A-frame resin ladder instructions
Contents
1. bested El or around the ladder This may cause entrapment resulting in permanent injury or death DDERS Division of Swim n Play Inc 313 Regina Avenue Rahway NJ 07065 4891 ar2. 420490 13 PRAN E INSTALLATION INSTRUCTIONS f i L Sy 1 Sg ey y j k F Pi rad AN ii ee i gt F Pa i Fa th F Fa ae ka J Fa a l z ki i a i dite _ pole F w t i 4 j j n M F d Bi Be 4 a j E 3 i i F i a I j F f l f L i I 7 g d i Li J lt l r f Division of Swim n Play Inc fF i sia A R 313 Regina Avenue Tj Tif y Rahway NJ 07065 4891 gt eet y N 732 574 1500 www swimnplay com GENERAL Before you start check to see that you have ie correct number of parts Use the packing list on the last page Carefully read through and understand all the assembly steps before starting assembly NOTE Lyfgard as a manufacturer reserves the right to revise change or modify construction of it s products ernrdsy DANGER NO DIVING sHaLlow water DO NOT DIVE OR JUMP into your pool Your pool is approximately 4 deep It is pwneway NOt designed for diving or jumping If you dive or jump into your pool you run the CAUSE peatuor risk Of permanent injury or death Alert all visitors and family of this and point out all PERMANENT mur warning labels supplied ADULT SUPERVISION REQUIRED Lay one Handrail down on a flat surface Press the two tabs of the Platform into the slots in the Handrail making sure that the top surface of the Platform is facing in the same direction as the top of the H
3. ach the extension feet as follows Note these extension feet are not required for a 48 or 50 pool 8 Locate and A position the S i lt ladder bottom N Rotate extension NJ Do and ladder i j foot up into position W extension feet te Insert screw 10 x 1 as shown SLOT NI into hole and fasten AHHH Two extension Wa securely to ladder M Repeat this for each corner Oe feet required TAB arene MG HOLE Insert tab N amp into slot at rear bottom of ladder Holding the inside pool ladder staircase assembly under the water slightly twist the assembly to the side to allow any and all trapped air to escape Place the ladder assembly back onto the top ledge of the pool Check the levelness of the ladder when the inside staircase is touching the bottom of the pool It may be necessary to adjust the levelness by either sliding the staircase section out of the handrail slightly or by removing the staircase and cutting some of the straight section to allow you to put the Staircase assembly further into the handrail In either case drill the two holes in the staircase section and secure with the two bolts as described earlier Make sure that he bolt goes through both the handrail and the staircase section Adjust here in or out Use the following chart to determine how long your base legs should be Use a hack saw and then cut them to the required length if needed TT e
4. andrail Also make sure that the Outside Staircase Receiver long channel running along one OUTSIDE STAIRCASE edge of the Platform is on the side opposite RECEIVERS from the Inside Staircase Stems of the Handrail Install a Support Block to lock in each Platform tab by pressing the Support Blocks through the slots of the Handrail and onto the tabs Note carefully to position the down arrow of the Support Block correctly II ee Tap the Support Blocks firmly into place using a rubber mallet INSIDE TAIRCASE PLATFORM ee Assemble the other Handrail to the opposite side of the platform making sure that you mount it facing identically BLOCKS Assemble the Inside Pool Ladder Staircase into the Inside Staircase Stems of the two Handrails Use a rubber mallet to tap the Staircase all the way up into the Handrail Secure the assembly with the x 20 x 21 Stainless Steel Bolts passing the bolts first through the inside section of the Handrail the Staircase and through the outside section of the Handrail Fasten with the Cap Nuts Provided Weight must be added to the bottom of the pool staircase A coarse gravel or sand may be used If you use sand you must you must seal the sand in a plastic bag to prevent the sand from going into your pool E Leave these holes free 7S Simply insert the bags of sand or gravel into the four a i compartments Th
5. e ee ee 52 3 4 You must use additional patio blocks under the brace pad for proper support 4 Place the Platform Handrail assembly assembled above onto the ledge of the pool Make sure that the two round receivers underneath the Platform that the legs of the Support Brace will eventually be fitted into clear the ledge on the outside of the pool Position the ladder so that the distance between the barrier and the inside of the pool wall must be between 3 and 4 inches See close up 8A Find the two holes in the top of the Platform and mark these holes on the ledge with a pencil Look under the ledge to make sure that drilling holes at these two places will not hit the wall or any other structural part of the pool Using a tape measure verify that the pencil marks are 19 apart from center to center CHECK AGAIN to make sure that drilling holes at these two places will not hit the wall or any other structural part of the pool Using a 7 16 drill bit drill carefully through the pool ledge at these two locations being careful because any metal chips or debris falling into the pool could cause damage to the liner Minimum 3 Maximum 4 ko Outside Inside of Pool of Pool Fasten the entire ladder assembly to the pool ledge by placing two 3 8 x 16 x 2 1 4 stainless steel bolts through the holes in the platform and through the holes in the ledge drilled previously Fasten with sta
6. en place the compartment door over the compartments lining up the screw holes Assemble the door by inserting it into the groove in the ladder body and securing using the three 3 10 x 5 8 screws supplied Installation of Ladder Barrier Ladder barrier is to be assembled to the ladder staircase that goes into the pool So Assemble the Lower Extension Bracket onto the Lower Bracket Assemble the Lower Bracket onto the compartment door using the two screws supplied Insert 3 barrier tubes through the Lower Bracket and secure with one screw on each tube to the Upper Bracket Insert the remaining 3 barrier tubes through the Lower Extension Bracket and secure with one screw on each tube to the Upper Extension Bracket The tubes do not have holes for the screws These screws are self tapping and are designed to drive through the tubes Assemble the Upper Bracket onto the back of the top step using two of the screws supplied caps at the bottom of the three external tubes Gently place the ladder into the pool Confirm that the tubes do not touch the liner lf they tubes touch the liner remove the ladder Assemble the Upper Extension from the pool and cut the tubes Bracket onto the Upper Bracket Close the compartment on the bottom of the outside staircase as shown similar to step 3 but without putting weight into it For Pools 52 or 54 deep and you are assembling the universal ladder att
7. inless steel washers and nuts provided 3 Install the outside staircase section lt i gt to the ladder by holding the staircase horizontally to the platform Align the slot in the staircase with the hook in the platform and lower the staircase down Your ladder is now ready for use Insert the two 2 Brace Legs into the Brace Pad and Platform Using the holes in the Brace Pad and Platform as a template drill a 1 8 pilot hole through the Brace Legs secure the Brace Legs using four 4 10 x 5 8 Pan head Screws provided LG AF DLX PACKING LIST p Note Support the bottom of the Brace SS Pad using patio blocks not supplied CAUTIONS 361238 e Locate the ladder on a solid base e Only one person on the ladder at a time e Always face the ladder when using e The ladder must be installed as per manufacturers instructions e DANGER NO DIVING NO JUMPING Permanent injury or death may result e Remove outside staircase section when not in use to prohibit unauthorized entry into the pool JONOT SAN TIROUCIF LARET e Warning labels have been supplied already attached APPLIED TO HANDRAIL to your ladder Should you need additional labels for any reason either contact your local pool dealer or APPLIED TO HANDRAIL the manufacturer and order the label with the part number APPLIED TO OUTSIDE STAIRCASE LARGE DO NOT DIVE LABEL 490156 1 e DANGER Do not swim behind through APPLIED TO PLATFORM
Download Pdf Manuals
Related Search