37 Fs 0 77ms 48k 0 39ms 96k Digital Audio Bus Connectors 2 x RJ45 Ethernet connectors Maximum Cable Length 100m 300ft on Category 5e cable between devices Maximum Number of Nodes 60 Latency 4 Fs 0 08ms 48k 0 04msQ96k Pass Through Latency 2 Fs 0 04ms 48k 0 02ms 96k Power and
9. servicing to qualified service personnel who should refer to the table below The green yellow wire shall be connected directly to the units chassis CONDUCTOR WIRE COLOR Normal Alt L LIVE BROWN BLACK NEUTRAL BLUE WHITE GREEN EARTH GND i GREEN WARNING If the ground is defeated certain fault conditions in the unit or in the system to which it is connected can result in full line voltage between chassis and earth ground Severe injury or death can then result if the chassis and earth ground are touched simultaneously WARNING FOR YOUR PROTECTION READ THE FOLLOWING KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING LIQUID AND NO OBJECT FILLED WITH LIQUID SUCH AS VASES SHALL BE PLACED ON THE APPARATUS CLEAN ONLY WITH A DRY CLOTH DO NOT BLOCK ANY OF THE VENTILATION OPENINGS INSTALL IN ACCORDANCE WITH THE MANUFACTURER S INSTRUCTIONS DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS HEAT REGISTERS STOVES OR OTHER APPARATUS INCLUDING AMPLIFIERS THAT PRODUCE HEAT ONLY USE ATTACHMENTS ACCESSORIES SPECIFIED BY THE MANU FACTURER UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OF TIME Do not defeat the safety purpose of the polarized or grounding type plug A polarized plug has two blades with one wider than the other A grounding type plug has two blades and a
10. t without loss of channels All devices within a given Digital Audio Bus ring must be configured for the same sample rate The sample rate of the BLU BIB device is automatically configured based on remotely configured devices within the Digital Audio Bus ring Channel Select The BLU BIB input channels are easily configured by six DIP switches located on the rear of the device which select a range of 8 consecutive channels from the Digital Audio Bus Input channel assignments are configured by DIP switch selection only Do not give more than one BLU BIB device within the same Digital Audio Bus ring the same DIP switch settings Doing so will result in only one of the devices passing audio onto the Digital Audio Bus Each BLU BIB should have unique DIP switch settings The BLU BIB is not configured by HiQnet London Architect To determine the DIP switch settings 3 by HARMAN Spundweb by HARMAN required for assignment to given channels on the Digital Audio Bus see page 6 The same information is also available on the top lid of the BLU BIB chassis Analog Input 1 8 The 8 analog mic line level inputs utilize the same terminal block connectors as the other members of the Soundweb London family The BLU BIB operates in three different modes which are accessed via the front panel controls Stealth Mode Stealth Mode prevents the user from making any changes to the input gain and Phantom Power on any channels Stealth Mo
11. third grounding prong The wide blade or third prong are provided for your safety If the provided plug does not fit your outlet consult an electrician for replacement of the obsolete outlet Protect the power cord from being walked on or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus Use only with the cart stand tripod bracket or table specified by the manufacture or sold with the apparatus When a cart is used use caution when moving the cart apparatus combination fo avoid injury from tip over Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into the apparatus the apparatus has been exposed fo rain or moisture does not operate normally or has been dropped POWER ON OFF SWITCH For products provided with a power switch the power switch DOES NOT break the connection from the mains MAINS DISCONNECT The plug shall remain readily operable For rack mount or installation where plug is not accessible an all pole mains switch with a contact separation of at least 3 mm in each pole shall be incorporated into the electrical installation of the rack or building FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE Replace fuse with same type and rating only MULTIPLE INPUT VOLTAGE This equipment
Download Pdf Manuals
Related Search