User Manual - DAZA Opticare
Contents
1. z NEVER TOUCH THE ELEMENT IN THE SENSOR Figure 4 Battery placement Entrance delay Standard between the detection of a movement and a transmission is a delay of 1 sec This delay gives you the time to switch off the receiver so that no alarm is received It is possible to change this time into 3 5 or 10 seconds You can do this by changing dipswitch 1 and or 2 Wd 1 second default 1 2 i 3 seconds 1 2 Wf 5 seconds i 2 im 10 seconds 1 2 Factory default settings Switch 3 to 8 should NEVER be changed When changes are made correct operation of the sensor can NOT be guaranteed w Ce m n m o CE N E o m Daza Opticare BV follows a policy of continuous improvement in the development of its products The technical data can therefore be changed without notice This product is classified as an electrical and electronic device When you decide to discard this product please ensure that this is done accordance with the European Directive on Waste Electrical and Electronic Equipment WEEE and compliant with local laws relating to this directive Page 2 of 22. 7009 7109 CE R Wireless Optiscan 2014 06 05 V1 0 User Manual General This wireless Optiscan detects when a person intends to leave the bed It includes a built in transmitter that communicates directly with your carephone or nurse call system This transmitter must be configured to the carehone nurse call system before you can use the sensor By switching the sensor on and off three times briefly in succession you can automatically enable the sensor to send an alarm Because some carephones require a call to be made 2x in succession the transmitter will have to be activated twice Installation and use Place the sensor on the floor facing the bed figure 1 Make sure that the sensor is placed safely where it can cause no harm to the inhabitant for example underneath a chair or table It is highly preferable to place it at a distance of at least 2 meters from the bed The sensor has a 90 degrees field of view over a distance of approximate 7 meter Make sure that no objects are in front of the sensor that can block its view figure 2 Switching on 1 Switch on the sensor by placing the switch on the back of the sensor to ok position 1 0 is off i 2 Leave the room aie 3 The sensor switches itself on automatically once no movement across the floor has been detected for 15 seconds Figuur 2 Kijkhoek Sensor Note The sensor will not transmit any alarms in the first 5 seconds after the sensor is tur
3. ned on This will prevent falls alarms when the sensor is turned on Switch off 1 Turn the sensor off by setting the switch to position 0 1 is on 2 If applicable set the alarm on the care system telephone nurse call system Daza Opticare BV follows a policy of continuous improvement in the development of its products The technical data can therefore be changed without notice This product is classified as an electrical and electronic device When you decide to discard this product please ensure that this is done accordance with the European Directive on Waste Electrical and Electronic Equipment WEEE and compliant with local laws relating to this directive Page 1 of 2 7009 7109 CE X Wireless Optiscan 2014 06 05 V1 0 User Manual Battery empty warning When the Optiscan battery is almost empty the LED behind the Optiscan lens blinks red every 5 seconds Sensor element f Battery replacement Only replace this with a 3 6 volt lithium cell of size 2 3 AA WW Correct operation can only be guaranteed when an original battery of the brand Saft type LS17330 is used Daza partnumber 7083 Daza Remove the 4 screws on the rear of the Optiscan housing Replace the battery in I T accordance with Fig 3 Please note Plus pole on the right side After closing the Optiscan the sensor will require some time to calibrate This is shown by the frequently illumination of the green LED behind the lens
Download Pdf Manuals
Related Search