User Manual
Contents
1. Part Number Important Read and understand all instructions before installation Check the kit ORBC MB1 hardware against the kit contents shown below to ensure you have all necessary parts GM 50 Curved LED Light Bar Mount Parts Included Tools Needed 1 Driver Side Bracket 1 5 16 x 1 Bolt 6 Nut Inserts 1 2 Wrench 9 16 Wrench Drill e Center Drill or 1 4 Drill Bit 1 Passenger Side Bracket 1 3 8 Washer 6 5 16 x 1 Button 33 64 Drill Bit e 3 16 Allen Wrench 6mm Allen Wrench Tape 2 Rubber Adhesive Pads 1 3 8 Nut Head Screw Measure Masking Tape Sharpie or Center Punch Installation Instructions 1 Before installing the light bar and brackets disconnect the positive battery connection Open the doors and pull back the weather stripping above the windshield line on both sides See Photo 1 3 Put masking tape on the painted surface where the brackets will mount so you do not scratch the paint while marking hole locations 4 Install the driver and passenger brackets on the 50 curved LED light bar using the mounting hardware that was supplied with the light Hand tighten 5 Place the brackets on top of the door jam 1 2 up from the windshield line and mark the 3 holes with a marker or a center punch on both sides See Photo 2 6 Remove the brackets from the truck and drill pilot holes using a center drill or 1 4 drill bit Then drill those holes out to 33 64 515 dia See Pho2. to 3 7 Slide the 3 8 nut and washer over the supplied 5 16 x 1 bolt and screw them into a nut insert See Photo 4 Place the assembled bolt and nut insert into a drilled hole in the door jam 8 Using a 1 2 wrench and a 9 16 wrench tighten the bolt while holding the nut with the 9 16 wrench This will compress the nut insert and lock it into place in the drilled hole See Photo 5 9 Install all 6 nut inserts this way 10 Install the rubber pads on the inside of each light bracket 11 Remove the masking tape from both sides of truck 12 Hold the LED light bar with the brackets attached up to the door jam and align the 3 holes on each side Secure with the supplied 5 16 x 1 button head screw and tighten with a 3 16 Allen wrench 13 Finally tighten each side of the LED light bar to the bracket with a 6mm Allen wrench so the light is positioned as desired in the bracket See Photo 6 14 Reapply the factory rubber door seal securely in the track 15 Complete wiring of light bar and connect positive lead back to the battery post N PHOTO 6 PHOTO 4 Super Bright LEDs St Louis MO 63045 LED Lighting For Everything an
Download Pdf Manuals
Related Search