How To Set A Node
Contents
1. customer support department LZ C frequently asked questions H3000 Systems How do I configure the system Heading Node The Hydra 3000 System can accept heading data from a variety of different sources These different sources are known as Nodes and allow the system to identify which heading devices are connected to the system The list below shows the various sources of heading available with its respective address node Device Node CPU NMEA input 5 Halcyon Processor Halcyon Gyro input 15 Halcyon Processor NMEA input 5 Halcyon 2000 Compass 16 ACP Pilot Direct Halcyon Gyro input 18 NMEA Heading NMEA FFD 96 97 etc Enter the required heading node by following the procedure below Using an FFD a b c d e f Press the Scroll Up key until NAVIGATE is shown in the text flashing Press Enter Press the Scroll Up key again until the display shows COURSE M flashing Press Enter COURSE M will now stop flashing Press Scroll Down until the display shows CALBRATE Press Enter 3 times The display now shows HDG NO and will display a value that flashes g Use the Scroll Up and Scroll Down keys to change the value to the required setting h Press Enter i Switch the system off and then back on again to complete the calibration process Using a GFD a Press the Enter Menu key b Scroll down until Setup is highlighted and press Enter c Scroll down to Commission and pre2. ss Enter d Scroll down to Heading and press Enter e Use the Left and Right Up and Down keys to change the required digit f Press Enter to store the value Note e Hydra and Hercules Pilots will also require the Heading Node to be set to your desired choice Refer to the relevant user manual for further information e 20 20 displays will require Heading to be re selected following Heading node selection Simply re select this function ends B amp G Customer Support Premier Way Abbey Park ROMSEY S051 9DH UK Robert Langford Wood Page 1 FAQ H3000 setting heading node www bandg com
Download Pdf Manuals
Related Search